2008 TOYOTA LAND CRUISER stop start

418 4−3. Do−it−yourself maintenance
16 STOP15 AStoplights, high mounted stop−
light, brake controller, towing
converter, ABS, VSC, main
body ECU, EFI
17 TOW BRK30 A
Brake controler
18 RR AUTO A/C50 A
Rear blower control
19 PTC−150 A
PTC heater
20 PTC−250 A
PTC heater
21 PTC−350 A
PTC heater
22 RH−J/B40 A
No circuit
23 SUB BATT40 A
To w i n g
24 VGRS40 A
No circuit
25 H−LP CLN30 A
Headlight cleaner
26 DEFOG30 A
Rear window defogger
27 AHC60 A
No circuit
28 HTR50 A
Blower controller
29 PBD30 A
No circuit
30 LH−J/B150 A
Main body ECU
31 ALT180 A
No circuit
32 A/PUMP NO.150 A
AI DRIVER
33 A/PUMP NO.250 A
AI DRIVER2
34 MAIN40 AHeadlight, daytime running
light system
35 ABS150 A
ABS
36 ABS230 A
ABS
37 ST30 A
Starter system
38 IMB7.5 AID code box, smart key sys−
tem, GBS
39 AM25 A
Main body ECU
40 DOME27.5 A
Vanity lights, overhead module
FuseAmpereCircuit

5
When trouble arises
443 5−1. Essential information
Towing with a wheel lifttype truck
From front
Use a towing dolly under the rear
wheels.
From rear
Use a towing dolly under the
front wheels.
NOTICE
nTo prevent causing serious damage to the transmission
Never tow this vehicle wheels on the ground.
nTo prevent damaging the vehicle
lDo not tow the vehicle with the “ENGINE START STOP” switch off.
The steering lock mechanism is not strong enough to hold the front wheel
straight.
l
When raising the vehicle, ensure adequate ground clearance for towing at
the opposite end of the raised vehicle. Without adequate clearance, the
vehicle could be damaged while being towed.

446
5−1. Essential information
Fuel pump shut off system
Follow the procedure below to restart the engine after the system is
activated.
Switch to ACCESSORY mode or OFF.
Restart the engine.
NOTICE
nBefore starting the engine
Inspect the ground under the vehicle.
If you find that fuel has leaked on to the ground, the fuel system has been
damaged and is in need of repair. Do not restart the engine.
To minimize the risk of fuel leakage when the engine stalls or an air
bag inflates upon collision, the fuel
pump shut off system stops sup
plying fuel to the engine.
STEP1
STEP 2

456 5−2. Steps to take in an emergency
nIf the tire pressure warning system is inoperative
The tire pressure warning system
will become inoperati ve in the follow−
ing conditions:
(When the condition becomes normal, the system will work properly.)
lIf tires not equipped with tire pressure warning valves and transmit−
ters are used.
lIf the ID code on the tire pressure warning valves and transmitters is
not registered in the tire pressure warning computer.
lIf the tire inflation pressure is more than 73 psi (500 kPa, 5.1 kgf/cm2
or bar).
The tire pressure warning system may become inoperative in the follow−
ing conditions:
(When the condition becomes normal, the system will work properly.)
lIf electronic devices or facilities us ing similar radio wave frequencies
are nearby.
lIf a radio set at similar frequencies is in use in the vehicle.
lIf a window tint that affects the radio wave signals is installed.
lIf there is a lot of snow or ice on the vehicle, in particular around the
wheels or wheel housings.
lIf non−genuine Toyota wheels are used. (Even if you use Toyota
wheels, the tire pressu re warning system may not work properly with
some types of tires.)
lIf tire chains are used.
lIf the spare tire is in a location subject to poor radio wave signal
reception.
lIf a large metallic object which caninterfere with sign al reception is
put in the luggage compartment.
nIf the tire pressure warning light comes on after blinking for 1
minute frequently
If the tire pressure warning light comes on after blinking 1 minute fre−
quently when the “ENGINE START STOP” switch is turned to IGNITION
ON mode, have it checked by Toyota dealer.

5
When trouble arises
477 5−2. Steps to take in an emergency
Emergency start function
When the engine does not start, the following steps can be used as
an interim measure to start the engine if the “ENGINE START STOP”
switch is functioning normally.
Set the parking brake.
Put the shift lever in “P”.
Set the “ENGINE START ST
OP” switch to ACCESSORY
mode.
Press and hold the “ENGINE START STOP” switch about 15
seconds while depressing the brake pedal firmly.
Even if the engine can be start
ed using the above st eps, the system
may be malfunctioning. Have the vehicle checked by your Toyota
dealer. nThe starter motor does not turn over, the interior lights and
headlights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem.
l
One or both of the battery terminals may be disconnected.
l
The battery may be discharged. ( P. 484)
lThere may be a malfunction in the steering lock system.
Contact your Toyota dealer if the problem cannot be repaired, or if
repair procedures are unknown.
STEP1
STEP 2
STEP 3
STEP 4

478
5−2. Steps to take in an emergency
If the shift lever cannot be shifted from P
If the shift lever cannot be shifted with your foot on the brake, there
may be a problem with the shif
t lock system (a system to prevent
accidental operation of the shift lever). Have the vehicle inspected by
your Toyota dealer immediately.
The following steps may be used as an emergency measure to
ensure that the shift
lever can be shifted.
Set the parking brake.
Set the “ENGINE START STOP” switch to the ACCES−
SORY mode.
Depress the brake pedal.
Pry the cover up with a flat−
head screwdriver or equiva−
lent.
Press the shift lock override
button.
The shift lever can be shifted
while the button is pressed.
STEP1
STEP 2
STEP 3
STEP 4
P
R
N
+
SD
ITY51C041
P
R
N
+
SD
ITY51C042
STEP5

482 5−2. Steps to take in an emergency
Changing “ENGINE START STOP” switch modes and starting the
engine
Shift the shift lever to “P” and apply the brakes.
Touch the Toyota emblem side of
the electronic key to the
“ENGINE START STOP” switch.
An alarm will sound to indicate
that the start function cannot
detect the electronic key that is
touched to the “ENGINE START
STOP” switch if any of the doors
is opened while the key is
touched to the switch.
To change “ENGINE START STOP” switch modes: Within 10
seconds of the buzzer soundin
g, release the brake pedal and
press the “ENGINE START STOP” switch. Modes can be
changed each time the sw
itch is pressed. ( P. 149)
To start the engine: Press the “ENGINE START STOP” switch
within 10 seconds after the buz
zer sounds, keeping the brake
pedal depressed.
If the “ENGINE START STOP” swit
ch cannot be operated, contact
your Toyota dealer.
STEP1
STEP 2
STEP 3

5
When trouble arises
483 5−2. Steps to take in an emergency
nStopping the engine
Shift the shift lever to “P” and press the “ENGINE START STOP” switch as
you normally do when stopping the engine.
nReplacing the key battery
As this procedure is a temporary measure, it is recommended that the elec−
tronic battery be replaced immediately when the battery depletes. ( P. 410)
nAlarm
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set,
the alarm may be triggered. (
P. 97)