2008 TOYOTA HIGHLANDER bulb

1
2
3
4
5
6
7
5
4-2. Maintenance ...................... 404Maintenance requirements ..................... 404
General maintenance.......... 406
Emission inspection and maintenance (I/M)
programs........................... 409
4-3. Do-it-yourself maintenance .................... 410
Do-it-yourself service precautions ....................... 410
Hood ................................... 414
Positioning a floor jack ........ 416
Engine compartment ........... 419
Tires .................................... 433
Tire inflation pressure ......... 443
Wheels ................................ 447
Air conditioning filter............ 449
Key battery .......................... 452
Checking and replacing fuses ................................. 455
Light bulbs........................... 466
5-1. Essential information ....... 478 If your vehicle needs to be towed ........................... 478
If you think something is wrong ............................ 485
Fuel pump shut off system .............................. 486
Event data recorder ............ 487 5-2. Steps to take in an
emergency ...................... 489
If a warning light turns on or a warning buzzer
sounds... .......................... 489
If a warning message is displayed (vehicles with
multi-information
display) ............................. 498
If you have a flat tire ........... 499
If the engine will not start .................................. 510
If the shift lever cannot be shifted from P ................... 512
If you lose your keys/ wireless remote control
transmitter ........................ 513
If the electronic key does not operate properly
(vehicles with smart
key system) ...................... 514
If the battery is discharged........................ 516
If your vehicle overheats ......................... 520
If the vehicle becomes stuck ................................. 523
6-1. Specifications ................... 526 Maintenance data (fuel, oil level, etc.) ........... 526
Fuel information.................. 539
Tire information .................. 542
6-2. Customization................... 554 Customizable features........ 554
5When trouble arises
6Vehicle specifications

175
2-1. Driving procedures
2
When driving
Tur n signal lever
■Turn signals can be operated when
The “ENGINE START STOP” switch or the engine switch is in ON.
■ If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.
Left turn
Right turn
Move and hold the lever
partway to signal a lane
change.
The left hand signal will flash
until you release the lever.
Move and hold the lever
partway to signal a lane
change.
The right hand signal will flash
until you release the lever.

Maintenance and care4
397
4-1. Maintenance and care ............................... 398
Cleaning and protecting the vehicle exterior......... 398
Cleaning and protecting the vehicle interior.......... 401
4-2. Maintenance ................... 404 Maintenance requirements .................. 404
General maintenance....... 406
Emission inspection and maintenance (I/M)
programs........................ 409 4-3. Do-it-yourself
maintenance ................. 410
Do-it-yourself service precautions .................... 410
Hood ................................ 414
Positioning a floor jack ..... 416
Engine compartment ........ 419
Tires ................................. 433
Tire inflation pressure ...... 443
Wheels ............................. 447
Air conditioning filter......... 449
Key battery ....................... 452
Checking and replacing fuses .............................. 455
Light bulbs........................ 466

465
4-3. Do-it-yourself maintenance
4
Maintenance and care
■
After a fuse is replaced
●If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. ( P. 466)
● If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■ If there is an overload in the circuits
The fuses are designed to blow before the entire wiring harness is damaged.
CAUTION
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage, and possibly a fire or injury.
●Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
● Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
This can cause extensive damage or even fire.
● Do not modify fuses or the fuse box.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by your
Toyota dealer as soon as possible.

466
4-3. Do-it-yourself maintenance
Light bulbs
You may replace the following bulbs yourself. The difficulty level of
replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perfor m, contact your Toyota dealer.
For more information about replacing other light bulbs, contact your
Toyota dealer.
■ Prepare a replacement light bulb.
Check the wattage of the light bulb being replaced. ( P. 538)
■ Front bulb locations
Headlights
Parking and front side marker lights
Front fog lights (if equipped)
Front turn signal lights

467
4-3. Do-it-yourself maintenance
4
Maintenance and care
Replacing light bulbs
■ Headlights
Unplug the connector.
Remove the rubber cover.
■Rear bulb locations
Back-up lights
Rear turn signal lights Stop/tail and rear
side
marker
lights
License plate lights
STEP1
STEP2

468 4-3. Do-it-yourself maintenance
Release the bulb retaining
spring.
Remove the bulb.STEP3
STEP4

470 4-3. Do-it-yourself maintenance
Right sideRemove the fender liner.
Turn the bulb base counterclock-
wise.
STEP2
STEP3