2008 TOYOTA CAMRY HYBRID lock

14
FEATURES/OPERATIONS
Seat adjustments-Front
Seatback angle
Position
Lumbar support (driver side only)
Position, cushion angle and height (driver side only)
Manual seatPower seat
Seats-Head restraints
Lock release button
Fold down Pull
Seats-Folding rear seats

21
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
Seat heaters (if equipped)
Front passenger seatDriver seat
Clock
H-Hour set
M-Minute set
Refer to the Owner’s Manualfor adjusting time.
21
PlasmaclusterTM*
* This system adopts the plasmacluster technology, manufactured under license from SHARP
Corporation. “PlasmaclusterTM” is a trademark of SHARP Corporation.
Improves air quality by emitting positive and negative ions into the cabin.
This system operates from the driver side vent and a low system noise is
normal.
“ECO HEAT/COOL” switch
Economical mode
ON/OFF
NOTE:Slightly improves gas mileage. It may take longer to reach set cabin
temperature.

22
FEATURES/OPERATIONS
Door locks
LockUnlock
Power outlets
Instrument panel
“POWER” switch must be set at “ACC” or “ON” to be used.
Center console
Cup holders
Front
Rear

OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
SAFETY AND
EMERGENCY FEATURES
Moving the lever to “LOCK” will allow the door to be opened only from
the outside.
Rear door
Doors-Child safety locks
If belt is fully extended, then retracted even slightly, it cannot be re-
extended beyond that point, unless fully retracted again. This feature is
used to help hold child restraint systems securely.
To find more information about seat belts, and how to install a child
restraint system, refer to the Owner's Manual
.
Keep as low on
hips as possible
Take up
slack
To o high
Seat belts
Fuel filler door-Internal release
(2) Pull up
(1) Remove
23

24
SAFETY AND EMERGENCY FEATURE
Push up, or
squeeze lock
release to lower
Tire Pressure Warning System reset
If tire pressure becomes critically low on any of the tires (excluding spare),
indicator comes on. Pushing “ SET” button should not turn off the light.
Correctly adjusting tire inflation will turn off the light after a few minutes.
After replacing/rotating tire or wheels, the system must be initialized.
Refer
to the Owner’s Manualfor more details.
System reset initialization
1.Push and hold “ SET” button
until the indicator blinks three
times.
2.Wait a few minutes to allow
initialization to complete.
Seat belts-Shoulder belt anchor
Rear seat outside
position guides
provide added
comfort for children
who have outgrown
child restraints.
Child comfort guide