2008 TESLA ROADSTER key

Table of Contents
For information on how to use the Touch Screen, the High Power Connector, and the audio and
navigation systems, refer to the separate manuals provided in your owners package.Introduction and consumer information
Important notes about your vehicle 1-2
Important notes about this manual 1-3
Consumer information 1-4
Your vehicle at a glance Exterior 2-2
Interior 2-4
Seating an d safety restraints
Seats 3-2
Seat belts 3-3
Airbag system 3-6
Doors, locks, and s ecurity
Keys 4-2
Do ors
4-4
Trunk 4-6
Vehicle security 4-7
Charging your vehicle General information about charging 5-2
Charge settings 5-4
Charging components 5-6
Driving your vehicle Driving basics 6-2
Switches and controls 6-7
Instruments 6-11
Comfort and convenience Power windows 7-2
Rear view mirrors 7-3
Interior temperature control 7-4
Interior accessories 7-7
Removable roof 7-9
HomeLink® 7-15Audio and navigation systems
8-1
Maintenance and care Maintenance 9-2
Fluid reservoirs 9-4
Windshield wiper and washer 9-6
Cleaning and vehicle care 9-7
Roadside emergencies Tool kit 10-2
Energy Depletion 10-3
Tire repair 10-4
Wheels 10-6
Fuse replacement 10-7
Bulb replacement 10-9
Raising the vehicle 10-11
Vehicle recovery 10-13
Technical specifications Vehicle identification 11-2
Wheels and tires 11-4
Approved fluids and capacities 11-14
Vehicle dimensions and weights 11-15
Subsystem specifications 11-17
Roadster OHB.book Page 1 Thursday, October 2, 2008 8:59 AM

Seat belts
3-3
Seating and s afety restraints
Seat beltsGeneral information
WARNING: Seat belts should be worn
by all occupants, for every journey no
matter how short. Failure to do so greatly
increases the risk of death or serious injury in
the event of an accident.
S
It is an established fact that seat belts provide
good protection in accidents. Therefore
wearing a seat belt is required by law in most
states.
Both the driver and passenger seating
positions are equipped with three-point
inertia reel seat belts. Inertia reel belts are
tensioned automatically and allow freedom
of movement during normal driving
conditions.
The belt reel automatically locks, preventing
movement of occupants, whenever your
vehicle experiences the force associated with
hard acceleration, braking, cornering or on
impact in a collision. The reel may also lock
when driving on steep hills or slopes.Seat belt safety instructions
WARNING: Ensure that all seat belts are
worn correctly. An improperly worn
seat belt increases the risk of death or serious
injury in the event of a collision.
S
WARNING: Seat belts are designed to
bear upon the bony structure of the
body, and should be worn low across the
pelvis, over the shoulder and across the
chest. Avoid wearing the lap section of the
belt across the abdominal area.
S
WARNING: Always adjust the belt to
remove slack. Seat belts worn too loose
can result in injuries because they allow
excessive forward movement in an
accident.
S
WARNING: Do not wear seat belts over
hard, fragile or sharp items in clothing,
such as pens, keys, eyeglasses, etc. In an
impact, the pressure from the seat belt on
such items can cause them to break, which in
turn may cause serious injury.
S
WARNING: Seat belts should not be
worn with any part of the strap
twisted.SWA R N I N G : E a c h b e l t a s s e m b l y m u s t b e
used by only one occupant. It is
dangerous to put the belt around a child
being carried on an occupant’s lap.
S
WARNING: It is essential that seat belts
that have been worn in an accident are
replaced, even if damage to the assembly is
not obvious. The belt anchors must also be
checked.
S
WA R N I N G : C a r e m u s t b e t a k e n t o a v o i d
contaminating the seat belt webbing,
and seat belt mechanisms with any
chemicals, liquids, grit, dirt or cleaning
products. If a seat belt fails to retract or latch
into the buckle, it must be replaced
immediately.
S
WARNING: No modifications or
additions should be made that prevent
the seat belt mechanism from taking up slack, or that prevent the seat belt being
adjusted to remove slack. A slack belt greatly
reduces the level of occupant protection.
S
Using the seat beltsFastening the belt1. Ensure that the seat is correctly
positioned.
2. Take hold of the latch plate and pull it slowly across your chest and lap.
3. Insert the latch plate into the buckle and press down until you hear a “click” that
indicates it is securely locked into place.
4. Pull the belt to check that it is securely fastened.
5. Position the belt so that it is worn low across the front of the pelvis, and across
the chest and shoulder.TR0139
Roadster OHB.book Page 3 Th ursday, October 2, 2008 8:59 AM

4-1
Doors, locks, and security
Keys
About your keys 4-2
Using the key fob 4-2
Doors Exterior door release 4-4
Interior door release 4-4
Central door locking 4-4
Emergency unlocking 4-5
Trunk Opening the trunk 4-6
Closing the trunk 4-6
Trunk interior release handle 4-6
Vehicle security Alarm System 4-7
Vehicle PIN code 4-8
PIN lock 4-10
Valet mode 4-11
Roadster OHB.book Page 1 Thursday, October 2, 2008 8:59 AM

Keys4-2
Doors, locks, and security
Doors, Locks, and Security
KeysAbout your keys
Caution: The key fob contains delicate
electronic circuits and must be
protected from impact, water damage
and high temperatures. Avoid contact with
solvents, waxes and abrasive cleaners.
You have been supplied with three keys. Two
of the keys are key fobs with three buttons:
1. Lock button
2. Unlock button
3. Programmable button. See
Programmable button, page 4-3 .
Keep one of the keys in a secure place for use
in emergencies. If you lose a key, contact
Tesla Motors for a replacement.
Using the key fobThe buttons on the key fob transmit a coded
radio signal to a receiver in your vehicle. It is
not necessary to point the key fob at your
vehicle, but you must be within operating
range and you must hold the button down for
two seconds. The operating range will vary
according to the key fob’s battery condition
and other physical factors.
If the vehicle can not be locked or unlocked
using the associated button on the key fob, it
may be necessary to change the battery in
the key fob. See Replacing the key fob’s
battery, page 4-3 .
Note: Interference from other radio
equipment operating on a similar frequency
may affect operation of the key fob. If this
happens, operate the key fob as close to your
vehicle as possible. If you are unable to unlock your vehicle with the key fob, use the
emergency key lock. See
Emergency
unlocking, page 4-5 .
Locking
WARNING: Never leave anyone in your
vehicle when it is locked using the key
fob. The interior door release handles will
operate, but because the car was locked
using the key fob, the alarm will sound. To
re-open the doors using the exterior door
release handles, you must first disarm the
alarm using the key fob.
S
Press the Lock button on the key fob to
lock the doors and arm the alarm.
The turn signals will flash once and the red
alarm indicator on the console (illustrated on
page 4-7) will illuminate and continue to flash
on and off while the vehicle is locked. If you
push the Lock button after the vehicle has
already been locked, you’ll hear a
confirmation beep.
If a door, the hood or the trunk are not fully
closed when the lock button is pressed, the
turn signals will not flash and your vehicle is
not armed. Check that the doors, hood and
trunk are fully closed, then re-lock your
vehicle.
If any attempt is made to open the doors or
the hood after the alarm has been set, the
horn will sound and the turn signals will flash
for one minute. See Alarm System, page 4-7 .
TR0044
1
2
3
TR0090
Roadster OHB.book Page 2 Th ursday, October 2, 2008 8:59 AM

Keys
4-3
Doors, locks, and security
Unlocking
Press the Unlock button on the key fob
to unlock the doors and disarm the
alarm.
The turn signals flash twice and the red alarm
indicator on the console extinguishes.
Note: If neither door or trunk are opened
within one minute, the doors will
automatically re-lock and the alarm will arm.
Programmable button
This button can be programmed to
perform one of the following functions:
• Alarm
The horn sounds and the exterior lights
flash for one minute. Press again to cancel
the alarm.
• Trunk release
Opens the trunk.
• Open or close a HomeLink
® device
Operates devices such as a garage door
or gate.
To program this button, use the Touch
Screen. Refer to the Touch Screen Users
Manual, provided in your owners package.
To activate the programmed function, press
and hold the button for two seconds.
Replacing the key fob’s batteryThe key fob’s battery should last for
approximately one year depending on use.
When the battery needs replacing, you’ll notice a deterioration in performance. For
example, you’ll gradually need to be closer to
the vehicle to operate the key fob.
To replace the battery:
1. Remove the securing screw on the rear of the key fob and carefully separate the two
halves. Avoid damaging the seal between
the two halves.
2. Remove the batteries, taking care to avoid touching the circuit board or the
contact surfaces of the battery holder.
3. Fit two new batteries (type CR1616) with the ‘+’ sides facing upwards.
If possible, avoid touching the flat
surfaces of the battery because finger
marks will reduce battery life. Wipe the
battery clean before fitting.
4. Assemble the two halves of the key fob.
ComplianceThe key fob complies with Title 47 CFR Part
15 Subpart C rules for intentional radiators.
Operation is subject to the following
conditions:
• This device may not cause harmful
interference.
• This device must accept any interference
received, including interference that may
cause undesired operation.
Any changes or modifications to the key fob
not expressly approved by the manufacturer
or Tesla Motors could void the user’s
authority to operate the equipment.
Transmitter FCC ID: L2M001004
TR0156
Roadster OHB.book Page 3 Th ursday, October 2, 2008 8:59 AM

Doors4-4
Doors, locks, and security
DoorsExterior door releaseWith the doors unlocked, press the touch pad
(located in the air inlet on the door) to release
the door. Pull the door to open.
Note: The door release touch pads operate
only if the doors are unlocked.
Interior door releaseFrom inside your vehicle, pull the interior
door release handle to unlock and open the
door.
Central door lockingFor your security, you can lock both doors
from inside your vehicle by pressing the
central locking switch on the driver’s door
panel.
Press the switch once to lock the doors and
inhibit the use of the exterior door release
touch pads. The alarm indicator on the center
console will illuminate when the doors are
locked (except if the vehicle is moving over 5
mph).
Press the switch to unlock the doors and
enable operation of the exterior door release
touch pads. You can also unlock the doors
using the key fob.
Note: The central door locking switch does
not operate if the doors have been locked
using the key fob. You’ll need to unlock the
doors using the key fob. The central door
locking switch also does not operate if a door,
trunk, or the hood is not completely closed.
TR0091
TR0092
TR0093
Roadster OHB.book Page 4 Th ursday, October 2, 2008 8:59 AM

Doors
4-5
Doors, locks, and security
Drive away lockingFor your security, the doors lock and the
trunk release switch is inhibited whenever
your vehicle’s speed exceeds 5 mph.
The trunk release button is reactivated when
your vehicle’s speed is less than 5 mph.Emergency unlockingIf the key fob fails to unlock the doors (for
instance if there is an electrical failure), you
can unlock the driver’s door using the
mechanical key.
A lock is located on the underside of the
driver’s door. Turn the key clockwise to
unlock the door.
Note: If active, the alarm will sound when the
door is opened. To cancel the alarm, press the
unlock button on the key fob or enter the PIN
Code on the Touch Screen. For details, refer
to the Touch Screen Users Manual provided in
your owners package.
TR0146
Roadster OHB.book Page 5 Th ursday, October 2, 2008 8:59 AM

Trunk4-6Doors, locks, and securityTr u n kOpening the trunkTo open the trunk, press the trunk release
button on the dashboard, or insert the key in
the external lock and turn counter-clockwise.
You can also use the key fob if you have set
up the its programmable button to remotely
open the trunk. For details on programming
the key fob, refer to the Touch Screen Users
Manual provided in your owners package.The trunk release button is disabled when the
doors are locked with the key fob, or when
your vehicle’s speed exceeds 5 mph.
Closing the trunkClose the trunk one side at a time. Use both
hands to firmly but gently apply downward
pressure on one side of
the rear spoiler until
you hear it click into place. Repeat for the
other side.
T C2
R
1
BR
AK E FA
UL
T
C R
U I
S Emp
h
rp
mx
1 0
001
50
1
4
0
13
0
1
20
1
10
1
00
5 0
4 0
3 0
2 0
10 9
0
60 8
0
7
0
0
0
1
2
3
4
5
6
7
8
9
10
11
12
13
1 4
1 5TCP
RN 1 2
2:0
0PM
2:00PM
TR0108
To close the trunk,
use both hands
to firmly but gently
push down on one
side of the rear
spoiler until you
hear it “click”
into place. Repeat
for the other side.
Trunk interior release handleYour vehicle is equipped with a mechanical
trunk release handle that provides a means of
escape in the event that a person becomes
locked inside the trunk. Adults are advised to
familiarize themselves with the operation and
location of the release handle.
A T-shaped handle is located at the back of
the trunk towards the drivers side of the
vehicle. This handle is made using a
luminescent material that glows for hours
after a brief exposure to ambient light. To
open the trunk from the inside, pull the
T-shaped handle and push up on the trunk lid. TR0149
Roadster OHB.book Page 6 Th ursday, October 2, 2008 8:59 AM