Downloaded from www.Manualslib.com manuals search engine INSPECTION AND MAINTENANCE
Refill with Oil and Check for Leaks 1) Pour oil through the filler hole and install the filler cap. For the approximate capacity of the oil, refer to the "Capacities" item in the "SPECIFICATIONS" section. 2) Start the engine and look carefully for leaks at the oil filter and drain plug. Run
the engine at various speeds for at least 5 minutes. 3) Stop the engine and wait about 5 min
utes. Check the oil level again and add oil if necessary. Check for leaks again.
CAUTION
• When replacing the oil filter, it is recommended that you use a genu
ine SUZUKI replacement filter. If you use an aftermarket filter, make
sure it is of equivalent quality and follow the manufacturer's instruc
tions.
• Oil leaks from around the oil filter or drain plug indicate incorrect installation or gasket damage. If you find any leaks or are not sure
that the filter has been properly tightened, have the vehicle inspected by your SUZUKI dealer.
7-13
Engine Coolant
(For Gasoline Engine Model)
EXAMPLE
64J151
(For Gasoline Engine Model)
EXAMPLE
(For Diesel Engine Model)
64J249
.A WARNING
It is hazardous to remove the degas
sing tank cap for Diesel engine when
the water temperature is high,
because scalding fluid and steam may be blown out under pressure.
Wait until the coolant temperature
has lowered before removing the cap.
Downloaded from www.Manualslib.com manuals search engine A WARNING
Brake fluid is harmful or fatal if swallowed, and harmful if it comes in contact with skin or eyes. If swallowed,
do not induce vomiting. Immediately contact a poison control center or a
physician. If brake fluid gets in eyes
flush eyes with water and seek medi~ cal a~ention. ~ash thoroughly after
handling. Solution can be poisonous to animals. Keep out of the reach of
children and animals.
NOTE: With disc brakes, the fluid level can be
expected to gradually fall as the brake
pads wear.
Brake Pedal Check. if the ~rake pedal·stops at the regular height without "spongy" feeling when you depress it. If not, have the brake system inspected by your SUZUKI dealer. If you doubt the brake pedal for the regular
height, check it as follows:
. .
54G108
Pedal to wall minimum distance "a": 70 mm (2.8 in.)
With the engine running, measure the distance between the brake pedal and floor
wall when the pedal is depressed with
approximate~y. 300 ~ (30 kg, 66 Ibs) of force: .The ~Inlmum distance required is as spec!fled. SIn?e vour vehicle's brake system IS self-adJusting, there is no need for
pedal adjustment.
If the pedal to floor wall distance as measured above is less than the minimum dis~ance required, have your vehicle Inspected by your SUZUKI dealer.
NOTE: When measuring the distance between the i?rake pedal and floor wall, be sure not to mclude the floor mat or rubber on the floor
wall in your measurement.
INSPECTION AND MAINTENANCE
60G104S
A WARNING
If you experience any of the following
problems with your vehicle's brake
system, have the vehicle inspected
immediately
by your SUZUKI dealer. • Poor braking performance • Uneven braking (Brakes not work-
ing uniformly on all wheels.) • Excessive pedal travel • Brake dragging • Excessive noise • Pedal pulsation (Pedal pulsates
when depressed.) .
7-24
