Page 20 of 304
Q:What is wrong with this?
A:The belt is behind the body.
{CAUTION
You can be seriously injured by
not wearing the lap-shoulder
belt properly. In a crash, you
would not be restrained by the
shoulder belt. Your body could
move too far forward increasing
the chance of head and neck
injury. You might also slide
under the lap belt. The belt
force would then be applied
right on the abdomen. That
could cause serious or fatal
injuries. The shoulder belt
should go over the shoulder
and across the chest.
Q:What is wrong with this?
A:The belt is twisted across
the body.
1-16 Seats and Restraints
ProCarManuals.com
Page 21 of 304
{CAUTION
You can be seriously injured by
a twisted belt. In a crash, you
would not have the full width
of the belt to spread impact
forces. If a belt is twisted,
make it straight so it can work
properly, or ask your dealer/
retailer to x it.
Lap-Shoulder Belt
All seating positions in the vehicle
have a lap-shoulder belt.
Here is how to wear a lap-shoulder
belt properly.
1. Adjust the seat so you can sit up
straight. To see how, see “Seats”
in the Index.2. Pick up the latch plate and pull
the belt across you. Do not let
it get twisted.
The lap-shoulder belt may lock if
you pull the belt across you very
quickly. If this happens, let the
belt go back slightly to unlock it.
Then pull the belt across you
more slowly.
If you ever pull the shoulder
portion of a passenger belt out
all the way, you may engage the
child restraint locking feature.
If this happens, just let the belt go
back all the way and start again.3. Push the latch plate into the
buckle until it clicks.
Pull up on the latch plate to
make sure it is secure. If the belt
is not long enough, seeSafety
Belt Extender on page 1-22.
Make sure the release button on
the buckle is positioned so you
would be able to unbuckle the
safety belt quickly if necessary.
Seats and Restraints 1-17
ProCarManuals.com
Page 22 of 304
4. If equipped with a shoulder belt
height adjuster, move it to the
height that is right for you.
Improper shoulder belt height
adjustment could reduce the
effectiveness of the safety belt
in a crash. See “Shoulder Belt
Height Adjustment” later in this
section.
5. To make the lap part tight, pull
up on the shoulder belt.
It may be necessary to pull
stitching on the safety belt
through the latch plate to fully
tighten the lap belt on smaller
occupants.To unlatch the belt, push the button
on the buckle. The belt should go
back out of the way. When the safety
belt is not in use, slide the latch plate
up the safety belt webbing. The latch
plate should rest on the stitching on
the safety belt, near the guide loop
on the side wall.Before you close a door, be sure
the belt is out of the way. If you slam
the door on it, you can damage
both the belt and the vehicle.
Shoulder Belt Height Adjuster
The vehicle has a shoulder belt
height adjuster for the driver
and right front passenger position.
Adjust the height so that the
shoulder portion of the belt is
centered on your shoulder. The belt
should be away from the face and
neck, but not falling off the shoulder.
Incorrect positioning of the shoulder
belt can reduce the effectiveness of
the safety belt.
1-18 Seats and Restraints
ProCarManuals.com
Page 23 of 304
To move it, push the button on the
front of the height adjuster and
move the height adjuster to
the desired position.
After you move the adjuster to
where you want it, try to move it
down without pushing the button
to make sure it has locked into
position.
Safety Belt Pretensioners
The vehicle has safety belt
pretensioners for the front outboard
occupants. Although you cannot see
them, they are part of the safety belt
assembly. They can help tighten the
safety belts during the early stages
of a moderate to severe frontal and
near frontal crash if the threshold
conditions for pretensioner activation
are met. And, if the vehicle has
side impact airbags, safety belt
pretensioners can help tighten
the safety belts in a side crash.
Pretensioners work only once. If
they activate in a crash, you will need
to get new ones, and probably other
new parts for the safety belt system.
SeeReplacing Safety Belt System
Parts After a Crash on page 1-23.
Rear Safety Belt Comfort
Guides
Rear shoulder belt comfort guides
may provide added safety belt
comfort for older children who have
outgrown booster seats and for some
adults. When installed on a shoulder
belt, the comfort guide positions the
belt away from the neck and head.
There is one guide for each
outboard passenger position in the
rear seat. Here is how to install
a comfort guide to the safety belt:
1. Pull the elastic cord out from the
side of the seatback to remove
the guide from its storage pocket.
Seats and Restraints 1-19
ProCarManuals.com
Page 24 of 304
2. Place the guide over the belt and
insert the two edges of the belt
into the slots of the guide.3. Be sure that the belt is not
twisted and it lies at. The elastic
cord must be under the belt
and the guide on top.
{CAUTION
A safety belt that is not
properly worn may not provide
the protection needed in a
crash. The person wearing the
belt could be seriously injured.
The shoulder belt should go
over the shoulder and across
the chest. These parts of the
body are best able to take belt
restraining forces.
1-20 Seats and Restraints
ProCarManuals.com
Page 25 of 304
4. Buckle, position, and release
the safety belt as described
previously in this section.
Make sure that the shoulder
belt crosses the shoulder.To remove and store the comfort
guide, squeeze the belt edges
together so that you can take them
out of the guide. Push the guide into
the pocket on the side of seatback.
Properly secure the guide loop
before folding the seatback. The
comfort guide and vehicle can be
damaged while closing a door if it is
not properly secured in its storage
location.Safety Belt Use During
Pregnancy
Safety belts work for everyone,
including pregnant women. Like
all occupants, they are more likely
to be seriously injured if they do
not wear safety belts.A pregnant woman should wear a
lap-shoulder belt, and the lap portion
should be worn as low as possible,
below the rounding, throughout
the pregnancy.
The best way to protect the fetus is
to protect the mother. When a safety
belt is worn properly, it is more likely
that the fetus will not be hurt in a
crash. For pregnant women, as for
anyone, the key to making safety
belts effective is wearing them
properly.
Seats and Restraints 1-21
ProCarManuals.com
Page 26 of 304
Safety Belt Extender
If the safety belt will fasten around
you, you should use it.
But if a safety belt is not long
enough, your dealer/retailer will order
you an extender. When you go in to
order it, take the heaviest coat you
will wear, so the extender will be
long enough for you. To help avoid
personal injury, do not let someone
else use it, and use it only for the
seat it is made to t. The extender
has been designed for adults.
Never use it for securing child seats.
To wear it, attach it to the regular
safety belt. For more information,
see the instruction sheet that comes
with the extender.
Safety Belt Check
Now and then, make sure the safety
belt reminder light and all your belts,
buckles, latch plates, retractors and
anchorages are working properly.
Look for any other loose or damaged
safety belt system parts. If you see
anything that might keep a safety belt
system from doing its job, have it
repaired. Torn or frayed safety belts
may not protect you in a crash. They
can rip apart under impact forces.
If a belt is torn or frayed, get a new
one right away.
Make sure the safety belt reminder
light is working. SeeSafety Belt
Reminders on page 4-14for more
information.
Keep safety belts clean and dry.
SeeCare of Safety Belts on
page 1-22.
Care of Safety Belts
Keep belts clean and dry.
{CAUTION
Do not bleach or dye safety
belts. If you do, it may severely
weaken them. In a crash, they
might not be able to provide
adequate protection. Clean
safety belts only with mild
soap and lukewarm water.
1-22 Seats and Restraints
ProCarManuals.com
Page 27 of 304
Replacing Safety Belt
System Parts After
a Crash
{CAUTION
A crash can damage the safety
belt system in the vehicle.
A damaged safety belt system
may not properly protect the
person using it, resulting in
serious injury or even death
in a crash. To help make sure
the safety belt systems are
working properly after a crash,
have them inspected and any
necessary replacements made
as soon as possible.After a minor crash, replacement of
safety belts may not be necessary.
But the safety belt assemblies that
were used during any crash may
have been stressed or damaged.
See your dealer/retailer to have the
safety belt assemblies inspected or
replaced.
New parts and repairs may be
necessary even if the safety belt
system was not being used at
the time of the crash.
Have the safety belt pretensioners
checked if the vehicle has been in a
crash, or if the airbag readiness light
stays on after you start the vehicle or
while you are driving. SeeAirbag
Readiness Light on page 4-14.
Airbag System
Your vehicle has the following
airbags:
A frontal airbag for the driver.
A frontal airbag for the right front
passenger.
A seat-mounted side impact
airbag for the driver.
A seat-mounted side impact
airbag for the right front
passenger.
A roof-rail airbag for the driver
and the passenger seated
directly behind the driver.
A roof-rail airbag for the
right front passenger and the
passenger seated directly behind
the right front passenger.
All of the airbags in your vehicle will
have the word AIRBAG embossed in
the trim or on an attached label near
the deployment opening.
Seats and Restraints 1-23
ProCarManuals.com
