2008 RENAULT SCENIC diagram

8Electrical equipment
V2 MR-372-J84-86C100$TOC.mif
V2
86C
"The repair procedures given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The procedures may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from
which his vehicles are constructed."
V2
All rights reserved by Renault s.a.s.
Edition Anglaise
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of
Renault s.a.s.
© Renault s.a.s. 2008
MULTIMEDIA
Fault finding - Introduction 86C - 2
Fault finding - List and location of components 86C - 7
Fault finding - Operating diagram 86C - 8
Fault finding - Function 86C - 9
Fault finding - Role of components 86C - 10
Fault finding - Configurations and programming 86C - 11
Fault finding - Conformity check 86C - 12
Fault finding - Customer complaints 86C - 20

86C-2
MR-372-J84-86C100$111.mif
V2
86C
MULTIMEDIA
Fault finding - Introduction
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding procedure applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedure (this manual):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
–Visu-Schéma (CD-ROM), paper.
Type of diagnostic tools
–CLIP + multiplex line sensor
Special tooling required
3. REMINDERS
Procedure
Scénic II ph2: To run fault finding on the vehicle computers, switch on the forced + after ignition feed.
Proceed as follows:Vehicle(s): Espace IV phase 2, Scénic II phase 2,
Trafic II phase 2, Kangoo 2
Function concerned: Multimedia
Special tooling required
Multimeter
Elé. 1681 Universal bornier
Switch on the forced + after ignition feed:
–with the vehicle card in the card reader,
–press and hold the Start button (longer than 5 seconds) with start-up conditions not fulfilled,
–connect the diagnostic tool and perform the required operations.
Switching off the forced + after ignition feed:
Press the Start button twice briefly (less than 3 seconds).
Ensure that the + after ignition feed has been cut off by checking that the computer warning lights on the
instrument panel have gone out.
MR-372-J84-86C100$111.mif

86C-8
MR-372-J84-86C100$333.mif
V2
86C
MULTIMEDIA
Fault finding - Operating diagram
Layout of the main LPN* radio system components:
*LPN: Low Price NavigationCAN V M diagnostic
socketUCH
SUPPLY
(Kangoo 2)Passenger electric
mirror (Trafic II ph2)
Other computersMultimedia network
interface unit
Steering column
control
Multifunction aerial
(Trafic II ph2)
GPS aerialLPN*
radionavigation
Aerial amplifier
(Espace IV ph2,
Scénic II ph2,
Kangoo 2)Passenger
compartment fuse box
and relay
Radionavigation
display
ABS computer, ABS/
ESP or wheel speed
depending on
equipment level
Microphone
CD changer
(if optional)Speakers
Vehicle multiplex network
Multimedia multiplex network
MR-372-J84-86C100$333.mif