2008 PONTIAC G8 ignition

3. Insert and turn the new
section (A) to ON/RUN within
ve seconds of removing
the original key.
4. Turn the new section (A) to
LOCK/OFF. Section (A) is
now programmed.
To program a new section (B):
1. Turn the ignition to ON/RUN with
the new section (A).
The vehicle must be in
PARK (P).
2. Select Remote Key from the
personalization menu.
3. Select Program.
4. Press
QandWon the new
section (B), at the same time,
until you hear two beeps.
5. Repeat Step 4 for all other keys,
including keys that require
programming or ones previously
programmed to the vehicle.
Any key not reprogrammed will
be erased.6. Turn the ignition to LOCK/OFF.
7. Join sections (A) and (B)
until they click.
Do not join the two key sections
until programming is complete.
Do not leave the key or device that
disarms or deactivates the theft
deterrent system in the vehicle.
Content Theft-Deterrent
Your vehicle has a content
theft-deterrent alarm system.
Arming the System
To arm the system, either:
PressQon the RKE transmitter.
Or, lock the vehicle using the
key in the driver’s door.
The alarm will automatically arm
after about 30 seconds. The security
light, located on the instrument
panel, will ash.Press
Von the RKE transmitter
to open the trunk without setting
off the alarm. The system will rearm
when the trunk is closed.
Disarming the System
To disarm the system, do one of the
following:
PressKon the RKE transmitter.
Turn the ignition to ON/RUN.
Allow the alarm to time out after
about 30 seconds and reset
itself.
The alarm will automatically disarm.
If the system is armed and any
door is unlocked without pressing
K
on the RKE transmitter the alarm
will sound.
Keys, Doors and Windows 2-13
2008 - Pontiac G8 Owner Manual

Power Windows
A. Power Window Switches
B. Rear Window Lockout SwitchThe power window switches (A) for
all doors are located on the
center console. The switches work
when the ignition is in ON/RUN,
ACC/ACCESSORY, or in Retained
Accessory Power (RAP). See
Retained Accessory Power (RAP)
on page 8-3.
Press down or pull up on the switch
to open or close a window.
Express-Down Window
The driver and front passenger
window switches have an
express-down feature to allow the
window to be lowered without
holding the switch. Press the switch
down all the way, release it, and
the window goes down
automatically. Stop the window
while it is lowering by pressing or
pulling the switch.
Rear Window Lockout
Press the lockout buttono(B), to
prevent rear seat passengers
from operating the windows. Press
the button again to turn the
feature off.
Rear Power Windows
The rear doors have their own
switches.
R:Press to open the window.
Q:Press to close the window.
Sun Visors
Pull the visor toward you, or move it
to the side to help reduce glare.
Keys, Doors and Windows 2-15
2008 - Pontiac G8 Owner Manual

Mirrors
Manual Rearview Mirror
The vehicle has a manual rearview
mirror with a compass display
and OnStar
®control buttons located
at the bottom of the mirror. See
your dealer/retailer for more
information on the system and how
to subscribe to OnStar. See
OnStar
®System on page 4-36for
more information about the services
OnStar provides.
Adjust the mirror to see clearly
behind your vehicle. Hold it in the
center to move it up or down
and side to side.
Headlamp Glare
1. To reduce headlamp glare from
vehicles following from behind,
pull the lever toward you.
The rear view clarity is reduced
when the mirror is set to
reduce headlamp glare.2. Return the lever back to its
original position as soon as
the glare has disappeared to
restore the rear view.
Cleaning the Mirror
Do not spray glass cleaner directly
on the mirror. Use a paper towel
or similar material dampened
with glass cleaner.
Compass
Compass Display
Y(On/Off):Press to turn the
compass on or off. The compass
display can show a maximum of two
characters. For example, NE is
displayed for north-east.
When the ignition and the compass
feature are on, a character box
displays for about two seconds.
After two seconds, the mirror
displays the direction the vehicle is
facing.
Compass Calibration
When on, the compass automatically
calibrates as the vehicle is driven. If,
after two seconds, the display does
not show a compass direction, (N for
North, for example), there may be a
strong magnetic eld interfering with
the compass. Interference can be
caused by a magnetic antenna
mount, magnetic note pad holder, or
a similar magnetic item. If CAL
should ever display in the compass
window, the compass might need
calibration.
Press and hold
Yfor several
seconds to activate the compass
calibration mode. CAL displays
in the compass window on
the mirror.
The mirror can be calibrated by
driving the vehicle in circles
at 5 mph (8 km/h) or less until the
display shows a direction.
2-16 Keys, Doors and Windows
2008 - Pontiac G8 Owner Manual

Compass Variance
The mirror is set to zone eight.
Adjust the compass to compensate
for compass variance if you live
outside zone eight. Under certain
conditions, such as during a
long-distance, cross-country trip, it
is necessary to adjust for compass
variance. If the variance is not
adjusted, the compass could give
false readings.
To adjust for compass variance:
1. Find the current location
and variance zone number on
the following zone map.2. Press and hold
Yuntil zone
displays.
3. Once zone displays, press
Y
repeatedly until the correct
zone number displays. If CAL
displays in the compass window,
the compass might need
calibration. See “Compass
Calibration” explained previously.
Outside Power Mirror(s)
With the ignition on, move the
selector switch located on the center
console to the left or right to choose
either the driver or passenger
side mirror.
To adjust a mirror, use the arrows
located on the four-way control
pad to move the mirror in the
desired direction. The mirror moves
right or left, up or down. Adjust
each mirror to see the side of your
vehicle and the area beside and
behind your vehicle. Keep the
selector switch in the center position
when not adjusting either outside
mirror.
Keys, Doors and Windows 2-17
2008 - Pontiac G8 Owner Manual

Manually fold the mirrors inward to
prevent damage when going
through an automatic car wash. To
fold, push the mirror toward the
vehicle. Push the mirror outward, to
return to its original position.
Outside Convex Mirror
{CAUTION
A convex mirror can make
things (like other vehicles) look
farther away than they really
are. If you cut too sharply into
the right lane, you could hit a
vehicle on your right. Check
your inside mirror or glance
over your shoulder before
changing lanes.
The passenger side mirror is convex
shaped. A convex mirror’s surface
is curved so more can be seen from
the driver seat. It also makes
things, like other vehicles, look
farther away than they really are.
Sunroof
The sunroof control is located
between the sun visors. It works
when the ignition is in ON/RUN. The
sunroof will not operate after the
engine is turned off.
From the closed position
9, turn
the control clockwise to one of
the six open positions. The
sunshade opens with the sunroof.
Tilt the sunroof by turning the control
counter-clockwise.
Obstruction Detection
When the sunroof encounters an
obstruction while closing, it
immediately returns to the fully open
or tilt position. The sunroof will
not move again until the control is
pressed upward, or a different
position is selected.
2-18 Keys, Doors and Windows
2008 - Pontiac G8 Owner Manual

The main components of the
instrument panel are the following:
A.Turn Signal/Multifunction
Lever on page 4-4 .
B. Audio Steering Wheel Controls
on page 6-23 andDIC Operation
and Displays on page 4-23 .
C. Instrument Panel Cluster on
page 4-11 .
D. Audio Steering Wheel Controls
on page 6-23 .
E. Windshield Wipers on page 4-8 .
F. Hazard Warning Flashers on
page 4-4 .
G. Voltmeter, Oil Gage. Voltmeter
Gage on page 4-15 .
H. Outlet Adjustment on page 7-8 .I.
Exterior Lamps Controls on
page 5-1 .Instrument Panel
Brightness on page 5-3 .Fog
Lamps on page 5-3 (If Equipped).
J. Hood Release on page 9-5.
K. Tilt Wheel on page 4-4 .
L. Horn on page 4-4.
M. Ignition Positions on page 8-2 .
N. Climate Control System on
page 7-1 .Automatic Climate
Control System on page 7-4
(If Equipped).
O. Shift Lever. Automatic
Transmission Operation on
page 8-6 . P.
Power Door Locks on page 2-9 .
Q. Outside Power Mirror(s) on
page 2-17 .
R. Power Windows on page 2-15 .
S. Traction Control System (TCS) Disable Button. Electronic
Stability Program on page 8-16 .
T. Heated Seats on page 1-5
(If Equipped).
U. Accessory Power Outlet(s) on
page 4-9 .
V. Audio System(s) on page 6-1 .
W. Glove Box on page 3-1 .
Instruments and Controls 4-3
2008 - Pontiac G8 Owner Manual

Using Cruise Control on Hills
How well the cruise control works on
hills depends upon the vehicle
speed, load, and the steepness of
the hills.
When going up steep hills, you
might have to step on the
accelerator pedal to maintain the
vehicle speed.
When going downhill, you might
have to brake or shift to a lower gear
to keep the vehicle speed down.
When the brakes are applied
the cruise control is turned off.
Ending Cruise Control
Step lightly on the brake pedal.
When the cruise control is
deactivated, the CRUISE
INACTIVE message appears in
the instrument panel cluster.
Press theOQbutton at the
end of the lever two times.Erasing Speed Memory
The cruise control set speed memory
is erased when the cruise control or
the ignition is turned off.
Turn and Lane-Change
Signals
An arrowGon the instrument
panel cluster ashes in the direction
of the turn or lane change.
To signal a turn, move the lever all
the way up or down.
To signal a lane change, slightly
raise or lower the lever until
the arrow starts to ash and release
the lever. The turn signal ashes
automatically three times.
The lever returns to its starting
position when it is released.
To cancel the lane change, move
the lever back to the starting
position.
Headlamp
High/Low-Beam Changer
The headlamps must be on for
this feature to work.
Push the turn signal lever away
from you to turn the high beams on.
The fog lamps turn off automatically
when high beam is selected.
This instrument panel cluster light
3comes on while the high
beam headlamps are on.
Pull the lever towards you to return
to low beams.
To ash the high beams, pull the
lever towards you. The lamps
remain on high beam as long as the
lever is held.
Instruments and Controls 4-7
2008 - Pontiac G8 Owner Manual

Windshield Wipers
The windshield wiper/washer lever
is located on the right side of
the steering column.
The ignition must be turned to the
ON/RUN or ACC/ACCESSORY
position to use the windshield
wipers.Move the lever to the following
positions:
z(Mist):Hold the lever in this
position for continuous wiping
cycles.
((Off):Turns the wipers off.
&(Intermittent):For a delayed
wiping cycle. Turn the
&band
forward or rearward for more
frequent or less frequent wipes.
The frequency of wipes also
depends on the vehicle speed. As
the vehicle speed increases, so
does the wiper rate.
1 (Low):For steady wiping at low
speed.
2 (High):For steady wiping at high
speed.
Never use the wipers on dry glass,
as this could damage the wiper
blade inserts and scratch the glass.Be sure to clear ice and snow from
the wiper blades before using
them. If the blades are frozen to the
windshield, carefully loosen or
thaw them. If they become
damaged, get new blades or blade
inserts.
Heavy snow or ice can overload the
wipers. A circuit breaker stops
them until the motor cools. Clear
away snow or ice to prevent
an overload.
Windshield Washer
Pull the lever toward you to spray
washer uid on the windshield.
The spray continues until the lever
is released. The wipers will run
a few times. SeeWindshield Washer
Fluid on page 9-22for information
on lling the windshield washer uid
reservoir.
4-8 Instruments and Controls
2008 - Pontiac G8 Owner Manual