2008 PEUGEOT 807 light

Instruments and controls
READY TO SET OFF
2
37
Zero re-set
Your PEUGEOT dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
- Switch off the ignition,
- Press and hold the trip recorder
re-set button,
- Switch on the ignition.
The display begins a countdown.
When the display shows "= 0", release
the button; the spanner disappears.
Engine oil level indicator
When the ignition is switched on, the
engine oil level is indicated for a few
seconds, after the service information. Oil level correct
Lack of oil
Flashing of
"OIL",
linked with the
service warning light,
accompanied by an
audible signal and a message on the
display, indicates a lack of oil which
could damage the engine.
If the lack of oil is conirmed by a check
using the dipstick, it is essential that
the level is topped up.
Oil level gauge
fault
Flashing of "OIL --"
indicates a malfunction
of the engine oil level
gauge. Consult a PEUGEOT dealer.
Dipstick
A = maximum, never exceed
this level as a surplus of oil
may damage the engine.
Contact a PEUGEOT dealer
without delay.
B = minimum, top up the level
via the oil iller cap, using
the type of oil suited to your
engine.
Trip recorder zero
reset button
With the ignition on, press
the button until the zeros
appear.
Lighting rheostat
With the lights on, press
the button to vary the
intensity of the lighting
of the instruments and
controls. When the lighting reaches
the minimum (or maximum) setting,
release the button then press it again
to increase (or reduce) the brightness.
As soon as the lighting is of the
required brightness, release the button.
The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
After this operation, if you wish to
disconnect the battery, lock the
vehicle and wait for at least ive
minutes, otherwise the zero re-set will
not be registered.

READY TO SET OFF
2
43
Starting and stopping
STARTING AND STOPPING
STOP position: steering lock.
The ignition is off.
Good practice when startingHandbrake
On the version with rotating front seat,
the handbrake can be disengaged.
Pulling the handbrake to immobilise
the vehicle then lowering the lever
does not release the brake, it permits
rotation of the driver’s seat.
Pull the button placed at the end of the
handbrake forwards.
The handbrake lever lowers.
You can now rotate the seat.
To return to normal operation, pull the
lever up until it clicks.
If the handbrake is on or has
not been released fully, this is
indicated by:
- a warning light which comes on on the instrument panel,
- an audible signal,
- a message on the display.
Good practice when stopping
Running and accessories position.
Certain accessories can be used.
Starting position.
The starter is operated. Diesel pre-heating warning
light
Turn the key to the Running
position.
In cold weather, wait for this warning
light to switch off then operate the
starter (Starting position) until the
engine starts.
If the temperature is high enough, the
warning light comes on for less than one
second, you can start without waiting.
Minimise engine and gearbox
wear
When switching off the ignition, let the
engine run for a few seconds to allow
the turbocharger to return to idle.
Do not press the accelerator when
switching off the ignition.
There is no need to engage a gear
after parking the vehicle.
Good practice on long journeys
When travelling far from home, take
the conidential card with you just as
you would take your personal papers.
In other circumstances, keep this
conidential card in a safe place, never
in the vehicle.
Make a note of the coded number on
the label attached to the key and of the
code etched on the head of the
anti-theft socket (if your vehicle is itted
with alloy wheels).

Steering wheel controls
44
Automatic lights
If your vehicle is itted
with a brightness
sensor.
Lights off
Dipped beam (green)
Main beam (blue)
LIGHTING CONTROL
STEERING WHEEL CONTROLS
Checking by means of the indicator
lights on the instrument panel is
described in the "Instruments and
controls" section of chapter 2.
Side lights
Front and rear lights
Selection is by turning ring A.

Steering wheel controls
ERGONOMICS and COMFORT
3
45
Front fog lights (green)
and rear fog lights
(amber, 2nd rotation of
the ring forwards). To switch off the front and rear
fog lights, turn the ring rearwards
twice in succession.
Direction
indicators (green
flashing)
Left: downwards.
Right: upwards.
In clear weather or in rain, both
day and night, rear fog lights
dazzle and are prohibited.
Do not forget to switch them off when
they are no longer needed.
Automatic switching on of the lights
switches off the rear fog lamps, but the
front fog lamps remain on. Daytime lights
Depending on the country in which
the vehicle is sold, the vehicle may
be equipped with daytime lights. The
dipped headlamps come on when the
vehicle is started.
The instruments and controls
(instrument panel, display, air
conditioning control panel, ...) are
only lit on switching to the automatic
switching on of the lights mode or
when the lights are switched on
manually.
Dipped beam/main beam change
Pull the stalk fully towards you.
Lights-on buzzer
When the ignition is switched off, when
the driver’s door is opened, a buzzer
sounds if you have left your lights on.
Front fog lights (green, 1st
rotation of the ring forwards).
Front and rear fog lights
Rotate ring
B forwards to switch on
and rearwards to switch off. The
status is conirmed by the light on the
instrument panel.
These operate with the side lights and
the dipped beam headlamps. This warning light comes on
on the instrument panel.

Steering wheel controls
46
Automatic "Follow-Me-Home"
lighting
With the ignition off, when you leave your
vehicle with the automatic switching
on of the lights function activated , the
side lights and dipped headlamps remain
on for the selected duration.
To deactivate or activate this
function, go to the display
coniguration menu.
The duration of the timed period must
also be set (15, 30, 60 seconds), via
the display coniguration menu.
Carry out these operations when the
vehicle is stationary.
HEADLAMPS BEAM
Depending on the load in your vehicle,
the beam setting must be adjusted.
0 - 1 or 2 people in the front seats.
1 - 5 people.
2 - 6 to 8 people.
3 - Driver + maximum authorised
loads.
Initial setting is position 0.
In foggy weather or in snow,
the brightness sensor can
detect suficient light. As a
consequence, the lights will not come
on automatically.
Automatic switching on of the
lights
If your vehicle is itted
with a brightness
sensor, the side lights
and dipped beam
headlamps switch on
automatically if the light is poor, or
during operation of the windscreen
wipers. They switch off as soon as the
light becomes bright enough or the
windscreen wipers stop. This function
is not compatible with the daytime
lights. Deactivation
Turn the ring forwards or rearwards.
The deactivation of this function is
accompanied by a message on the
display.
The function is deactivated temporarily
when you use the manual lights stalk.
If the brightness sensor does not
function correctly
, the lights come on
accompanied by the service warning
light, an audible signal and a message
on the display.
Contact a PEUGEOT dealer.
Do not cover the brightness
sensor located in the centre of the
fascia. It is used for the automatic
switching on of the lights and for the
automatic wipers.
Activation
Turn the ring to the AUTO position.
The activation of this function is
accompanied by a message on the
display.
AUTOMATIC ADJUSTMENT OF
THE XENON HEADLAMPS
On vehicles which are itted with xenon
headlamps, this system automatically
corrects the height of the light beam,
regardless of the load in the vehicle.
The driver is then guaranteed optimum
lighting without dazzling other road
users.
Cancelling: 4
"lash" the headlamps,
4 get out of the vehicle and lock it.

ERGONOMICS and COMFORT
3
79
Comfort and safety
1. Driver's upper glove box
FRONT INTERIOR LAYOUT
This is itted with a lock.
To open the glove box, lift the handle.
The light comes on when the cover is
opened.
It contains three sockets for the
connection of video equipment if itted
in your vehicle.
It includes special compartments for
storing maps, a packet of cigarettes,
an A4 document etc.
This permits the connection of a mobile
telephone charger, a baby's bottle
warmer, etc.
To open, press the button.
To close, press the cover.
It includes special compartments for
storing a pen, a mobile telephone,
coins or tokens and credit cards.
2. Audio equipment concealing lap
Lower the lap fully to lock it in place.
Press the lap to raise it.
3. Central storage compartment
4. Passenger's upper glove box
To open, press the button.
To close, press the cover.
It includes special compartments for
storing a pair of spectacles, keys, ive
CDs and four audio cassettes or nine
audio CDs. 5. Passenger's lower glove box
6. Lighter or 12 V socket for
accessories (120 W) 12. Mat itting/removal
When removing the front mat, push
the seats as far back as possible and
remove the ixings.
When reitting, position the mat
correctly on the pins and clip the
ixings. Check that the mat is secured
correctly.
To prevent the mat from becoming
caught under the pedals:
- only use mats suited to the ixings
already present in the vehicle. It
is imperative that these ixings are
used.
- never it one mat on top of another.
7. Cooled compartment
It can hold up to three cans.
Slide the closer, located on the right, to
open (upwards) or close (downwards)
the air inlet.
8. Can holder and ashtray
This retractable and lit support contains
up to two can holders, a removable
ashtray and a location for the lighter
when it is used as a 12 V socket
(120 W). 9. Storage compartment or
additional telematics control
The storage compartment must not be
used as an ashtray.
If itted in your vehicle, the additional
telematics control is located on the
centre console.
10. Storage compartment
11. Door tray with space for a bottle of water

82
Comfort and safety
Front courtesy light
Automatic switching on/off
The front courtesy light comes on
when the key is removed from the
ignition, when the vehicle is unlocked,
when one of the front doors is opened
or for location of the vehicle using the
remote control.
It switches off gradually after the
ignition is switched on and when the
vehicle is locked. Permanently on, ignition on.
Front: comes on when one
of the front or rear doors is
opened.
Permanently off.Individual reading light
Rear courtesy light rows 2 and 3
These are switched on and off by
means of a manual switch.
COURTESY LIGHTS
Rows 2 and 3: comes on
when one of the rear doors is
opened. Rear courtesy light

02
89
DISPLAY AND GENERAL MENU
> COLOUR DISPLAY
This displays the following information, via the RT4 GPS audio/
telephone control pad:
- the time,
- the date,
- the exterior temperature (if there is a risk of i ce, you are warned by a
message),
- the audio source displays (radio, CD, jukebox, .. .),
- the telematic system displays (telephone, service s, ...),
- the accesses check (doors, boot, ...),
- the warning messages (e.g.: "Fuel level low") and vehicle function
status messages (e.g.: "Auto lighting activated") d isplayed temporarily,
- the trip computer display,
- the GPS (Europe) satellite navigation system disp lays.
New
The RT4 system uses the complete and detailed NAVTE Q maps installed directly on the equipment’s hard disc. There is no longer any need to
insert a map CD in the CD player. The updates of th e maps of France and of the other European countrie s, offered by our partner NAVTEQ, will be
available from the PEUGEOT network. Display coniguration: refer to 10 - Display low cha
rt.
Telephone
Orange Time:
Date: