Page 53 of 211
3
52
ELECTRIC FRONT SEATS
Longitudinal adjustment
Push the control forwards or backwards
to slide the seat. Driver and passenger seat cushion
height and angle adjustment
Height: t i l t t h e r e a r o f t h e c o n t r o l u p
or down.
Angle: t i l t t h e f r o n t o f t h e c o n t r o l u p
or down. Seat back angle adjustment
Tilt the control forwards or backwards
to adjust the angle of the seat back.
The electrical functions of the
d r i v e r ’ s s e a t ( w i t h t h e e x c e p -
tion of the access to the rear
s e a t s ) a r e d e a c t i v a t e d a p -
p r o x i m a t e l y o n e m i n u t e a f t e r t h e i g n i -
tion is switched off.
T o r e a c t i v a t e t h e m , o p e n t h e d o o r o r
switch on the ignition.
Page 55 of 211
3
54
Head restraint height and angle
adjustment
To raise or lower the head restraint,
p u l l i t f o r w a r d s t h e n s l i d e i t .
To tilt the head restraint, tilt the lower
p a r t f o r w a r d s o r b a c k w a r d s .
To remove the head restraint, move it
a l m o s t t o t h e h i g h e s t p o s i t i o n , l i f t t h e
t a b u s i n g a c o i n a n d p u l l t h e h e a d r e -
s t r a i n t f o r w a r d s a n d u p w a r d s a t t h e
same time.
T o r e fi t t h e h e a d r e s t r a i n t , e n g a g e t h e
s t a l k s i n t h e h o l e s k e e p i n g i n l i n e w i t h
the seat back. Front seat active head restraint
T h i s s y s t e m p r e v e n t s w h i p l a s h .
I n t h e e v e n t o f a r e a r i m p a c t , t h e a c t i o n
o f t h e b o d y o n t h e s e a t b a c k m o v e s
t h e h e a d r e s t r a i n t f o r w a r d s a n d u p -
w a r d s p r e v e n t i n g t h e h e a d f r o m b e i n g
thrown backwards.
Front armrest
T o c h a n g e t h e p o s i t i o n o f t h e a r m r e s t :
L i f t t h e h a n d l e 1 .
T h e a r m r e s t f o l d s f o r w a r d s a n d u p w a r d s .
T o r e t u r n t o t h e i n i t i a l p o s i t i o n , p u s h
t h e a r m r e s t b a c k w a r d s a n d p r e s s i t t o
engage.
The adjustment is correct
w h e n t h e t o p o f t h e h e a d r e -
s t r a i n t i s l e v e l w i t h t h e t o p o f
the head. N e v e r d r i v e w i t h t h e h e a d r e -
s t r a i n t s r e m o v e d ; t h e y m u s t
b e i n p l a c e a n d a d j u s t e d c o r -
r e c t l y .
Page 85 of 211
5
76
AUTOMATIC HEADLAMP ADJUSTMENT
W h e n s t a t i o n a r y a n d w h e n t h e v e h i -
cle is moving , the system automati-
cally corrects the height of the beam,
whatever the load of the vehicle. The
driver is then assured of having opti-
mum lighting and not causing a nui-
sance to other road users.
DIRECTIONAL HEADLAMPS
Activation/Deactivation
When the dipped or main beam head-
lamps are on, this function enables the
light beam to follow the direction of the
road.
The quality of your lighting when turning
is improved considerably.
I n c a s e s o f m a l f u n c t i o n ,
the warning light comes on
on the instrument panel dis-
play, accompanied by an au-
dible signal and a message
on the multifunction display. The sys-
tem places your headlamps to the low
position.
Do not touch the xenon bulbs. Consult
a PEUGEOT dealer. F u n c t i o n a c t i v a t e d
F u n c t i o n d e a c t i v a t e d To deactivate or acti-
vate the function, go to
the
"Personalisation -
C o n fi g u r a t i o n " menu on
your multifunction display.
When the engine is switched on, the
status of activation/deactivation of this
function selected when the engine was
switched off is retained.
By default, this function is activated.
Note: when stationary or driv-
ing at very low speed, or in
reverse gear, this function is
inactive.
I n t h e e v e n t o f a m a l f u n c -
tion, t h i s w a r n i n g l i g h t fl a s h e s
on the instrument panel.
O n v e h i c l e s fi t t e d w i t h d a y t i m e
lights, the function is only acti-
vated if the lights stalk is in the
dipped/main beam headlamps
position.
On starting, with the engine
running, the headlamps initial-
ise automatically and perform
a vertical sweep.
Consult a PEUGEOT dealer.
Page 96 of 211
7
86
SEAT BELTS
Detection of fastening of the front
seat belts
When the ignition is switched on , if a
front passenger has not fastened his seat
belt and if the vehicle speed is below
13 mph (20 km/h) , you are warned by
lighting of the seat belt warning light .
The warning light switches off when
the seat belt(s) concerned is(are) fas-
tened.
If the vehicle speed is above 13 mph
(20 km/h) , y o u a r e w a r n e d b y fl a s h -
ing of the seat belt warning light , an
audible signal and a message on the
multifunction display locating the un-
fastened seat belt(s).
Front seat belts with
pre-tensioner and force
limiter
In the event of a serious front impact,
the pre-tensioning system instantly
t i g h t e n s t h e s e a t b e l t s fi r m l y a g a i n s t
the bodies of the occupants.
The pre-tensioning seat belts are
armed when the ignition is on.
The force limiter reduces the pressure
of the seat belt against the chest of
the occupant, so increasing his pro-
tection. Rear seat belts
T h e r e a r s e a t s a r e e a c h fi t t e d w i t h a
three-point inertia reel seat belt.
These seat belts have a force limiter.
To fasten the seat belts
Pull the strap, then insert the
tongue into the buckle.
Check that the seat belt is fastened
correctly by pulling the strap. To unfasten the seat belts
Press the red button on the buckle.
Note: a bag or an animal
placed on the front passenger
seat may trigger the lighting of
the warning light.
The audible signal ceases and the
warning light switches off when the
seat belt concerned is fastened.
After two minutes without any action
o n t h e s e a t b e l t s , t h e fl a s h i n g w a r n i n g
light remains on permanently and the
audible signal ceases.
All of the warnings cease when a
door is opened or when the engine is
switched off.
Front seat belt height adjustment:
To lower the attachment point,
squeeze control 1 and slide it
downwards.
To raise the attachment point, slide
control 1 upwards.
