2008 Peugeot 407 C Dag bonnet
[x] Cancel search: bonnetPage 2 of 211
A. Unfolding/Folding of the key.
B. Normal locking or deadlocking.
C. Complete or selective unlocking.
D. Unlocking of the boot.
1. Bonnet opening control.
2. Opening of the bonnet.
104
Low fuel level
73
1. F u e l fi l l e r fl a p o p e n i n g b u t t o n .
2. O p e n i n g o f t h e f u e l fi l l e r fl a p .
3. Opening and hooking of the fuel
tank cap.
Capacity of the tank: approximately
67 litres.
When this warning light
comes on on the instru-
ment panel, you have
enough fuel left to drive
approximately 30 miles
(50 km).
64
Fuel tank Bonnet Remote control key
Page 5 of 211
1. Cruise control/speed limiter switches.
2. Steering wheel height and depth
adjustment.
3. Lights and direction indicators controls.
4. Instrument panel.
5. Driver's air bag.
Horn.
6. Gear lever.
7. Driver's footwell air outlet.
8. Fascia fuse box.
9. F u e l fi l l e r fl a p o p e n i n g b u t t o n .
10. Adjustable and closing side vent.
11. Speakers (tweeters).
12. Driver's seat electric controls.
13. Driver's heated seat control.
14. Bonnet release.
Page 75 of 211
4
68
THE ALARM
This provides two types of surveil-
lance:
- exterior protection: it sounds if
a door, the boot or the bonnet is
opened.
-
interior protection: it sounds if the
volume inside the passenger compart-
ment changes (breaking of a window
or a movement inside the vehicle).
When the alarm is triggered, the si-
ren sounds and the direction indica-
t o r l i g h t s fl a s h f o r a p p r o x i m a t e l y t h i r t y
seconds.
After triggering, the alarm remains set,
ten times in succession.
On the eleventh time it will become
inactive again, until the next cycle of
disarming then setting of the alarm.
Warning: if button A indicator light
fl a s h e s r a p i d l y , t h e a l a r m h a s b e e n
triggered while you were away from
your vehicle.
Incorrect operation
When the ignition is switched on, if
button A lights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have
the system checked.
R e m o t e c o n t r o l f a i l u r e , alarm set
Unlock the doors with the key and
open the door. The alarm is trig-
gered.
Switch on the ignition. The alarm is
disarmed.
* According to country.
Setting the alarm
Switch off the ignition and get out
of the vehicle.
Set the alarm, by locking or dead-
locking using the remote control
(button A i n d i c a t o r l i g h t fl a s h e s
once per second).
If you wish to lock or deadlock your
vehicle without setting the alarm, lock
it (one turn of the key) or deadlock it
( a s e c o n d t u r n w i t h i n fi v e s e c o n d s
maximum) using the lock.
The alarm is activated automatically
two minutes after the last closure of a
door or the boot.
In order to avoid accidental triggering
of the alarm when a door or the boot
is opened, it is essential to press the
unlocking button on the remote control
again.
Before setting the alarm, en-
sure that all of the accesses
(doors, bonnet, boot) are
closed correctly.
Disarming
Unlock the vehicle with the remote
control key.
The alarm is disarmed, indicator light A
goes out when the ignition is switched on.
T o s e t t h e a l a r m w i t h e x t e r i o r protection only
If, while you are away from the vehi-
cle, you wish to leave a window par-
tially open or a pet inside the vehicle,
you should choose exterior protection
only.
Switch off the ignition,
In the next ten seconds, press but-
ton A until the indicator light is on
continuously,
Get out of the vehicle,
Set the alarm by locking or dead-
locking using the remote control
(button A i n d i c a t o r l i g h t fl a s h e s
once a second).
Page 114 of 211
9
104
Bonnet strut
Secure the strut in its housing to hold
the bonnet open.
Before closing the bonnet, replace the
strut in its clip.
OPENING THE BONNET
From inside: pull the handle on
the left-hand side under the fascia
towards you.
From outside: lift the catch and raise
the bonnet. To avoid any risk of burns, only
handle the bonnet strut by the
protective foam.
To close
Lower the bonnet and release it at the
end of its travel. Check that the bonnet
is properly locked.
Page 133 of 211
1010
120
Before disconnecting the bat-
tery, you must wait for 2 minu-
tes after switching off the
ignition.
Never disconnect a terminal when the
engine is running.
N e v e r c h a r g e a b a t t e r y w i t h o u t fi r s t
disconnecting the terminals.
Open the windows and close the sun-
roof before disconnecting the battery.
If they do not operate normally follow-
ing reconnection of the battery, they
must be reinitialised (see paragraphs
"Reinitialisation of the electric win-
dows" and "Sunroof").
After every reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised.
H o w e v e r , i f s l i g h t d i f fi c u l t i e s a r e e x -
perienced after this, please contact a
PEUGEOT dealer.
On the 2.7 litre 24V HDI engine, if
there is no battery in the boot, do
not connect a slave battery to the
positive (+) and negative (-) termi-
nals under the bonnet as a short
circuit may occur.
The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
disposed of in accordance
with regulations and must never be
discarded with household waste.
Take used batteries to an approved
collection point.
open the bonnet,
use the two additional positive (+)
and negative (-) terminals located
under the bonnet,
open the red cover of the positive
(+) terminal,
connect the red cable between the
positive (+) terminal and the positive
(+) terminal of the slave battery,
connect the green or black cable
between the negative (-) terminal
and the negative (-) terminal of the
slave battery,
operate the starter, let the engine
run,
wait for the engine to return to idle,
then disconnect the cables,
close the red cover of the positive
(+) terminal,
r e fi t t h e l e f t s i d e c o v e r ,
close the bonnet. BOOT) *
* V e h i c l e s fi t t e d w i t h t h e 2 . 7 l i t r e H D I
24 V engine.
The battery is in the left boot trim.
To charge the battery using a battery
charger (boot open):
fold down the panel to gain access
to the battery,
disconnect the battery,
follow the instructions for use given
by the battery charger manufacturer,
reconnect starting with the nega-
tive (-) terminal,
raise the panel and close it. To start the vehicle from another
battery: