2008 Peugeot 107 Dag ESP
[x] Cancel search: ESPPage 11 of 97
14
FAMILIARISATION
W h e n t h e i g n i t i o n i s o n , t h e o r a n g e
and red warning lights come on.
W h e n t h e e n g i n e i s r u n n i n g , t h e s e
warning lights should switch off.
I f w a r n i n g l i g h t s r e m a i n o n , r e f e r t o
the page concerned.
18
A. Rev counter
B. Display
C. Fuel gauge
17 The dynamic stability control system
(ASR/ESP) optimises the vehicle's
road holding.
F o r c o r r e c t o p e r a t i o n o f t h e s y s t e m ,
refer to the page concerned.
56
MONITOR THOROUGHLY
Instrument panel Warning lights ASR/ESP option
Page 16 of 97
1
19
INSTRUMENTS and CONTROLS
Battery charge
warning light
This comes on each time
the ignition is switched on
until the engine is started.
Fixed lighting, with the engine run-
ning, indicates a malfunction.
Consult a PEUGEOT dealer.
Driver's seat belt not
fastened warning
light *
When the ignition is
s w i t c h e d o n , t h e w a r n i n g l i g h t fl a s h e s
until the driver fastens his seat belt.
Above a speed of approximately
10 mph (15 km/h), the warning light
fl a s h e s a c c o m p a n i e d b y a n a u d i b l e
signal until the driver fastens his seat
belt.
The driver must ensure that all pas-
sengers have fastened their seat belt
correctly.
Air bags warning light
This comes on for a few
seconds each time the igni-
tion is switched on.
Passenger air bag disarmed
If the passenger air bag is disarmed,
the warning light remains on. 2 Tronic gearbox
warning light
Fixed lighting of this warning
light, with the engine run-
ning, indicates a malfunction of the
2 Tronic gearbox.
Emission control
system warning light
This comes on each time
the ignition is switched on
until the engine is started.
Fixed lighting, with the engine run-
ning, indicates an emission control
system fault.
Consult a PEUGEOT dealer. Diesel engine pre-heat
warning light
Wait until the warning light is
switched off before starting.
I f t h e t e m p e r a t u r e i s s u f fi c i e n t , t h e
w a r n i n g l i g h t c o m e s o n b r i e fl y , y o u
can start without waiting.
Water in diesel filter
warning light **
This comes on for a few
seconds each time the igni-
tion is switched on.
Fixed lighting, with the engine run-
ning, indicates a risk of damage to
the engine.
Consult a PEUGEOT dealer.
* According to version.
Note: it may also come on if
you run out of fuel (see "Run-
ning out of fuel").
** According to country.
Dynamic stability
control system
(ASR/ESP) activation
warning light
This comes on for a few seconds each
time the ignition is switched on.
With the engine running and the ve-
hicle moving, it comes on if the sys-
tem is activated. Dynamic stability
control system (ASR/
ESP) fault warning
light
This comes on for a few seconds each
time the ignition is switched on.
If this warning light comes on, with
the engine running, this indicates a
fault in the system.
Consult a PEUGEOT dealer.
Page 19 of 97
1
21
INSTRUMENTS and CONTROLS
Operating mode:
1st gear
2nd gear
3rd gear
4th gear
5th gear
If this warning light comes
on, with the engine running,
this indicates a malfunction
of the "2 Tronic" gearbox. Fuel gauge
This indicates the quantity of fuel
available:
-
1/1 and six blocks, the fuel tank
is full.
- R a n d o n e b l o c k fl a s h i n g , t h e
fuel tank is on the reserve.
Low fuel level
When the minimum level in the fuel
t a n k i s r e a c h e d , t h e l a s t b l o c k fl a s h e s
accompanied by an audible signal.
In certain driving conditions and depend-
ing on the engine, the distance which
can be travelled with the fuel remaining
may be less than 30 miles (50 km).
You have approximately 5 litres
remaining.
W h e n t h e f r e q u e n c y o f t h e fl a s h i n g
increases, you have approximately
3 litres remaining .
At least 5 litres must be added
after running out of fuel. Running out of diesel fuel
After running out of fuel, you
can travel a short distance after
10 pump repriming operations
(see corresponding section).
A f t e r fi l l i n g t h e f u e l t a n k ( m i n i m u m
5 litres), operate the repriming pump
at least 10 times (see corresponding
section).
"!" warning light
Consult a PEUGEOT dealer.
Page 23 of 97
2
25
AUDIO EQUIPMENT
Stereo reception
When the audio equipment receives
a station broadcasting in stereo it au-
tomatically transmits stereo sound
and the screen displays "ST" . If the
reception conditions deteriorate, the
audio equipment returns to mono
transmission and "ST" is no longer
displayed. Press one of these two
b u t t o n s b r i e fl y t o i n -
crease or decrease the
frequency displayed
respectively.
If you maintain the
pressure on the button
in the chosen direc-
tion, the frequency will be scanned
continuously.
The scan stops when you release the
button.
Manual station search
Automatic station search
Manual station storing
Selection of the radio source
Selection of a waveband
Press this button.
Press this button twice to
select the next station.
P r e s s t h i s b u t t o n b r i e fl y
to listen to each station
available on the FM waveband for three
seconds. To stop the station scan, press
this button again.
I f t h e t r a f fi c i n f o r m a t i o n p r o g r a m m e
TA is selected, only stations which
broadcast this type of programme
are selected.
Press the button several
times in succession to
select the wavebands
FM1, FM2, FM3 and
AM.
Select the required station.
Press one of the buttons "1" to "6"
for more than 2 seconds
A n a u d i b l e s i g n a l c o n fi r m s t h a t t h e
station has been stored.
Page 24 of 97
2
26
AUDIO EQUIPMENT Notes on radio
reception
Your audio equipment will be
subjected to phenomena which do
not affect domestic radio sets. Both
MW/LW and FM reception are sub-
ject to various forms of interference.
T h i s i s n o r e fl e c t i o n o n t h e q u a l i t y o f
the equipment but is due to the na-
ture of the signals and the way in
which they are transmitted.
On MW/LW, interference may be
noticed when passing under high
voltage power lines or bridges, or in
tunnels.
On FM, interference may be the re-
sult of increasing distance from the
t r a n s m i t t e r , d e fl e c t i o n o f t h e s i g n a l b y
obstacles (mountains, hills, buildings,
etc) or of being in an area which is not
covered by a transmitter.
Automatic storing of FM
stations (autostore)
Press this button.
Your audio equipment
automatically stores
the six best transmitters
received on AM and FM in your cur-
rent location. These stations are stored
on the AM and FM3 wavebands. The
end of the search is signalled by two
audible signals. Recalling stored stations
On each waveband, a brief press on
one of the buttons
"1" to "6" recalls
the corresponding stored station.
I f i t w a s n o t p o s s i b l e t o fi n d
six transmitters, the remain-
ing memories remain empty:
three dashes are displayed
on the audio equipment screen for
each empty memory.
Page 25 of 97
2
27
AUDIO EQUIPMENT
Regional following mode (REG)
Some stations, organised in a network,
broadcast regional programmes in
the various regions which they serve.
The regional following mode enables
you to continue listening to the same
programme. Search by type of programme
(PTY)
This enables you to listen to sta-
tions which broadcast a type of pro-
gramme which has a theme (NEWS,
SPORTS, TALK, POP, CLASSICS).
EON system
This system links stations which be-
long to the same network. It permits
t h e t r a n s m i s s i o n o f t r a f fi c i n f o r m a t i o n
broadcast by a station which belongs
to the same network as the station to
which you are listening.
I n o r d e r t o b e n e fi t f r o m t h i s , s e l e c t t h e
t r a f fi c i n f o r m a t i o n p r o g r a m m e
TA .
Using the AF (alternative
frequency) function on the FM
waveband
The
RDS (Radio Data System) ena-
bles you to continue listening to the
same station irrespective of the fre-
quency that it uses in your current
location. The audio equipment con-
tinuously searches for the transmitter
which provides the best reception.
Press this button sever-
al times in succession
to activate or deacti-
vate the function.
On FM, the multifunction display will
indicate:
- "TP" or "TP EON" : the radio
transmits a programme while
awaiting the broadcasting of
t r a f fi c i n f o r m a t i o n .
- "TA" or "TA EON" : the pro-
gramme transmitted by the radio
is put on standby while awaiting
t h e b r o a d c a s t i n g o f t r a f fi c i n f o r -
mation.
If you wish to interrupt the transmission
of a message, press this button again.
Traffic information
programme (TA)
Press this button sever-
al times in succession
to activate or deacti-
vate the function.
The screen will indicate:
- "AF" if the function is activated,
- "AF REG" if the function is
activated at regional level,
- "AF" fl a s h i n g i f t h e f u n c t i o n i s n o t
available. When
FM is selected,
press this button:
Notes: the volume of the traf-
fi c i n f o r m a t i o n i s i n d e p e n d e n t
of the volume of normal radio
listening.
You can adjust it using the
volume button, when the TA pro-
gramme is being transmitted.
The setting will be stored and will be
used during subsequent message
transmissions.
RDS
- "no PTY" is displayed,
- t h e n p r e s s t h e b u t t o n b r i e fl y t o select a programme.
After a few seconds without any action,
your selection is stored.
Page 30 of 97
2
30
AUDIO EQUIPMENT Press this button.
CD CHANGER FUNCTIONS Random playing of a CD
(RAND) When the CD changer
is selected, press this
button for 2 seconds.
The tracks of the current CD will be
played in a random order.
Press the button again for 2 seconds
to return to normal play.
Selection of a CD Press one of these
buttons on the audio
equipment to select
the previous or next
CD respectively. Repeating of a CD (RPT)
If you wish to listen to
the current CD again,
press and hold this
button.
The use of copied CDs may
cause faults.
Insert circular CDs only.
To cancel the repetition, press the
button again.
Selection of the CD changer
Page 57 of 97
6
55
SAFETY
HORN
Press one of the spokes of the steering
wheel.
HAZARD WARNING LIGHTS
Press the button, the direction indicators
fl a s h .
They can operate with the ignition off.
ANTI-LOCK BRAKING
SYSTEM (ABS) AND EBFD
AND CSC * BRAKING
SYSTEMS
The ABS, in conjunction with the
EBFD and CSC * braking systems, in-
creases the stability and manoeuvra-
bility of your vehicle on braking and
provides improved control, in particu-
lar on poor or slippery road surfaces.
The ABS prevents wheel lock in the
event of emergency braking.
The EBFD and CSC * systems provide
full control of the braking pressure wheel
by wheel. A distribution between:
- the front and the rear in the case of the EBFD (Electronic Brake
Force Distribution),
- the left and the right in the case of the CSC * (Cornering Stability
Control).
When the vehicle is being
driven, illumination of this
warning light indicates that
the handbrake is still on
or has not been properly
released.
When parking on a slope,
direct your wheels towards
the pavement and pull the
handbrake.
HANDBRAKE
Applying
Pull the handbrake to immobilise
your vehicle.
Note: when changing wheels
(tyres), make sure that these
are approved.
The anti-lock braking system
comes into operation automatically
when there is a risk of wheel lock.
* The CSC system is linked with the E B F D o n v e h i c l e s w h i c h a r e n o t fi t -
ted with ASR/ESP systems.
Releasing
Pull on the handle and press the button
to release the handbrake.