WINDSHIELD WIPER/WASHER SWITCH
The ignition switch must be in the ON position to
activate the windshield wipers.
Move the lever to the following positions to operate
the windshield wipers:
Intermittent (INT)– Front wipers operate in-
termittently andcanbefurther adjusted by
twisting the time control ring
.
Low Speed (LO)–Continuous low-speed
operation of front wipers.
High Speed (HI)–Continuous high-speed
operation of front wipers.
Mist (MIST) – Lift the lever up for one sweep of the front wipers.
Rear Wipers (REAR)– Twist the end section to operate the first (INT)or second
(ON) speed settings for the rear wipers.
The washer function activates the washer fluid and several sweeps of the wipers:
● For FRONT WASHER, pull lever toward you.
● For REAR WIPER, push lever away from you.
HEADLIGHT AND TURN SIGNAL CONTROL
TO ACTIVATE THE AUTOLIGHT SYSTEM:
Turn the headlight control switchto the AUTO position
to activate the autolight system. The autolight system can:
Turn the headlights on automatically when it is dark.
Turn the headlights off automatically when it is light.
Keep theheadlights onfor 45 seconds afteryouturn
the ignition switch to OFF and all doors are closed.
TO DEACTIVATE THE AUTOLIGHT SYSTEM:
Turn the headlight control switchto the OFF,orposition.
HEADLIGHT CONTROL SWITCH
Turn the headlight control switchto theposition to turn on the front parking,
tail, license plate and instrument panel lights.
Turn the headlight control switch
to theposition to turn on the headlights. All
other lights remain on.
3
FOG LIGHT OPERATION
NOTE:The headlights must be on and the low beams selected for the fog lights to operate.
Turn the switch (inside collar)
to theposition to turn on the fog lights.
Turn the switch (inside collar)
to the OFFposition to turn off the fog lights.
TURN SIGNAL SWITCH
Move the headlight control switch up or downto
signal a turning direction. When the turn is completed,
the turn signals cancel automatically.
To signal alane change, movetheheadlight control
switch up or down
to the point where the indicator
light begins to flash, but the headlight control switch does not latch.
HIGH BEAM
Push the headlight control switch forwardto se-
lect thehigh beam function. Theblue
indicator
light illuminates. Pulltheheadlight switchbacktothe
original position to select the low beam. The blue
indicator light goes off.
Pull and release the headlight control switch
to flash the headlight high beams on
and off.
LIGHTS ON DEMAND (if so equipped)
The lights ondemand switchallowsthedriver toselect oneofthree
lighting modes for the interior lights and puddle lamps:
Push thetop portion ofthe switch andtheinterior lightsand
puddle lamps will illuminate. The lights will turn off automatically
after 30minutes toprevent thebattery frombecoming dis-
charged.
Push the switch to the neutral position and the lights will stay on for approximately 30
seconds when:
The doors areunlocked bythe keyfob, akey, orthe power doorlockswitch whileall
doors are closed and the ignition switch is in the OFF position.
The driver’s door is opened and then closed while the key is removed from the ignition
switch.
The key is removed from the ignition switch while all doors are closed.
4
