2008 NISSAN PATHFINDER light

[x] Cancel search: light

Page 385 of 448

NISSAN PATHFINDER 2008 R51 / 3.G Owners Manual HEADLIGHTS
The headlight is a semi-sealed beam type which
uses a replaceable headlight (halogen) bulb. A
bulb can be replaced from inside the engine
compartment without removing the headlight as-
semb

Page 386 of 448

NISSAN PATHFINDER 2008 R51 / 3.G Owners Manual 4. Turn the bulb retaining ring counterclock-
wise until it is free form the headlight reflec-
tor and then remove it
sA.
5. Carefully remove the headlight bulb. Do not
shake or rotate the bulb when r

Page 387 of 448

NISSAN PATHFINDER 2008 R51 / 3.G Owners Manual 1. Map lights
2. Personal lights
3. Cargo light
4. High-mount stoplight
5. License plate light
6. Rear combination light7. Headlight assembly
8. Fog lightReplacement procedures
All other lights are ei

Page 388 of 448

NISSAN PATHFINDER 2008 R51 / 3.G Owners Manual Use a cloths1to protect the housing.
Map lights
LDI0459
Cargo light
WDI0206
Rear combination light
LDI0448
8-32Maintenance and do-it-yourself
ZREVIEW COPYÐ2008 Pathfinder(pat)
Owners ManualÐUSA_Engl

Page 389 of 448

NISSAN PATHFINDER 2008 R51 / 3.G Owners Manual If you have a flat tire, see the “In case of
emergency” section of this manual.
TIRE PRESSURE
Tire Pressure Monitoring System
(TPMS)
This vehicle is equipped with the Tire
Pressure Monitoring Syst

Page 398 of 448

NISSAN PATHFINDER 2008 R51 / 3.G Owners Manual Replacing wheels and tires
When replacing a tire, use the same size, tread
design, speed rating and load carrying capacity
as originally equipped. Recommended types and
sizes are shown in “Wheels an

Page 404 of 448

NISSAN PATHFINDER 2008 R51 / 3.G Owners Manual Take care not to spill gasoline during refu-
eling. Gasoline containing oxygenates can
cause paint damage.
E–85 fuel
E-85 fuel is a mixture of approximately 85% fuel
ethanol and 15% unleaded gasolin

Page 412 of 448

NISSAN PATHFINDER 2008 R51 / 3.G Owners Manual Use the following steps to mount the front license
plate:
1. Make holes on the plastic finisher at the
location mark (small dimple) using a 0.37 in
(9.5 mm) drill. Apply light pressure to the
drill. I