2008 NISSAN FRONTIER service

[x] Cancel search: service

Page 301 of 352

NISSAN FRONTIER 2008 D22 / 1.G Owners Manual Wheel nut tightening torque:
98 ft-lb (133 N·m)
The wheel nuts must be kept tight-
ened to specifications at all times. It
is recommended that wheel nuts be
tightened to specification at each
tire ro

Page 303 of 352

NISSAN FRONTIER 2008 D22 / 1.G Owners Manual If excessive tire wear is found, it is recommended
that all four tires be replaced with tires of the
same size, brand, construction and tread pattern.
The tire pressure and wheel alignment should
also

Page 305 of 352

NISSAN FRONTIER 2008 D22 / 1.G Owners Manual 9 Technical and consumer information
Capacities and recommended fuel/lubricants.........9-2
Fuel recommendation...........................9-3
Engine oil and oil filter recommendations..........9-5
Air

Page 306 of 352

NISSAN FRONTIER 2008 D22 / 1.G Owners Manual The following are approximate capacities. The actual refill capacities may be a little different. When refilling, follow the procedure
described in the “Maintenance and do-it-yourself” section to

Page 307 of 352

NISSAN FRONTIER 2008 D22 / 1.G Owners Manual FUEL RECOMMENDATION
For 2.5L engine.
Use unleaded regular gasoline with an octane
rating of at least 87 AKI (Anti-Knock Index) num-
ber (Research octane number 91) .
For 4.0L engine.
NISSAN recommends

Page 310 of 352

NISSAN FRONTIER 2008 D22 / 1.G Owners Manual the oil before the first recommended change
interval. Oil and filter change intervals depend
upon how you use your vehicle.
Operation under the following conditions may
require more frequent oil and f

Page 336 of 352

NISSAN FRONTIER 2008 D22 / 1.G Owners Manual To drive away:
1. Start the vehicle.
2. Apply and hold the brake pedal.
3. Shift the transmission into gear.
4. Release the parking brake.
5. Drive slowly until the vehicle and trailer are
clear from

Page 338 of 352

NISSAN FRONTIER 2008 D22 / 1.G Owners Manual DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable on
the
Page:   < prev 1-10 9-16 17-24 25-32 33-40 next >