2008 NISSAN ARMADA engine

[x] Cancel search: engine

Page 374 of 456

NISSAN ARMADA 2008 1.G Owners Manual 1. Battery
2. Fuse/fusible link box
3. Transmission dipstick
4. Engine oil filler cap
5. Brake fluid reservoir
6. Windshield washer fluid reservoir
7. Air cleaner
8. Drive belt location
9. Radiator ca

Page 375 of 456

NISSAN ARMADA 2008 1.G Owners Manual The engine cooling system is filled at the factory
with Genuine NISSAN Long Life
Antifreeze/Coolant to provide year-round anti-
freeze and coolant protection.The anti-freeze so-
lution contains rust a

Page 376 of 456

NISSAN ARMADA 2008 1.G Owners Manual If the cooling system frequently requires
coolant, have it checked by a NISSAN
dealer.
CHANGING ENGINE COOLANT
A NISSAN dealer can change the engine coolant.
The service procedure can be found in the

Page 377 of 456

NISSAN ARMADA 2008 1.G Owners Manual 5. Remove the dipstick again and check the oil
level. It should be between the H (High) and
L (Low) marks
sB. This is the normal oper-
ating oil level range. If the oil level is below
the L (Low) mark

Page 378 of 456

NISSAN ARMADA 2008 1.G Owners Manual If the oil filter is to be changed, remove and
replace it at this time. See “Changing engine
oil filter” later in this section.
WARNING
cProlonged and repeated contact with
used engine oil may cau

Page 379 of 456

NISSAN ARMADA 2008 1.G Owners Manual 5. Wipe the engine oil filter sealing surface with
a clean rag.
Be sure to remove any old gasket material
remaining on the sealing surface of the en-
gine.
6. Coat the gasket on the new filter with cl

Page 381 of 456

NISSAN ARMADA 2008 1.G Owners Manual Refill the reservoir more frequently when driving
conditions require an increased amount of win-
dow washer fluid.
Recommended fluid is Genuine NISSAN Wind-
shield Washer Concentrate Cleaner & Anti-
f

Page 382 of 456

NISSAN ARMADA 2008 1.G Owners Manual 1. Remove the battery caps with a screwdriver
as shown. Use a cloth to protect the battery
case.
2. Check the fluid level in each cell. If it is
necessary to add fluid, add only distilled
water to bri