2008 MITSUBISHI COLT clock

Maintenance8-37
8
To remove the cover (LHD vehicles)E01006800040
1. Turn the clips (A) anticlockw ise, then remove the cover
(B). 2. Remove the fuse puller (C) from the cover (B).

Maintenance8-39
8
To replace the cover (LHD vehicles)E01006900070
1. Align the cover hook (A) with the hole in the vehiclepanel, then press the cover into place. 2. Turn the clips (B) anticlockwise to retain the cover.

8-46 Maintenance
8
NOTE●When installing the bulb, align the upper part as illus-
trated then press the bulb into place.
Replacement of high beamE01007100040
1. On the left side of the vehi cle, turn the cap (A) anticlock-
wise to remove it. On the right side, turn the cap (A)
clockwise to remove it.
Upper

Maintenance8-49
8
Front turn-signal lampsE01003800270
1. Remove the cover from the splash shield.(Refer to “Headlamps: Replacement of low beam” on
page 8-44.)
2. Turn the bulb socket anticlockwise to remove it. And remove the bulb from the socket by turning it anticlock-
wise while pressing in.
Side turn-signal lampsE01003900082
1. Remove the lamp housing by levering it towards the frontof the vehicle.
Front

8-50 Maintenance
8
2. Remove the socket and bulb assembly together by turningit anticlockwise, and then remove the bulb by pulling out.Front fog lamps*E01004000660
3-door models
1. Remove the bumper protector (A) as follows:Pull the bottom edge of the bumper protector (B) towards
you at the end closer to the centreline of the vehicle so as
to lift the bumper protector a little at that point, then insert
a minus screwdriver into the gap and use it as a lever to
release the tab (C).

8-52 Maintenance
8
4. Push the connector (E) to disconnect and remove the foglamp. 5. Remove the entire socket and bulb assembly (F) by turn-
ing it anticlockwise.

8-56 Maintenance
8
4. Remove the entire socket and bulb assembly (D) by turn-ing it anticlockwise.NOTE● When mounting the lamp unit, align the holes in the lamp
unit with the pins (E) on the vehicle body.

Maintenance8-59
8
4. Remove the bulb by turning it anticlockwise while press-ing in.NOTE● When mounting the lamp unit, align the pins (G) on the
lamp unit with the holes in the body.
E- Rear turn-signal lamp
F- Stop lamp