2008 MITSUBISHI COLT ignition

Seat and seat belts2-29
2
Pregnant women restraint
E00405600136
Seat belt pre-tensioner system and force
limiter system
E00405700010
The driver’s seat and front passenger’s seat each have a seat
belt equipped with a pre-tensioner system.
Pre-tensioner systemE00405800936
The pre-tensioner systems will retract their respective seat belts
instantaneously, thus maximizing the seat belt’s effectiveness,
if there is a frontal impact severe enough to injure the driver
and/or front passenger and the ignition switch is in the “ON” or
“START” position.
The seat belt pre-tensioner incl udes the following components:
WARNING!
●Seat belts work for everyone, including pregnant
women. Pregnant women should use the available
seat belts. This will reduce the likelihood of injury to
both the woman and the unborn child. The lap belt
should be worn across the thighs and as snug against
the hips as possible, but not across the waist. Consult
your doctor if you have any additional questions or
concerns.
1- Air bag control unit
2- Front impact sensors
3- Seat belt pre-tensioner

2-52 Seat and seat belts
2
The air bags will operate only when the ignition switch is in the
“ON” or “START” position.When the impact sensors detect
an impact of sufficient frontal
or side force, an automated circuit ignites materials in the infla-
tor to generate gas and inflate the air bags.
The deployment of the air bags produces a sudden, loud noise,
and releases some smoke and powder, but these conditions are
not injurious and do not indicate a fire in the vehicle. People
with respiratory problems may feel some temporary irritation
from chemicals used to produce the deployment; open the win-
dows after air bag deployment, if safe to do so.
The air bags deflate very rapidl y after deployment, so there is
little danger of obscured vision.
The time required from the sensors detecting an impact to
deflation of the air bags after deployment is shorter than a blink
of an eye.
7- Side air bag modules*
8- Curtain air bag modules*
9- Side impact sensors*CAUTION!
● Air bags inflate at an ex tremely rapid speed. In cer-
tain situations, contact with inflating air bags can
result in light cuts, bruises, and the like.

Seat and seat belts2-53
2
Front passenger’s air bag ON-OFF switch*E00410100139
The front passenger’s air bag ON-OFF switch can be used to
disable the front passenger’s air bag. If you have a rearward
facing child restraint system that cannot be fitted to any seat
other than the front passenger seat, be sure to turn OFF the
front passenger’s air bag ON-OFF switch before using it.
(Refer to “To turn an air bag off” on page 2-54.)
Front passenger’s air bag ON-OFF switch is located in the
glove box.
WARNING!
●To reduce the risk of serious or fatal injury:
• Always remove the key from the ignition switch
before operating an air bag ON-OFF switch. Fail-
ure to do so could adversely affect the air bag per-
formance.
• Wait at least 60 seconds to operate the air bag ON- OFF switch after turning the ignition switch from
the “ON” position to the “LOCK” position.
The air bag SRS system is designed to retain
enough voltage to deploy the air bag.
• Be sure that the key is in the “ON” or “OFF” posi- tion.
Always remove the key from an air bag ON-OFF
switch after operating the switch.
Never remove the key, when the key-position is
between “ON” and “OFF”.
Neglecting to do so coul d lead to an inaccurate
key-position of the air bag ON-OFF switch.

2-54 Seat and seat belts
2
To turn an air bag offE00410600121
To turn an air bag off, follow these steps:1. Insert the key into the key opening of the air bag ON-OFF
switch, push the key inwards until stopped by a touch and
then turn the key from the “ON” to the “OFF” position
(anticlockwise).
2. Be sure that the key is in the “OFF” position before removing the key from the key opening of the air bag ON-
OFF switch.
3. Insert the key into the ignition switch, and turn the igni- tion to the “ON” position.
The air bag off indicator lamp, with the word “OFF PASS AIR
BAG” (depending on which air bag has been turned off) should
illuminate. This tells you that the air bag is OFF and will NOT
deploy. (Refer to “Front passenger’s air bag off indicator lamp”
on page 2-56.) The air bag will remain OFF, and will NOT deploy, until it is
turned ON again.
WARNING!
●
To reduce the risk of serious or fatal injury:
• If the indicator does not come on when the front
passenger’s air bag ON-OFF switch is turned OFF,
do not fit a rearward facing child restraint system
to the front passenger seat.
• Do not turn OFF the fron t passenger’s air bag ON-
OFF switch except when a rearward facing child
restraint system is fitt ed to the front passenger
seat.

Seat and seat belts2-55
2
To turn an air bag onE00410700092
To turn an air bag on, follow these steps:1. Insert the key into the key opening of the air bag ON-OFF
switch, push the key inwards until stopped by a touch and
then turn the key from the “OFF” to the “ON” position
(clockwise).
2. Be sure that the key is in the “ON” position before remov- ing the key from the key opening of the air bag ON-OFF
switch.
3. Insert the key into the ignition switch and turn the ignition to the “ON” position.
The air bag off indicator lamp, with the word “OFF PASS AIR
BAG” (depending upon which air bag has been turned back
on) should not illuminate. The air bag will remain ON, and will be ready to deploy, until
it is turned OFF again.
WARNING!
●
To reduce the risk of serious or fatal injury:
• Turn ON the front passenger’s air bag ON-OFF
switch immediately after removing a rearward
facing child restraint sy stem from the front pas-
senger seat.
• If the indicator remains on when the front passen- ger’s air bag ON-OFF switch is turned ON, do not
allow anyone to sit on the front passenger seat.

2-70 Seat and seat belts
2
SRS warning lampE00407800826
There is a supplemental restraint system (“SRS”) warning lamp
on the instrument panel. The system checks itself and the lamp
tells you if there is a problem. When the ignition key is turned
to the “ON” or “START” position, the warning lamp should
illuminate for several seconds and then should go out. This
means the system is ready. If an SRS air bags or pre-tensioner
seat belt is not operating properly, the warning lamp comes on
and stays on and a buzzer sounds.
The SRS warning lamp is shared by the following: ● Driver’s air bag
● Front passenger’s air bag*
● Side air bags*
● Curtain air bags*
● Seat belt pre-tensioners
● Front passenger’s air bag ON-OFF switch*
WARNING!
●If any of the following conditions occurs, the SRS
and/or seat belt pre-tensioners are not working
properly, and we recommend you to have it
inspected by a MITSUBISHI MOTORS Authorized
Service Point immediately.
• The SRS warning lamp does not illuminate when
you start the vehicle.
• The SRS warning lamp does not go out after sev- eral seconds.
• The SRS warning lamp illuminates while driving.

3-4 Instruments and controls
3
TachometerE00500300142
The tachometer indicates the engine speed (r/min). The
tachometer can help you obtain more economical driving and
also warns you of excessive engine speeds.
Odometer/TripmeterE00500600060
When the ignition switch is in the “ON” position, odometer
and tripmeter indications are given.
Odometer
The odometer indicates the total distance the vehicle has
travelled.
CAUTION!
● When during, watch the tachometer to make sure
that the engine speed indi cation does not rise into
the red zone (excessive engine rpm).
A- Odometer
B- Tripmeter
C- Reset button

Instruments and controls3-5
3
Tripmeter
The tripmeter indicates the dist ance travelled during a particu-
lar trip or period.
There are two tripmeter displays: TRIP and .
TRIP can be used to measur e the distance travelled since
the current trip began. At the same time, TRIP can be used
to measure the distance from an intermediate location.
Every time the reset button (C) is pressed lightly (less than 1
second), tripmeter indications (TRIP and ) are changed. To reset the tripmeter
To return the display to “0”, press the reset button (C) for more
than 1 second. Only the currently displayed value will be reset.
If TRIP is displayed, for example, only TRIP will be
reset.
NOTE
●
Display TRIP and each have a maximum distance
of 9999.9 km or mile.
● Even when the engine has been stopped, the odometer/trip
odometer indication is given for about 30 seconds if any
of the following steps is taken.
• The ignition key is turned to the “OFF” position.
• Any door is opened.
• The odometer/trip odometer reset button is pressed.
● When disconnecting the batter y terminal for a long time,
the memory of tripmeter display TRIP and are
cleared, and the display returns to “0”.
TRIP
TRIP