2008 Mercury Milan trailer

Automatic transmission fluid expands when warmed. To obtain an
accurate fluid check, drive the vehicle until it is warmed up
(approximately 20 miles [30 km]). If your vehicle has been
operated for an extended period at high speeds, in city traffic
during hot weather or pulling a trailer, the vehicle should be
turned off for about 30 minutes to allow fluid to cool before
checking.
1. Drive the vehicle 20 miles (30 km) or until it reaches normal operating
temperature.
2. Park the vehicle on a level surface and engage the parking brake.
3. With the parking brake engaged and your foot on the brake pedal,
start the engine and move the gearshift lever through all of the gear
ranges. Allow sufficient time for each gear to engage.
4. Latch the gearshift lever in P (Park) and leave the engine running.
5. Remove the dipstick, wiping it clean with a clean, dry lint free rag. If
necessary, refer toIdentifying components in the engine compartment
in this chapter for the location of the dipstick.
6. Install the dipstick making sure it is fully seated in the filler tube.
7. Remove the dipstick and inspect the fluid level. The fluid should be in
the designated areas for normal operating temperature.
Low fluid level
Do not drive the vehicle if the fluid
level is below the lower notch on
the dipstick and the outside
temperatures are above 50°F
(10°C).
Correct fluid level
The transmission fluid should be checked at normal operating
temperature 149°F (65°C) on a level surface. The normal operating
temperature can be reached after approximately 20 miles (30 km) of
driving.
The transmission fluid should be in
between the notches if at normal
operating temperature 149°F
(65°C).
2008 Milan(mln)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
279

Checking automatic transmission fluid at normal operating
temperature (140°F-158°F [60°C-70°C])
Automatic transmission fluid expands when warmed. To obtain an
accurate fluid check, drive the vehicle until it is warmed up
(approximately 20 miles [30 km]) until the engine coolant gauge
indicates normal operating temperature. If your vehicle has been
operated for an extended period at high speeds, in city traffic
during hot weather or pulling a trailer, the vehicle should be
turned off for about 30 minutes to allow fluid to cool before
checking.
1. Drive the vehicle 20 miles (30 km) or until the coolant guage indicates
normal operating temperature.
2. Park the vehicle on a level surface and engage the parking brake.
3. With the parking brake engaged and your foot on the brake pedal,
start the engine and move the gearshift lever through all of the gear
ranges. Allow sufficient time for each gear to engage (approximately
10–15 seconds in each position).
4. Move the gearshift lever to P (Park) and leave the engine running.
5. Remove the dipstick, wiping it clean with a clean, dry, lint-free rag. If
necessary, refer toIdentifying components in the engine compartment
in this chapter for the location of the dipstick.
6. Install the dipstick making sure it is fully seated in the filler tube.
7. Remove the dipstick and inspect
the fluid level. The fluid should read
within the hot range on the dipstick
if at normal operating temperature
(140°F-158°F [60°C-70°C]).
Checking automatic transmission fluid at cool temperature
(59°F-77°F [15°C-25°C])
If a fluid check is necessary at a low
fluid temperature (59°F-77°F
[15°C-25°C]), perform the check
using the cold range on the dipstick.
However, the fluid must be
re-checked at the proper fluid temperature.
2008 Milan(mln)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
281

Tire Pressure Monitoring
System (TPMS)
Tires, Wheels and Loading ....176
Tires ...........................161–162, 220
alignment ................................169
care ..........................................165
changing ..................................220
checking the pressure ............165
inflating ...................................163
label .........................................175
replacing ..................................167
rotating ....................................169
safety practices .......................168
sidewall information ...............170
snow tires and chains ............180
spare tire .................................220
terminology .............................162
tire grades ...............................162
treadwear ........................161, 166
Towing .......................................185
recreational towing .................185
trailer towing ..........................185
wrecker ....................................231
Traction control ........................194
Transaxle
fluid, checking and adding
(automatic) .............................278
fluid, checking and adding
(manual) .................................283
Transmission .............................196brake-shift interlock (BSI) ....196
fluid, refill capacities ..............287
lubricant specifications ..........287
manual operation ....................201
Trunk ...........................................99
remote release ..................91, 103
Turn signal ..................................56
U
USB port ......................................36
V
Vehicle Identification Number
(VIN) ..........................................291
Vehicle loading ..........................180
Ventilating your vehicle ...........190
W
Warning lights (see Lights) .......10
Washer fluid ..............................252
Water, Driving through .............210
Windows
power .........................................72
Windshield washer fluid and
wipers ..........................................68
checking and adding fluid .....252
replacing wiper blades ...........252
Wrecker towing .........................231
2008 Milan(mln)
Owners Guide (post-2002-fmt)
USA(fus)
Index
300