2008 MERCEDES-BENZ SL65AMG door lock

138 Controls in detail
Lighting
Switching on the hazard warning
flasher
Press hazard warning flasher
switch1.
All turn signals are flashing.
Switching off the hazard warning
flasher
Press hazard warning flasher switch1
again.
Interior lighting
The interior lighting controls are located in
the overhead control panel.
1Left reading lamp on/off
2Right reading lamp on/off
3Interior lighting on/off
4Slide switch for interior lighting controlDeactivating automatic control
Slide switch4 to the right.
The interior lighting and the entry/exit
lamps remain switched off in darkness,
even when you

unlock the vehicle

remove the SmartKey from the
starter switch

open a door

open the trunk
iWith the hazard warning flasher activated
and the combination switch set for either left
or right turn, only the respective left or right
turn signals will operate when the ignition is
switched on.
iIf the hazard warning flasher was activated
automatically, press hazard warning flasher
switch1 once to switch it off.
!An interior lamp switched on manually does
not go out automatically.
Leaving the interior lighting switch in the ON
position for extended periods of time with the
engine turned off could result in discharged
batteries.
iThe interior lighting is factory-set to
automatic mode.

139 Controls in detail
Lighting
Activating automatic control
Slide switch4 to the left.
The interior lighting switches on in
darkness when you

unlock the vehicle

remove the SmartKey from the
starter switch

open a door
In addition, the entry/exit lamps in
the doors come on.

open the trunk
The interior lighting switches off after
approximately 10 seconds, see
“Setting interior lighting delayed
switch-off” (
page 165).Manual control
Switching interior lighting on and off
Press switch3.
The interior lighting switches on.
Press switch3 once more.
The interior lighting switches off.
Switching reading lamps on and off
Press reading lamp switch1 or2 to
switch on the desired reading lamp.
Press reading lamp switch1 or2
again to switch off the respective
reading lamp.
Courtesy lighting
For better orientation in the dark, courtesy
lamps will illuminate the interior of your
vehicle as follows:
With parking lamps switched on:

the door handles

the driver and passenger footwells
With SmartKey in starter switch position1:

the door handles

the center console
Trunk lamp
The trunk lamp switches on when the trunk
is opened.
If the trunk lid remains open, the trunk
lighting switches off automatically after ap-
proximately 10 minutes.iIf a door remains open, the interior lighting
switches off automatically after approximately
5minutes.
iIf you turn the SmartKey in the starter
switch to position0 and switch off the head-
lamps, the door handle lamps will remain lit for
approximately 5 minutes.

140 Controls in detail
Instrument cluster
For a full view illustration of the instrument
cluster, see “Instrument cluster”
(
page 26).
1Reset button
The instrument cluster is activated when
you

open a door

switch on the ignition (page 40)

press reset button 1

switch on the exterior lamps
Opening a door will activate the instrument
cluster only for about 30 seconds.You can change the instrument cluster
settings in the Instrument cluster submenu
of the control system (
page 160).Adjusting instrument cluster
illumination
Use the reset button to adjust the illumina-
tion brightness for the instrument cluster
and the switches on the center console.
To brighten illumination
Turn reset button 1 in the instrument
cluster clockwise.
The instrument cluster illumination will
brighten.
To dim illumination
Turn reset button 1 in the instrument
cluster counterclockwise.
The instrument cluster illumination will
dim.
Warning!G
No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
As a result, you will not be able to see
information about your driving conditions,
such as speed or outside temperature,
warning/indicator lamps,
malfunction/warning messages or the
failure of any systems. Driving characteris-
tics may be impaired.
If you must continue to drive, do so with
added caution. Visit an authorized
Mercedes-Benz Center as soon as possible.iThe instrument cluster illumination is
dimmed or brightened to suit ambient light
conditions.

164 Controls in detail
Control system
Setting locator lighting
With the locator lighting feature activated
and the exterior lamp switch in
positionU, the following lamps will
switch on during darkness when the
vehicle is unlocked using button Πon
the SmartKey or SmartKey with
KEYLESS-GO*:

Parking lamps

Tail lamps

License plate lamps

Front fog lamps

Side marker lamps
The locator lighting switches off when the
driver’s door is opened.
If you do not open a door after unlocking
the vehicle with the SmartKey, the lamps
will switch off automatically after approxi-
mately 40 seconds.
Move the selection marker with
buttonæ or ç to the
Lighting
submenu.
Press button j or k repeatedly
until the message
Locator Lighting
appears in the multifunction display.
The selection marker is on the current
setting.
Press button æ or ç to switch
the locator lighting feature
On or Off.
Turn the exterior lamp switch to
position U when exiting the vehicle.
The locator lighting feature is
activated.Setting night security illumination
(Headlamps delayed switch-off feature)
Use this function to set whether you would
like the exterior lamps to remain on for
15 seconds during darkness after exiting
the vehicle and closing the doors.
With the headlamps delayed switch-off
feature activated and the exterior lamp
switch in position U before the engine
is turned off, the following lamps will
switch on when the engine is turned off:

Parking lamps

Tail lamps

License plate lamps

Side marker lamps

Front fog lamps
If after turning off the engine you do not
open a door or do not close an opened
door, the lamps will switch off auto-
matically after 60 seconds.

166 Controls in detail
Control system
Vehicle submenu
Access the
Vehicle submenu via the
Settings menu. Use the Vehicle submenu
to make general vehicle settings. The
following functions are available:
Setting automatic locking
Use this function to activate or deactivate
the automatic central locking. With the
automatic central locking system
activated, the vehicle is centrally locked at
a vehicle speed of approximately
9mph(15km/h).
Move the selection marker with
theæ or ç button to the
Vehicle submenu.
Press button j or k repeatedly
until the message
Automatic Door
Lock
appears in the multifunction
display.
The selection marker is on the current
setting.
Press button æ or ç to switch
the
Automatic Door Lock function
Onor Off.Convenience submenu
Access the
Convenience submenu via the
Settings menu. Use the Convenience sub-
menu to change the settings for a number
of convenience features. The following
functions are available:
Activating easy-entry/exit feature
Use this function to activate and deacti-
vate the easy-entry/exit feature
(
page 47).
FunctionPage
Setting automatic locking166FunctionPage
Activating easy-entry/exit
feature166

167 Controls in detail
Control system
Move the selection marker with
theæ orç button to the

Convenience
submenu.
Press button j or k repeatedly
until the message
Easy-entry
Function
appears in the multifunction
display.
The selection marker is on the current
setting.
Press button æ or ç to switch
the easy-entry/exit feature
On or Off.
Trip computer menu
Use the trip computer menu to call up
statistical data on your vehicle.
The following information is available:
Warning!G
You must make sure no one can become
trapped or injured by the moving steering
wheel when the easy-entry/exit feature is
activated.
To stop steering wheel movement, do one of
the following:

Move steering wheel adjustment stalk
(
page 47).

Press one of the memory position
buttons* or the memory button M*
(
page 129).
Do not leave children unattended in the ve-
hicle, or with access to an unlocked vehicle.
Children could open the driver’s door and
unintentionally activate the easy-entry/exit
feature, which could result in an accident
and/or serious personal injury.
FunctionPage
Fuel consumption statistics
since start168
Fuel consumption statistics
since last reset168
Resetting fuel consumption
statistics168
Distance to empty169
iThe last function called up will reappear the
next time you enter the trip computer menu.

201 Controls in detail
Power windows
Power windows
Opening and closing the windows
The windows are opened and closed elec-
trically. The switches for all the windows
are on the driver’s door. The switch for the
passenger side windows is on the passen-
ger door.
1Left door and rear side windows
2Right door and rear side windows
Switch on the ignition (page 40).
Warning!G
When closing the windows, make sure that
there is no danger of anyone being injured
by the closing procedure.
The closing of the door windows can be im-
mediately halted by releasing the switch or,
if the switch was pulled past the resistance
point and released, by either pressing or
pulling the respective switch.
The closing of the rear side windows can be
immediately halted by releasing the switch.
If a door window encounters an obstruction
that blocks its path in a circumstance where
you pulled the switch past the resistance
point and released it to close the door win-
dow, the automatic reversal function will
stop the door window and open it slightly.
If the door window encounters an obstruc-
tion that blocks its path in a circumstance
where you are closing the door window by
pulling and holding the switch, by pressing
and holding button ‹on the SmartKey,
by pressing and holding the lock button
(vehicles with KEYLESS-GO*) on an outside
door handle, by pressing and holding the re-
tractable hardtop switch, or by pressing and holding button,on the automatic
climate control panel, the automatic
reversal function will not operate.
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle. Do not leave children
unattended in the vehicle, or with access to
an unlocked vehicle. A child’s unsupervised
access to a vehicle could result in an
accident and/or serious personal injury.
iDepending on the current position, the win-
dows may also open or close when the air recir-
culation button, on the control panel of the
automatic climate control (
page 196) is
pressed and held.
iAfter switching off the ignition (page 40)
or removing the SmartKey from the starter
switch, the windows can be operated

until you open a door

for at least 5 minutes if no door was opened

202 Controls in detail
Power windows
Opening the door windows
Press switch1 or2 to the resistance
point.
The corresponding door window will
move downwards until you release the
switch.
Opening the rear side windows when
the hardtop is closed:
Open the door window.
Press switch1 or 2 to the resistance
point again.
The corresponding rear side window
will open completely.Closing the door windows
Pull switch1 or2 to the resistance
point.
The corresponding door window will
move upwards until you release the
switch.
Closing the rear side windows if the
hardtop is closed:
Close the door window.
Pull and hold switch1 or 2.
The corresponding rear side window
will move upwards until you release the
switch. Fully opening the door windows
(Express-open)
Press switch1 or2 past the resis-
tance point and release.
The corresponding door window opens
completely.
iIf the hardtop is open, the respective rear
side window will also open automatically.
Warning!G
If you pull and hold the switch up when clos-
ing the door window, and upward movement
of the door window is blocked by some ob-
struction including but not limited to arms,
hands, fingers, etc., the automatic reversal
will not operate.
iIf the hardtop is open, the respective rear
side window will also open automatically.