2008 MERCEDES-BENZ SL55AMG ESP

376 Practical hints
What to do if …
Symbol messages
Left displayRight displayPossible cause/consequencePossible solution
# The battery is no longer charging.
Possible causes:

alternator malfunctioning

broken poly-V-belt
Do not forget that the brake system
requires electrical energy and may
be operating with restricted capa-
bility. Considerably greater brake
pedal force is required and the stop-
ping distance is increased.
Stop the vehicle immediately in a safe loca-
tion and check the poly-V-belt.
If it is broken:
Do not continue to drive. Otherwise, the
engine will overheat due to an inoperative
water pump which may result in damage
to the engine. Contact an authorized
Mercedes-Benz Center.
If it is in order:
Contact an authorized Mercedes-Benz
Center immediately. Adjust driving to be
consistent with reduced braking respon-
siveness.
There is a malfunction in the elec-
tronic system.Have the system checked at an authorized
Mercedes-Benz Center as soon as possible.

377 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
# Battery/
Alternator
Stop CarThe battery is malfunctioning.
The electro-hydraulic brake system
requires electrical energy and
therefore has only limited opera-
tion. Considerably greater brake
pedal force is required and the stop-
ping distance is increased.Stop the vehicle in a safe location.
Adjust driving to be consistent with reduced
braking responsiveness.
Contact an authorized Mercedes-Benz
Center.
USA only:
;
Canada only:
3
Reduced
Brake Effect
Start EngineThe battery has insufficient voltage
and cannot supply sufficient power
to the electro-hydraulic brake sys-
tem.Start the engine.
The message disappears when sufficient
voltage is available.
Warning!G
Inhalation of exhaust gas is hazardous to
your health. All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause
unconsciousness and lead to death. Do not
run the engine in confined areas (such as a
garage) which are not properly ventilated.

388 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
NEngine Oil Level
Stop car,
switch engine off.There is no oil in the engine. There
is a danger of engine damage.Stop the vehicle in a safe location or as soon
as it is safe to do so.
Turn off the engine.
Add engine oil (page 286) and check the
engine oil level (
page 284).
Engine Oil Level
Reduce Oil LevelVehicles with engine oil measuring
system only:
You have added too much engine
oil. There is a risk of damaging the
engine or the catalytic converter.Have excess oil siphoned or drained off.
Observe all legal requirements with respect
to its disposal.
Engine Oil Level
Cannot
measure
eng. oil level.Vehicles with engine oil measuring
system only:
The measuring system is malfunc-
tioning.Have the measuring system checked by an
authorized Mercedes-Benz Center.
Engine Oil Level
Check LevelVehicles with oil dipstick only:
The engine oil has dropped to a crit-
ical level.Check the engine oil level (page 284) and
add oil as required (
page 286).
If you must add engine oil frequently, have the
engine checked for possible leaks.

397 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
HPlease correct
the tire pressure.The tire inflation pressure is too
low in one or more tires.Check and correct tire inflation pressure as required
(
page 302).
Tire Pressure
Caution
Tire DefectOne or more tires are deflating.Carefully bring the vehicle to a halt, avoiding abrupt
steering and braking maneuvers.
If necessary, change the wheel (page 417).
Caution
Tire defectOne or more tires are deflating.
Vehicles with Advanced TPMS*:
The respective tire is indicated in
the multifunction display.Carefully bring the vehicle to a halt, avoiding abrupt
steering and braking maneuvers.
If necessary, change the wheel (page 417).
Warning!G
Do not drive with a flat tire. A flat tire affects
the ability to steer or brake the vehicle. You
may lose control of the vehicle. Continued
driving with a flat tire will cause excessive
heat build-up and possibly a fire.
Warning!G
Follow recommended tire inflation
pressures.
Do not underinflate tires. Underinflated tires
wear excessively and/or unevenly,
adversely affect handling and fuel economy,
and are more likely to fail from being over-
heated.
Do not overinflate tires. Overinflated tires
can adversely affect handling and ride
comfort, wear unevenly, increase stopping
distance, and result in sudden deflation
(blowout) because they are more likely to
become punctured or damaged by road
debris, potholes etc.

398 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
HTire Pressure
Check TiresThe tire pressure in one or more
tires is already below the mini-
mum value.Carefully bring the vehicle to a halt, avoiding abrupt
steering and braking maneuvers.
Check and adjust tire pressure as required.
If necessary, change the wheel.
Check TiresThe tire pressure in one or more
tires is already below the mini-
mum value.
Vehicles with Advanced TPMS*:
The respective tire is indicated in
the multifunction display.Carefully bring the vehicle to a halt, avoiding abrupt
steering and braking maneuvers.
Check and adjust tire pressure as required.
If necessary, change the wheel (page 417).
Warning!G
Do not drive with a flat tire. A flat tire affects
the ability to steer or brake the vehicle. You
may lose control of the vehicle. Continued
driving with a flat tire will cause excessive
heat build-up and possibly a fire.
Warning!G
Follow recommended tire inflation
pressures.
Do not underinflate tires. Underinflated tires
wear excessively and/or unevenly,
adversely affect handling and fuel economy,
and are more likely to fail from being over-
heated.
Do not overinflate tires. Overinflated tires
can adversely affect handling and ride
comfort, wear unevenly, increase stopping
distance, and result in sudden deflation
(blowout) because they are more likely to
become punctured or damaged by road
debris, potholes etc.

417 Practical hints
Flat tire
Flat tire
Preparing the vehicle
Park the vehicle in a safe distance from
moving traffic on a hard, flat surface
when possible.
Turn on the hazard warning flashers.
Turn the steering wheel so that the
front wheels are in a straight ahead
position.
Set the parking brake (page 63).
Move the gear selector lever to
position P.
Turn off the engine (page 64).
Have any passenger exit the vehicle at
a safe distance from the roadway.
Vehicles with Smartkey: Remove the
SmartKey from the starter switch.
Vehicles with KEYLESS-GO*: Open the
driver’s door (this puts the starter
switch in position 0, same as with the
SmartKey removed from the starter
switch). The driver’s door then can be
closed again.Mounting the spare wheel
iOpen door only when conditions are safe to
do so.
Warning!G
The dimensions of the spare wheel are dif-
ferent from those of the road wheels. As a
result, the vehicle handling characteristics
change when driving with a mounted spare
wheel. Adapt your driving style accordingly.
The spare wheel is for temporary use only.
When driving with spare wheel mounted, en-
sure proper tire inflation pressure and do
not exceed vehicle speed of 50 mph
(80 km/h).
Drive to the nearest Mercedes-Benz Center
as soon as possible to have the spare wheel
replaced with a regular road wheel.
Never operate the vehicle with more than
one spare wheel mounted.
Do not switch off the ESP
® when a spare
wheel is mounted.

419 Practical hints
Flat tire
Take the vehicle tool kit and the jack
out of the storage compartment under
the trunk floor (
page 400).
On wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with
wrench).
The jack support tubes are located behind
the front wheel housings and in front of the
rear wheel housings.
Warning!G
The jack is designed exclusively for jacking
up the vehicle at the jack tubes built into
both sides of the vehicle. To help avoid
personal injury, use the jack only to lift the
vehicle during a wheel change. Never get
beneath the vehicle while it is supported by
the jack. Keep hands and feet away from the
area under the lifted vehicle. Always firmly
set parking brake and block wheels before
raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use,
especially on hills. Always try to use the jack
on level surface. Be sure that the jack arm is
fully inserted in the jack tube. Always lower
the vehicle onto sufficient capacity jack-
stands before working under the vehicle.
Warning!G
When turning the wheel wrench to loosen
the wheel bolts, make sure you position
hands on the wrench in such a way that you
avoid injury to yourself, such as scraping
your hands against the wheel. Make sure
turning the wheel wrench will not scratch or
damage the wheel rim.


423 Practical hints
Flat tire
Insert electrical plug 3 into vehicle
cigarette lighter socket (
page 244)
or the power outlet in the trunk
(
page 246).
Turn the SmartKey in the starter switch
to position1.
or
Press the KEYLESS-GO* start/stop
button on the gear selector lever once
without depressing the brake pedal.
PressI on the electric air pump
switch2.
The electric air pump should now
switch on and inflate the tire.
Inflate the spare tire:

SL 550 to 36 psi (2.5 bar)

SL 600, SL 55 AMG, SL 55 AMG
(Performance Package*), and
SL 65 AMG to 51 psi (3.5 bar)
This takes about 5 minutes.
Air hose4 and union nut5 can be-
come hot during inflation. Exercise
proper caution to avoid burning your-
self when using the equipment.
Press0 on the electric air pump
switch2.
Turn the SmartKey in the starter switch
to position0.
or
Press KEYLESS-GO* start/stop button
on the gear selector lever twice without
depressing the brake pedal.
The electric air pump should now be
switched off.
If the spare tire inflation pressure is
above the recommended tire inflation
pressure for the respective collapsible
tire (
page 453), release excess spare
tire inflation pressure using the vent
screw.
!Compare the recommended tire inflation
pressure for your vehicle with the tire inflation
pressure on the yellow label located on the spare
wheel rim.
If the tire inflation pressure on the yellow label
on the spare wheel rim differs from the values
given in this Operator’s Manual, inflate the tire to
the recommended tire inflation pressure given
on the yellow label on the spare wheel rim.
!Do not operate the electric air pump longer
than 8 minutes without interruption. Otherwise it
may overheat.
You may operate the air pump again after it has
cooled off.