2008 MERCEDES-BENZ SL550 towing

341 Practical hints
What to do if …
Where will I find ...?
Locking/unlocking in an
emergency
Replacing SmartKey batteries
Replacing bulbs
Replacing wiper blades
Flat tire
Batteries
Jump starting
Towing the vehicle
Fuses

378 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
TReduced
Brake Effect
Depress brake
pedal fully.The electro-hydraulic brake system
is in emergency operation mode.
Considerably greater brake pedal
force is required and the brake
pedal travel is longer. The stopping
distance is increased.
The maximum speed is limited to
55 mph (90 km/h).Stop the vehicle in a safe location or as soon
as it is safe to do so.
Apply the parking brake (page 63).
Do not drive any further.
Prevent the vehicle from rolling away by
blocking the wheels with wheel chocks or
other sizeable objects.
Contact an authorized Mercedes-Benz Center
or call for Roadside Assistance (
page 253).
Warning!G
Driving while this message is displayed can
result in an accident. Have your brake
system checked immediately.
If the electro-hydraulic brake system enters
its emergency operation mode, the driver
must apply significantly greater brake pedal
pressure and depress the pedal much
further than normal to obtain braking effect.
If necessary, apply full pressure to the brake
pedal. Brakes are only applied to the front
wheels. Stopping distance is increased!
If there is a malfunction in the
electro-hydraulic brake system, we recom-
mend that the vehicle be transported with
all wheels off the ground using flatbed or ap-
propriate wheel lift/dolly equipment.A tow bar must be used if circumstances do
not permit the use of the recommended
towing methods and the vehicle requires
towing with all four wheels on the ground.
Towing the vehicle with all four wheels on
the ground is only permissible for distances
up to 30 miles (50 km) and at a speed not to
exceed 30 mph (50 km/h). For more infor-
mation, see “Towing the vehicle”
(
page 434).

379 Practical hints
What to do if …
Left displayRight displayPossible cause/consequencePossible solution
USA only:
;
Canada only:
3
Reduced
Brake Effect
Service
RequiredThe electro-hydraulic brake system
is in emergency operation mode.
Considerably greater brake pedal
force is required and the brake
pedal travel is longer. The stopping
distance is increased.Stop the vehicle in a safe location or as soon
as it is safe to do so.
Apply the parking brake (page 63).
Do not drive any further.
Prevent the vehicle from rolling away by
blocking the wheels with wheel chocks or
other sizeable objects.
Contact an authorized Mercedes-Benz Center
or call for Roadside Assistance (
page 253).
Warning!G
Driving while this message is displayed can
result in an accident. Have your brake
system checked immediately.
If the electro-hydraulic brake system enters
its emergency operation mode, the driver
must apply significantly greater brake pedal
pressure and depress the pedal much
further than normal to obtain braking effect.
If necessary, apply full pressure to the brake
pedal. Brakes are only applied to the front
wheels. Stopping distance is increased!
If there is a malfunction in the
electro-hydraulic brake system, we recom-
mend that the vehicle be transported with
all wheels off the ground using flatbed or ap-
propriate wheel lift/dolly equipment.A tow bar must be used if circumstances do
not permit the use of the recommended
towing methods and the vehicle requires
towing with all four wheels on the ground.
Towing the vehicle with all four wheels on
the ground is only permissible for distances
up to 30 miles (50 km) and at a speed not to
exceed 30 mph (50 km/h). For more infor-
mation, see “Towing the vehicle”
(
page 434).

400 Practical hints
Where will I find ...?
First aid kit
The first aid kit is located in storage com-
partment under the passenger seat.
1Handle
2Lid
Pull handle 1 up.
Fold lid 2 down.
You can now remove the first aid kit.
Vehicle tool kit, jack, and spare wheel
The vehicle tool kit, jack, and spare wheel
are stored in the space underneath the
trunk floor.
Lift up the trunk floor cover.
You can now remove the tools and
accessories.
The vehicle tool kit includes

One pair of universal pliers

Two open-end wrenches

One hex-socket wrench

One interchangeable slot/Phillips
screwdriver

One towing eye bolt

One alignment bolt

One fuse chartiCheck expiration dates and contents for
completeness at least once a year and replace
missing/expired items.
Warning!G
The jack is designed exclusively for jacking
up the vehicle at the jack tubes built into
both sides of the vehicle. To help avoid per-
sonal injury, use the jack only to lift the ve-
hicle during a wheel change. Never get
beneath the vehicle while it is supported by
the jack. Keep hands and feet away from the
area under the lifted vehicle. Always firmly
set parking brake and block wheels before
raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack
on a hard level surface. Be sure that the jack
arm is fully inserted in the jack tube. Always
lower the vehicle onto sufficient capacity
jackstands before working under the vehi-
cle.

434 Practical hints
Towing the vehicle
Mercedes-Benz recommends that the vehi-
cle be transported with all wheels off the
ground using flatbed or appropriate wheel
lift/dolly equipment.
When circumstances do not permit the
recommended towing methods, the
vehicle may be towed with all wheels on
the ground or front wheels raised only so
far as necessary to have the vehicle moved
to a safe location where the recommended
towing methods can be employed.
!Do not tow-start the vehicle.
!Use flatbed or wheel lift/dolly equipment
with SmartKey in starter switch turned to
position0.
Do not tow with sling-type equipment. Towing
with sling-type equipment over bumpy roads will
damage radiator and supports.
To prevent damage during transport, do not tie
down vehicle by its chassis or suspension parts.
Switch off the tow-away alarm (
page 100) and
the automatic central locking (
page 166).
Warning!G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if:

the engine will not run

there is a malfunction in the
electro-hydraulic brake system

there is a malfunction in the power sup-
ply or in the vehicle’s electrical system
This is necessary to adequately control the
towed vehicle.
Prior to towing the vehicle with all wheels on
the ground, make certain that the SmartKey
is in starter switch position2.
Warning!G
The brake system requires electrical power
to operate.
A malfunction in the vehicle’s power supply
or electrical system may impair brake sys-
tem operation and switch it into its emer-
gency operation mode. To brake, the driver
must then apply significantly greater brake
pedal pressure and depress the pedal much
further to obtain the expected braking ef-
fect. If necessary, apply full pressure to the
brake pedal. Brakes are only applied to the
front wheels. Stopping distance is
increased! Adapt your driving style
accordingly. For more information, see
“Electro-hydraulic brake system”
(
page 94).
With the engine not running, there is no
power assistance for the brake and steering
systems. In this case, it is important to keep
in mind that a considerably higher degree of
effort is necessary to brake and steer the ve-
hicle. Adapt your driving accordingly.

435 Practical hints
Towing the vehicle
!If the vehicle is towed with the front axle
raised, the gear selector lever must be in
positionN and the engine must be shut off
(SmartKey in starter switch position0 or1).
Active braking action through the ESP
® may
otherwise seriously damage the brake system.
When towing the vehicle with all wheels on the
ground, the gear selector lever must be in
positionN and the SmartKey must be in starter
switch position2.
When towing the vehicle with all wheels on the
ground or the front axle raised, the vehicle
may be towed only for distances up to
30 miles (50 km) and at a speed not to exceed
30 mph (50 km/h).
!Towing of the vehicle should only be done
using the properly installed towing eye bolt.
Never attach a tow cable, tow rope or tow rod to
the vehicle chassis, frame or suspension parts.
iWhen towing the vehicle with all wheels on
the ground, please note the following:
With the automatic central locking activated and
the SmartKey in starter switch position2, or
KEYLESS-GO* start/stop button in position2,
the vehicle doors lock if the left front wheel as
well as the right rear wheel are turning at vehicle
speeds of approximately 9 mph (15 km/h) or
more.
To prevent the vehicle door locks from locking,
deactivate the automatic central locking
(
page 122).
iTo signal turns while being towed with the
hazard warning flasher in use, turn SmartKey in
starter switch to position2 and activate the
combination switch for the left or right turn
signal in the usual manner – only the selected
turn signal will operate.
Upon canceling the turn signal, the hazard warn-
ing flasher will operate again.
iIf the battery is disconnected or discharged

the SmartKey will not turn in the starter
switch

the gear selector lever will remain locked in
positionP.
For more information, see “Batteries”
(
page 427) and “Jump starting” (page 432).

436 Practical hints
Towing the vehicle
Installing towing eye bolt
Front
Example illustration (SL 550 and SL 600
without Sport Package)
1Cover on passenger side of front
bumper
To remove cover:
Press mark on cover 1 in direction of
arrow.
Lift cover1off to reveal the threaded
hole for towing eye bolt.To reinstall cover:
Fit locking tabs of cover under the
lower edge of the opening in the
bumper.
Apply even pressure on the upper part
of the cover until it snaps into place.
Rear
1Cover on passenger side of rear
bumper
To remove cover:
Insert flat, blunt object as a lever into
upper left or right recess of cover 1.
Loosen cover 1 using the lever.
Fold cover 1 down in direction of
arrow to reveal the threaded hole for
the towing eye bolt.
To reinstall cover:
Fit cover 1 and snap into place.
Installing towing eye bolt
Take the towing eye bolt and the wheel
wrench from the vehicle tool kit
(
page 400).
Screw towing eye bolt into threaded
hole to its stop.
Insert wheel wrench into towing eye
and tighten towing eye bolt by turning
it clockwise.
Removing towing eye bolt
Take the wheel wrench from the
vehicle tool kit (
page 400).
Insert wheel wrench into towing eye
and loosen towing eye bolt by turning it
counterclockwise.
Remove towing eye bolt.

484 Index
Tools 400
Total load limit 325
Tow-away alarm 100
Switch 32
Towing eye bolt 400
Installing 436
Towing the vehicle 434
TPMS (USA only) 305
Traction 93, 325
Transmission see Automatic transmission
Tread 325
Tread depth 293
Treadwear indicators 325
Trip computer 167
Trip odometer
Resetting 141
Trunk
Closing the lid 116
Lighting 139
Load assist 245
Messages in the multifunction
display 399Opening from inside vehicle 114
Opening/closing
system* 116, 117, 118
Parcel net 242
Power closing assist for trunk lid 121
Unlocking 114
Unlocking (KEYLESS-GO*) 114
Unlocking in an emergency 404
Unlocking separately 114
Valet locking 120
Trunk lid
Opening 115
Turn signal lamps
Cleaning lenses 336
Replacing bulbs 410, 413
Turn signals 25, 57
Exterior rear view mirrors 410, 413
Front bulbs 410
Indicator lamps 27
Rear bulbs 410
Turning off the engine 64U
Uniform Tire Quality Grading
Standards 325
Units
Setting speedometer units 160
Unlocking the vehicle 38
In an emergency 403
Upholstery
Cleaning 340
Useful features
Floormat* 247
V
Vehicle
Locking 31
Locking in an emergency 405
Minimum distance (Parktronic*) 235
Towing 434
Unlocking 31
Unlocking in an emergency 403