Page 732 of 761

731 Technical data
Fuels, coolants, lubricants, etc.
The coolant solution must be used year
round to provide the necessary corrosion
protection and increase boil-over protec-
tion. Refer to Maintenance Booklet for re-
placement interval.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze solu-
tion or other Mercedes-Benz approved
products of equal specification are used to
renew the coolant concentration or bring it
back up to the proper level.
For information on other Mercedes-Benz
approved products of equal specification,
refer to the Factory Approved Service
Products pamphlet (USA only) or contact
an authorized Mercedes-Benz Center.
To provide important corrosion protection,
the solution must be at least 50% anticor-
rosion/antifreeze (equivalent to freeze
protection to approximately –35°F
[–37°C]).If you use a solution that is more than 55%
anticorrosion/antifreeze (freeze protec-
tion to approximately –49°F [–45°C]), the
engine temperature will increase due to
the lower heat transfer capability of the so-
lution. Therefore, do not use more than
this amount of anticorrosion/ antifreeze.
If the coolant level is low, water and
MB 325.0 Anticorrosion/Antifreeze
should be used to bring it up to the proper
level (have cooling system checked for
signs of leakage).
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality, con-
sult an authorized Mercedes-Benz Center.Anticorrosion/antifreeze
Your vehicle contains a number of alumi-
num parts. The use of aluminum compo-
nents in motor vehicle engines
necessitates that anticorrosion/antifreeze
coolant used in such engines be specifical-
ly formulated to protect the aluminum
parts. Failure to use such anticorrosion/
antifreeze coolant will result in a signifi-
cantly shortened service life.
Therefore, the following product is strongly
recommended for use in your vehicle:
Mercedes-Benz 325.0 Anticorrosion/
Antifreeze agent.
Before the start of the winter season (or
once a year in hot southern regions), you
should have the anticorrosion/antifreeze
concentration checked. The coolant is also
regularly checked each time you bring your
vehicle to an authorized Mercedes-Benz
Center for service.
Page 733 of 761
732 Technical data
Fuels, coolants, lubricants, etc.
Anticorrosion/antifreeze quantity
ModelApproximate freeze protection
– 35°F (– 37°C)– 49°F (– 45°C)
S 550
S 550 4MATICVehicles without rear passenger
compartment climate control*6.08 US qt. (5.75 l)6.71 US qt. (6.35 l)
Vehicles with rear passenger com-
partment climate control*6.97 US qt. (6.60 l)7.66 US qt. (7.25 l)
S 600 (main cooling system)7.34 US qt. (6.95 l)8.08 US qt. (7.65 l)
S 600 (low temperature cooling system)1.37 US qt. (1.3 l)1.51 US qt. (1.43 l)
S 63 AMG6.0 US qt. (5.6 l)7.0 US qt. (6.16 l)
S 65 AMG (main cooling system)7.4 US qt. (7.0 l)8.14 US qt. (7.7 l)
S 65 AMG (low temperature cooling system)1.64 US qt. (1.55 l)1.81 US qt. (1.71 l)
Page 734 of 761

733 Technical data
Fuels, coolants, lubricants, etc.
Windshield washer system and
headlamp cleaning system
Both the windshield washer system and
headlamp cleaning systems are supplied
from the windshield washer reservoir.
The windshield washer reservoir has a ca-
pacity of approximately 6.87 US qt (6.5 l).
Refill the reservoir with MB Windshield
Washer Concentrate and water (or con-
centrate and commercially available
premixed windshield washer solvent/
antifreeze, depending on ambient tem-
peratures).Windshield and headlamp washer fluid
mixing ratio
For temperatures above freezing point, use
MB Windshield Washer Concentrate
“MB SummerFit” and water:
1 part “MB SummerFit” to 100 parts
water
(1.34 fl oz [40 ml] “MB SummerFit” to
1 gal [4.0 l] water).
For temperatures below freezing point, use
MB Windshield Washer Concentrate
“MB SummerFit” and commercially avail-
able premixed windshield washer sol-
vent/antifreeze:
1 part “MB SummerFit” to 100 parts
solvent
(1.34 fl oz [40 ml] “MB SummerFit” to
1 gal [4.0 l] solvent).Warning!G
Washer solvent/antifreeze is highly flamma-
ble. Do not spill washer solvent/antifreeze
on hot engine parts, because it may ignite
and burn. You could be seriously burned.
Page 742 of 761

741 Index
Dynamic Rear View Monitor* 453
Camera lens 590
Cleaning camera lens 590
Parallel parking 458
Reverse parking
(back-in parking) 456
Switching on 456
View through the camera 454
E
Easy-entry/exit feature 357
COMAND menu 246
EBP 71
Electrical fuses see Fuses
Electrical outlet see Power outlet
Electrical system, Technical Data 722
Electronic Brake Proportioning see EBP
Electronic parking brake 395
Indicator lamp 29, 600
Mechanically releasing 673
Messages in display 633
Warning lamp 29, 600
Electronic Stability Program see ESP
®
Electronic traction system 72
Emergency call system 510
Emergency calls, Tele Aid 511
Emergency engine shut-down 707
Emergency operation
(limp-home mode) 416
Emergency operations
Locking the vehicle 671
Mechanically releasing the electronic
parking brake 673
Releasing from inside 484
Remote door lock 517
Remote door unlock 517
Tilt/sliding sunroof or tilt/sliding
panel* 674
Unlocking the trunk 672
Unlocking the vehicle 671
Emergency tensioning device see ETDEmergency, In case of
Battery, Jump starting 697
First aid kit 668
Flat tire 686
Fuses 704
Roadside Assistance 16
Roadside Assistance (Tele Aid) 513
Towing the vehicle 700
Emission control 536
Emission control information label 713
Emission control system warranties 14
Engine
Belt layout 714
Cleaning 587
Compartment 541
Coolant 547, 726, 730
Malfunction indicator lamp 29, 602
Number 712, 713
Oil 546, 724, 728
Oils 543
Residual heat and ventilation 476
Starting 389
Technical data 715
Turning off 397