2008 MERCEDES-BENZ S600 warning lights

680 Practical hints
Replacing bulbs
Notes on bulb replacement
Only use 12-volt-bulbs of the same
type and with the specified watt rating.

Switch lights off before changing a bulb
to prevent short circuits.

Always use a clean lint-free cloth when
handling bulbs.

Your hands should be dry and free of oil
and grease.

If the newly installed bulb does not
come on, contact an authorized
Mercedes-Benz Center.
Have the LEDs and bulbs for the following
lamps replaced by an authorized
Mercedes-Benz Center:

the Bi-Xenon lamps

the front turn signal lamps

the front fog lamps

the additional turn signal lamps in the
exterior rear view mirrors

the parking and standing lamps

the front side marker lamps

the high mounted brake lamps

the brake, tail and rear standing lamps

the rear side marker lamps

the rear fog lamp

the rear turn signal lamps

the rear side marker lamps

the license plate lamps
Replacing bulbs for front lamps
Before you start to replace a bulb for a
front lamp, do the following first:
Turn the exterior lamp switch to M
(
page 371).
Open the hood (page 541).
Warning!G
Bulbs and bulb sockets can be very hot. Al-
low the lamp to cool down before changing
a bulb.
Keep bulbs out of reach of children.
Halogen lamps contain pressurized gas. A
bulb can explode if you:

touch or move it when hot

drop the bulb

scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the
lamp and its components. We recommend
that you have such work done by a qualified
technician.
!Do not replace the LEDs yourself. You could
otherwise damage the LEDs or parts of the vehi-
cle. Only have the LEDs replaced by an autho-
rized Mercedes-Benz Center.
iHave the headlamp adjustment checked
regularly.

698 Practical hints
Jump starting
Jump starting should only be performed on
the starter battery. The starter battery is
located in the engine compartment on the
passenger side (
page 694).
Make sure the two vehicles do not
touch.
Secure vehicle in place with electronic
parking brake (
page 395).
Shift the automatic transmission toP
(
page 399).
Turn off all electrical consumers, ex-
cept hazard warning flashers or work
lights.
Open the hood (page 541).
Start the engine of the vehicle with the
charged battery and run at idle speed.1Positive terminal of your vehicle’s
battery
2Positive terminal of other vehicle’s
battery
3Negative terminal of other vehicle’s
battery
4Negative clamp
Warning!G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(
page 692).
iVehicles with KEYLESS-GO*: remove the
KEYLESS-GO button (
page 345) and use the
SmartKey with KEYLESS-GO like a normal
SmartKey.

740 Index
Setting the current speed 433
Setting to last stored speed
(“Resume” function) 435
Warning and indicator lamps 427
Document holder 502
Door
Control panel 34, 35, 38
Entry lamps 379
Inside door handle 341
Locking 334, 339
Locking with Tele Aid 517
Messages in display 617, 648
Opening from inside vehicle 341
Opening from outside 333, 338
Power closing assist 342
Unlocking 333, 338
Unlocking with Tele Aid 517
DOT 576
Downhill driving
Cruise control 421
Drink holder see Cup holder
Drinking and driving 527
Drive-dynamic multicontour seats*, front
Adjusting (COMAND) 262Driving 389
Abroad 535
Hydroplaning 531
In winter 533
Instructions 389, 527
Problems 393
Safety systems 66
Through standing water 534
With DISTRONIC Plus* 437
Driving maneuver (COMAND) 207
Driving off 530
Driving safety systems
4MATIC 75
ABS 66
Adaptive Brake Lights (S 600 and USA
only) 68
BAS 68
BAS Plus 69
EBP 71
Electronic traction system 72
ESP
®71Driving systems 419
ABC* 442
Airmatic 440
Cruise control 419
DISTRONIC Plus* 424
Driving safety systems 66
Dynamic Rear View Monitor* 453
Park Assist* 448
Parktronic system* 444
Vehicle level control (ABC*) 443
Vehicle level control (Airmatic) 441
Driving tips 406
Kickdown 406
DVD 112
Audio (COMAND) 112
Changer (COMAND) 116
Changer (Voice Control*) 313
Ejecting (COMAND) 117
Loading (COMAND) 115
Playback options (COMAND) 123
Selecting a medium (COMAND) 121
Selecting a track (COMAND) 122
Setting the audio format
(COMAND) 123
Video (COMAND) 124