2008 MERCEDES-BENZ S550 4MATIC warning

441 Controls in detail
Driving systems
Vehicle level control with Airmatic
Your vehicle automatically adjusts its ride
height to:

increase vehicle safety

reduce fuel consumption
The vehicle chassis ride height is raised or
lowered according to the selected level
setting and to the vehicle speed:

With increasing speed, ride height is re-
duced by up to approximately 0.8 in
(20 mm).

With decreasing speed, the ride height
is again raised to the selected vehicle
level.The following vehicle level settings can be
selected when the vehicle is stationary:
Select the “Raised” level setting only when
required by current driving conditions.
Otherwise:

Fuel consumption may increase.

Handling may be impaired.1Vehicle level control switch
2Indicator lamp
Start the engine.
Briefly press switch1 to change from
one level setting to the other.
The message:
“Vehicle rising”
appears in the multifunction display
when changing from normal level to
raised level.
The indicator lamp2 is then lit. The
display switches off when the vehicle is
raised.
Warning!G
To help avoid personal injury, keep hands
and feet away from wheel housing area, and
stay away from under the vehicle when low-
ering the vehicle chassis.
iThese height adjustments are so small that
you may not notice any change.
Level
NormalFor driving on normal roads.
The indicator lamp is off.
RaisedFor driving on rough roads or
with snow chains. The indica-
tor lamp is on.


442 Controls in detail
Driving systems
Press switch1 again to lower the ve-
hicle. The indicator lamp2 is off.Suspension tuning
The Adaptive Damping System (ADS) auto-
matically tunes shock absorbers and
springs.
The suspension tuning is set according to:

your driving style

road surface conditions

the vehicle loading

your choice of suspension style
The program mode selector switch (C/S)
(
page 409) is used to adjust the suspen-
sion tuning:
Start the engine.
Select the desired driving program.
Active Body Control (ABC)*
The ABC system is an active, comput-
er-controlled system that hydraulically ad-
justs the suspension at all four wheels in
response to various driving situations. It
automatically selects the optimum suspen-
sion tuning and ride height for your vehicle.
iThe selected vehicle level setting remains
stored in memory even if the engine is turned off
and restarted except when you

exceed a speed of 75 mph (120 km/h)
or

maintain a speed of between 50 mph
(80 km/h) and 75 mph (120 km/h) for more
than 3 minutes
The vehicle then lowers to regular level.
Driving programSuspension tuning
CComfortcomfortable
(default setting)
SSportsporty
for dynamic driving
Warning!G
S63AMG and S65AMG only:
When you switch off the engine, the entire
vehicle is lowered. You should therefore
make sure that no one is near the wheel
housing or under the vehicle when you
switch off the engine. Otherwise, parts of
the individuals body could be trapped.
!S63AMG and S65AMG only:
When you switch off the engine, the entire vehi-
cle is lowered. When parking, position your vehi-
cle in such a way that it will not scrape against a
curb, for example, when it is lowered. Your vehi-
cle could otherwise be damaged.


443 Controls in detail
Driving systems
Vehicle level control with ABC
Your vehicle automatically adjusts its ride
height to:

increase vehicle safety

reduce fuel consumption
The vehicle chassis ride height is raised or
lowered according to the selected level
setting and to the vehicle speed:

With increasing speed, ride height is re-
duced by up to approximately 0.6 in
(15 mm).

With decreasing speed, the ride height
is again raised to the selected vehicle
level.
The following vehicle level settings can be
selected when the vehicle is stationary:
Select the “Raised” level setting only when
required by current driving conditions.
Otherwise:

Fuel consumption may increase.

Handling may be impaired.1Vehicle level control switch
2Indicator lamp
Selecting a higher level
Start the engine.
If indicator lamp2 is off:
Press switch1.
Indicator lamp2 comes on. The vehi-
cle is raised to a higher level.
iS63AMG and S65AMG only:
When you switch off the engine, the entire vehi-
cle is lowered by 0.2 in (5 mm).
Warning!G
To help avoid personal injury, keep hands
and feet away from wheel housing area, and
stay away from under the vehicle when low-
ering the vehicle chassis.
iThese height adjustments are so small that
you may not notice any change.
Level
NormalFor driving on normal roads.
The indicator lamp is off.
RaisedFor driving on rough roads or
with snow chains. The indica-
tor lamp is on.
iThe selected vehicle level setting remains
stored in memory even if the engine is turned off
and restarted.

444 Controls in detail
Driving systems
Selecting a normal level
Start the engine.
If indicator lamp2 is on:
Press switch1.
Indicator lamp2 goes out. The vehicle
is adjusted to a normal level.
Suspension tuning
The suspension tuning is set according to:

your driving style

road surface conditions

the vehicle loading

your choice of suspension styleThe program mode selector switch (C/S)
(
page 409) or (S/C/M) (page 413) is
used to adjust the suspension tuning:
Start the engine.
Select the desired driving program.
Parktronic system*
Driving programSuspension tuning
CComfortcomfortable
(default setting)
SSport
MManualsporty
for dynamic driving
Warning!G
Parktronic is a supplemental system. It is
not intended to, nor does it replace, the
need for extreme care. The responsibility
during parking and other critical maneuvers
always remains with the driver.
Warning!G
Make sure no persons or animals are in the
area in which you are maneuvering. You
could otherwise injure them.
!Special attention must be paid to objects
with smooth surfaces or low silhouettes (e.g.
trailer couplings, painted posts, elevated cross-
bars or road curbs). Such objects may not be de-
tected by the system and can damage the
vehicle.

446 Controls in detail
Driving systems
Front sensors
Rear sensorsMinimum distance
If the system detects an obstacle in this
range, all the distance warning segments
illuminate and you hear a warning signal. If
the obstacle is closer than the minimum
distance, the actual distance may no long-
er be indicated by the system.Warning indicators
Visual signals indicate to the driver the rel-
ative distance between the sensors and an
obstacle.
The warning indicator for the front area is
in the instrument cluster. The warning indi-
cator for the rear area is on the roof liner in
the rear.
1Left side of the vehicle
2Right side of the vehicle
3Indicator
Each warning indicator is divided into five
yellow and two red distance segments for
either side of the vehicle.
If yellow indicators 3 under the segments
are lit, Parktronic is ready to measure.
Centerapprox. 40 in (100 cm)
Cornersapprox. 24 in (60 cm)
Centerapprox. 48 in (120 cm)
Cornersapprox. 32 in (80 cm)
!During parking maneuvers, pay special at-
tention to objects located above or below the
height of the sensors (e.g. street curbs, painted
posts, or trailer hitches etc.). The Parktronic sys-
tem will not detect such objects at close range
and damage to your vehicle or the object may re-
sult.
Ultrasonic signals from outside sources (e.g.
truck air brakes, car wash, or jackhammers) may
impair the operation of the Parktronic system.
Centerapprox. 8 in (20 cm)
Cornersapprox. 6 in (15 cm)

447 Controls in detail
Driving systems
The position of the gear selector lever de-
termines which warning indicators will be
activated.
As your vehicle approaches an object, one
or more distance segments will illuminate,
depending on the distance. When the sev-
enth distance segment illuminates, you
have reached the minimum distance.
Front area:
An intermittent acoustic warning will
sound as the first red distance segment
illuminates and a constant acoustic
warning lasting a maximum of
2 seconds will sound for the second
red distance segment. The signal is
canceled when the gear selector lever
is placed in park position P.

Rear area:
An intermittent acoustic warning will
sound as the first red distance segment
illuminates and a constant acoustic
warning lasting a maximum of
2 seconds will sound for the second
red distance segment. The signal is
canceled when the gear selector lever
is placed in position D orP.Switching Parktronic system on/off
The Parktronic system can be switched off
manually.
1Parktronic button
2Indicator lamp
Gear selector
lever positionWarning indicator
DFront area activated
R or NFront and rear area
activated
PNeither activated

448 Controls in detail
Driving systems
Switching off the Parktronic sys-
tem: Press button 1.
Indicator lamp 2 comes on.
Switching on the Parktronic system:
Press button 1 again.
Indicator lamp 2 goes out.
Parktronic system malfunction
If only the red distance segments illumi-
nate and an acoustic warning sounds,
there is a malfunction in the Parktronic
system. The Parktronic system will auto-
matically switch off after 20 seconds and
the indicator lamp in the Parktronic switch
comes on.
Have the Parktronic system checked
by an authorized Mercedes-Benz Cen-
ter as soon as possible.
If only the red distance segments illumi-
nate and no acoustic warning sounds, the
Parktronic system sensors are dirty or
there is an interference from other radio or
ultrasonic signals. The Parktronic system
will automatically switch off after 20 sec-
onds and the indicator lamp in the Park-
tronic switch comes on.
Switch off the ignition (page 344).
Clean the Parktronic system sensors
(
page 589).
Switch on the ignition.
or
Check the Parktronic system operation
at another location to rule out interfer-
ence from outside radio or ultrasonic
signals.
Park Assist*
iThe Parktronic system is automatically
switched on when the ignition is switched on
(
page 344).
Warning!G
Park Assist is a supplemental system. It is
not intended to, nor does it replace, the
need for extreme care. The responsibility
during parking and other critical maneuvers
always remains with the driver.
Warning!G
Make sure no persons or animals are in the
area in which you are maneuvering. You
could otherwise injure them.
!Special attention must be paid to objects
with smooth surfaces or low silhouettes (e.g.
trailer couplings, painted posts, elevated cross-
bars or road curbs). Such objects may not be de-
tected by the system and can damage the
vehicle.

451 Controls in detail
Driving systems
Front sensors
Rear sensorsWarning indicators
Visual signals indicate to the driver the rel-
ative distance between the sensors and an
obstacle.
The warning indicator for the front area is
in the instrument cluster. The warning indi-
cator for the rear area is on the roof liner in
the rear.
1Left side of the vehicle
2Right side of the vehicle
3Indicator
Each warning indicator is divided into five
yellow and two red distance segments for
either side of the vehicle.
If yellow indicators 3 under the segments
are lit, Park Assist is ready to measure.The position of the gear selector lever de-
termines which warning indicators will be
activated.
As your vehicle approaches an object, one
or more distance segments will illuminate,
depending on the distance. When the sev-
enth distance segment illuminates, you
have reached the minimum distance.
iDue to the sensors’ broad detection range,
it is possible that Park Assist also detects the fol-
lowing obstacles and issues a warning:

obstacles in the ground, e.g. sewer canal
covers, rails, bumps in the road or gutters

obstacles moving upward quickly, e.g. rolling
garage doors
Centerapprox. 40 in (100 cm)
Cornersapprox. 24 in (60 cm)
Centerapprox. 50 in (125 cm)
Cornersapprox. 24 in (60 cm)
!While parking, pay particular attention to ob-
jects over or underneath the sensors, e.g. flower
boxes, an elevated crossbar or a trailer tow
hitch. Park Assist does not detect such nearby
objects. You could otherwise damage the vehicle
or the objects.
Gear selector
lever positionWarning indicator
DFront area activated
RFront and rear area
activated
NWith the electronic
parking brake engaged:
neither activated.
With the electronic
parking brake released:
front and rear area acti-
vated.
PNeither activated