2008 MERCEDES-BENZ ML350 menu

307 Controls in detail
Useful features
Compass
Calling up the compass
Press buttonè orÿ repeatedly
until the
AIRMATIC/Compass menu
appears in the multifunction display.
The compass displays the direction
into which the vehicle is currently trav-
eling:
N, NE, E, SE, S, SW, W, or NW.To make sure the display is correct, the
compass must be set to the proper geo-
graphic zone (
page 173). It may also be
necessary to calibrate the compass
(
page 174).
iUSA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interfer-
ence, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.
iCanada only:
This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.
iIf your vehicle is not equipped with the air
suspension program*, the multifunction display
will show the compass only.
iThe presence of buildings, bridges, power
lines and large antenna masts can influence the
displayed values. Metallic or magnetic objects in
or on the vehicle can influence the accuracy of
the compass.
iIf the compass is not calibrated or its
function is impaired by outside influences, the
message
Compass - - - appears in the
multifunction display.

361 Operation
Tires and wheels
Restarting the Run Flat Indicator
The Run flat indicator must be restarted in
the following situations:

If you have changed the tire inflation
pressure

If you have replaced the wheels or tires

If you have installed new wheels or
tires
Using the Tire and Loading Information
placard on the driver’s door B-pillar or,
if available, the tire inflation pressure
label on the inside of the fuel filler flap,
make sure the tire inflation pressure of
all four tires is correct.
Switch on the ignition (page 40).
Make sure the standard display menu
appears in the multifunction display
(
page 147).
Press buttonk orj repeatedly
until the following message appears in
the multifunction display:
Press the reset button on the instru-
ment cluster (
page 145).
The following message will appear in
the multifunction display:
Restart
Run Flat Indicator?
Yes
Cancel
Warning!G
The Run Flat Indicator does not provide a
warning for wrongly selected tire inflation
pressures. Always adjust tire inflation pres-
sure according to the Tire and Loading
Information placard on the driver’s door
B-pillar (
page 352) or, if available, on the
tire inflation pressure label located on the
inside of the fuel filler flap (
page 337).
The Run Flat Indicator does not replace
regular checks of the tire inflation pressures
since a gradual pressure loss in more than
one tire cannot be detected by the Run Flat
Indicator.
The Run Flat Indicator is not able to issue a
warning due to a sudden dramatic loss of
tire inflation pressure (e.g. tire blowout
caused by a foreign object). In this case
bring the vehicle to a halt by carefully apply-
ing the brakes and avoiding abrupt steering
maneuvers.
Warning!G
The Run Flat Indicator can only warn you in
a reliable manner if you have set the correct
tire inflation pressures for each tire.
If an incorrect tire inflation pressure was set,
the system will monitor the pressure
according to the incorrect value.

365 Operation
Tires and wheels
Switch on the ignition (page 40).
Press buttonè orÿ on the mul-
tifunction steering wheel repeatedly
until the standard display menu ap-
pears in the multifunction display
(
page 147).
Press buttonj or k repeatedly
until you see the following message:
Tire Pressure Monitor
Active
Menu: R-Button
Press the reset button (page 145).
The following message will appear in
the multifunction display:
Restart tire
pressure monitor?
Press buttonæ.
The following message will appear in
the multifunction display:
Tire Pressure Monitor
Restarted
After driving a few minutes the system
verifies that the current tire inflation
pressures are within the system’s
specified range. Afterwards the current
tire inflation pressures are accepted as
reference pressures and then moni-
tored.
If you wish to cancel activation:
Press buttonç.Checking tire pressure electronically
with the Advanced Tire Pressure Moni-
toring System (Advanced TPMS)*,
(Canada only)
The TPMS only functions on wheels that
are equipped with the proper electronic
sensors. It monitors the tire inflation pres-
sure, as selected by the driver, in all four
tires. A warning is issued to alert you to a
decrease in pressure in one or more of the
tires.
Tire pressure inquiries are made using the
multifunction display. The present inflation
pressures are displayed only after a few
minutes’ travel time.
iRestart the TPMS after adjusting the tire in-
flation pressure to the inflation pressure recom-
mended for the vehicle operating condition. Tire
pressure should only be adjusted on cold tires.
Observe the recommended tire inflation pres-
sure on the Tire and Loading Information placard
on the driver’s door B-pillar (
page 352). Some
vehicles may have supplemental tire inflation
pressure information for driving at high speeds
(
page 358) or for vehicle loads less than the
maximum loaded vehicle condition
(
page 358). If such information is provided, it
can be found on the inside of the fuel filler flap.
iThis device complies with RSS-210 of Indus-
try Canada. Operation is subject to the following
two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.

368 Operation
Tires and wheels
Restarting Advanced TPMS*
The TPMS usually recognizes new refer-
ence values automatically, for example
when you have

adjusted the tire inflation pressure

changed wheels or tires

mounted new wheels or tiresIf you want to set new reference values
manually:
Using the Tire and Loading Information
placard on the driver’s door B-pillar
(
page 352) or, if available, the sup-
plemental tire inflation pressure
information on the inside of the fuel
filler flap (
page 337), make sure the
tire inflation pressure of all four tires is
correct.
Press buttonè orÿ on the mul-
tifunction steering wheel repeatedly
until the standard display menu
appears in the multifunction display
(
page 147).
Press buttonj or k repeatedly
until

the current inflation pressures for
each tire appear in the multifunc-
tion display
or

the following message appears in
the multifunction display
Tire pressure
displayed after
driving for
a few minutes.
Press the reset button (page 145).
The following message will appear in
the multifunction display:
Restart tire
pressure monitor?
Warning!G
It is the driver’s responsibility to calibrate
the TPMS on the recommended cold infla-
tion pressure. Underinflated tires affect the
ability to steer or brake the vehicle. You
might lose control over the vehicle.
iReactivate the TPMS after adjusting the tire
inflation pressure to the inflation pressure rec-
ommended for the vehicle operating condition.
Tire pressure should only be adjusted on cold
tires. Observe the recommended tire inflation
pressure on the Tire and Loading Information
placard on the driver’s door B-pillar
(
page 352). Some vehicles may have supple-
mental tire inflation pressure information for
driving at high speeds (
page 358) or for vehi-
cle loads less than the maximum loaded vehicle
condition (
page 358). If such information is
provided, it can be found on the inside of the fuel
filler flap.

413 Practical hints
What to do if …
Vehicle status messages in the
multifunction display
Warning and malfunction messages
appear in the multifunction display located
in the instrument cluster.
Certain warning and malfunction messag-
es are accompanied by an audible signal.
Address these messages accordingly and
follow the additional instructions given in
this Operator’s Manual.
Selecting the vehicle status message
memory menu in the control system
(
page 162) displays both cleared and
uncleared messages.
High-priority messages appear in the
multifunction display in red color.Certain messages of high priority cannot
be cleared from the multifunction display
using the reset button (
page 145) or
buttonj,k,ÿ, orè on the
multifunction steering wheel.
Other messages of high priority and mes-
sages of less immediate priority can be
cleared from the multifunction display
using the reset button (
page 145) or
buttonj,k,ÿ, orè on the
multifunction steering wheel. They are
then stored in the vehicle status message
memory (
page 162). Remember that
clearing a message will only make the mes-
sage disappear. Clearing a message will
not correct the condition that caused the
message to appear.
Warning!G
All categories of messages contain
important information which should be
taken note of and, where a malfunction is
indicated, addressed as soon as possible at
an authorized Mercedes-Benz Light Truck
Center.
Failure to repair condition noted may cause
damage not covered by the Mercedes-Benz
Limited Warranty, or result in property dam-
age or personal injury.

531 Index
A
ABS 98
Indicator lamp 400
Messages in the multifunction
display 415
Off-road - ABS 99
Accelerator position, automatic
transmission 190
Accessory weight 379
Accident 64
Active head restraint 88, 127, 458
Adaptive Damping System (ADS)* 255
Air bags 74
Children 75, 89
Front passenger front air bag off
indicator lamp 31, 83
Front, Driver 77
Front, Passenger 77
Occupant Classification System
(OCS) 79
Safety guidelines 76
Side impact (front and rear*) 78
Window curtain 78Air conditioning refrigerant 525
Air conditioning system see
Climate control or
Automatic climate control (3-zone)*
Air conditioning, Cooling 214, 229
Air distribution, Front 209, 224
Air distribution, Rear 217, 233
Air pressure see Tire inflation pressure
Air pump, electric (ML 63 AMG) 485
Air recirculation mode 212, 227
Air suspension program* 254
Adaptive Damping System
(ADS)* 255
Messages in the multifunction
display 447
Vehicle level control* 255
Air vents 217
Air vents, Front 210, 224
Air vents, Rear 234
Air volume 210, 225
Alarm system see Anti-theft systems
Alignment bolt (vehicle tool kit) 450, 483Anticorrosion/antifreeze 529
Antiglare, Interior rear view mirror 199
Antiglare, Rear view mirrors* 199
Antilock Brake System see ABS
Anti-theft systems 107
Anti-theft alarm system 106, 107
Immobilizer 106
Aquaplaning see Hydroplaning
Armrest storage/telephone* compart-
ment
Front 281
Ashtrays (Depending on vehicle
configuration) 285
Aspect ratio 379
ATF 345
Attaching a trailer 330
AUDIO menu 160
Audio menu
CD operation 161
Radio operation 160
Satellite radio* operation 160
Auto-dimming*, Rear view mirrors 199
Automatic central locking, Control
system 175

534 Index
Climate control 204
Air conditioning, Cooling 214, 215
Air distribution, Front 209
Air distribution, Rear 217
Air recirculation mode 212
Air vents, Front 210
Air volume 210
Control panel*, Rear 216
Control panel, Front 206
Deactivating system 208
Defogging 212
Defrosting 210
Rear window defroster 203
Residual engine heat (REST) 215
Clock 27, 169
Cloth upholstery,
Cleaning and care of 397
Cockpit 24
Cockpit Management and Data System
see COMAND system
Cold tire inflation pressure 380
Collapsible tire 518
Collapsible tire (ML 63 AMG only) 453
Collapsible wheel chock 452COMAND system see separate operating
instructions
Combination switch 59, 60, 62, 139
Compass 307
Adjustment 173
Calibration 174
Calling up the compass 307
Control and operation of radio
transmitters 334
Control system 147
Multifunction display 147
Multifunction steering wheel 148
Resetting to factory default 164
Control system menus 147
AIRMATIC*/Compass 162
AMG menu 156
AUDIO 160
NAV* 161
Settings 163
Standard display 154
TEL* 180
Trip computer 178
Vehicle configuration 177
Vehicle status message memory 162Control system submenus 151, 153, 166
Comfort* 176
Instrument cluster 167, 168
Lighting 170
Time/Date 169
Vehicle 173
Coolant 345, 528
Anticorrosion/antifreeze
mixing ratio and quantity 529
Capacities 522
Checking coolant level 339, 345
Messages in the multifunction
display 431, 433
Temperature 336
Temperature display 154
Corner-illuminating front fog lamps* 140
Messages in the multifunction
display 439
Replacing bulbs 469
Crossing obstacles 325
Cruise control 244
Activating 246
Messages in the multifunction
display 416

543 Index
M
Main dimensions 520
Maintenance 12, 386
Calling up service indicator
display 388
Clearing service indicator
message 387
Maintenance System 386
Resetting service indicator 388
Service indicator message 386
Service term exceeded 387
Maintenance System 386
Manual headlamp mode see Headlamps
Manual shift progam
(ML 63 AMG only) 195
Manual shift program (ML 63 AMG)
Activating 195
Deactivating 196
Maximum cooling, MAXCOOL* see
Automatic climate control
(3-zone)* 226Maximum load rating, Tires 381
Maximum loaded vehicle weight,
Tires 381
MB Tex upholstery, Cleaning and care
of 398
Mechanical key 455
Memory function* see Seats
Menus see Control system menus
Messages in display see
Multifunction display messages
Microphone, Hands-free 33
Minispare wheel see Spare wheel
Mirrors
Adjusting 49
Auto-dimming rear view
mirrors* 199
Exterior rear view mirror 49
Interior rear view mirror 49, 199
MON 338, 526
Multicontour seat* 129Multifunction display 147
Changing settings see Control system
menus and Control system
submenus
Selecting display 168
Selecting language 167
Multifunction display messages 413
ABS 415
Air suspension program* 447
Brake fluid 430
Brake lamps 438
Brake pads 428
Coolant 433
Corner-illuminating front fog
lamps* 439
Cruise control 416
Doors 435
Downhill Speed Regulation 428
EBP 429
Engine coolant 431, 433
ESP
®405