2008 MERCEDES-BENZ ML350 seat adjustment

53 Getting started
Driving
With a smooth motion, pull the belt out
of seat belt outlet1.
Place the shoulder portion of the belt
across the top of your shoulder and the
lap portion across your hips.
Push latch plate2 into buckle3
(
page 52) until it clicks.
If necessary, tighten the lap portion to
a snug fit by pulling shoulder portion
up.
Seat belt height adjustment
1Release button
Press release button1 and move the
seat belt height adjuster upward or
downward.
Proper use of seat belts

Do not twist the belt when fastening.

Adjust seat belt so that the shoulder
portion is located as close as possible
to the middle of the shoulder (it should
not touch the neck). Never pass the
shoulder portion of the belt under your
arm. For this purpose, you can adjust
the height of the belt outlet
(
page 53).

Position the lap belt as low as possible
on your hips (over hip joint) and not
across the abdomen.

Place the seat backrest in a position
that is as upright as possible.

Never use a seat belt for more than one
person at a time.

Do not fasten a seat belt around a
person and another object at the same
time. When using a seat belt to secure
infant or toddler restraints or children
in booster seats, always follow the
child seat manufacturer’s instructions.

Check your seat belt periodically
during travel to make sure that it is
properly positioned.

Make sure the seat belt is always fitted
snugly. Take special care of this when
wearing loose clothing.

54 Getting started
Driving
Starting the engine Automatic transmission
Gearshift pattern for automatic
transmission
PPark position
RReverse gear
NNeutral
DDrive position
For more information on how to operate
the gear selector lever, see “Automatic
transmission” (
page 183).
Warning!G
Do not pass belts over sharp edges. They
could tear.
Do not allow the belt to get caught in the
door or in the seat adjustment mechanism.
This could damage the belt.
Never attempt to make modifications to
seat belts. This could impair the effective-
ness of the belts.
Do not bleach or dye seat belts as this may
severely weaken them. In a crash, they may
not be able to provide adequate protection.
Damaged seat belts or belts that were highly
stressed in an accident must be replaced.
Contact an authorized Mercedes-Benz Light
Truck Center.Warning!G
Inhalation of exhaust gas is hazardous to
your health. All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause un-
consciousness and possible death.
Do not run the engine in confined areas
(such as a garage) which are not properly
ventilated. If you think that exhaust gas
fumes are entering the vehicle while driving,
have the cause determined and corrected
immediately. If you must drive under these
conditions, drive only with at least one win-
dow fully open.

74 Safety and Security
Occupant safety
Air bags
Warning!G
Air bags are designed to reduce the poten-
tial of injury and fatality in certain frontal
impacts (front air bags), side impacts (side
impact air bags and window curtain air bags)
or rollovers (window curtain air bags).
However, no system available today can
completely eliminate injuries and fatalities.
The deployment of the air bags temporarily
releases a small amount of dust from the air
bags. This dust, however, is neither injurious
to your health, nor does it indicate a fire in
the vehicle. The dust might cause some tem-
porary breathing difficulty for people with
asthma or other breathing trouble. To avoid
this, you may wish to get out of the vehicle
as soon as it is safe to do so. If you have any
breathing difficulty but cannot get out of the
vehicle after the air bag inflates, then get
fresh air by opening a window or door.
Warning!G
To reduce the risk of injury when the front
air bags inflate, it is very important for the
driver and front passenger to always be in a
properly seated position and to wear their
respective seat belt.
For maximum protection in the event of a
collision always be in normal seated position
with your back against the seat backrest.
Fasten your seat belt and make sure it is
properly positioned on your body
(
page 51).
Since the air bag inflates with considerable
speed and force, a proper seating and hands
on steering wheel position will help to keep
you at a safe distance from the air bag.
Occupants who are unbelted, out of position
or too close to the air bag can be seriously
injured or killed by an air bag as it inflates
with great force in the blink of an eye:

Sit properly belted in a position that is as
upright as possible with your back
against the seat backrest.

Adjust the driver’s seat as far as possi-
ble rearward, still permitting proper op-
eration of vehicle controls. The distance
from the center of the driver’s breast-
bone to the center of the air bag cover
on the steering wheel must be at least
10 inches (25 cm) or more. You should
be able to accomplish this by a combina-
tion of adjustments to the seat and
steering wheel. If you have any
problems, please see an authorized
Mercedes-Benz Light Truck Center.

Do not lean your head or chest close to
the steering wheel or dashboard.

Keep hands on the outside of steering
wheel rim. Placing hands and arms in-
side the rim can increase the risk and
potential severity of hand/arm injury
when driver’s front air bag inflates.

Adjust the front passenger seat as far as
possible rearward from the dashboard
when the seat is occupied.

127 Controls in detail
Seats
Seats
For information on seat adjustment, see
the “Getting started” section (
page 43).
For more information on seats, see “Load-
ing” (
page 266).
Front seat active head restraintsYou cannot remove the active head
restraints on the driver’s and front
passenger’s seat.
For removal of the active head restraints
we recommend that you contact an
authorized Mercedes-Benz Light Truck
Center.
For information on head restraint adjust-
ment, see “Seats” (
page 43).
For information on active head restraints,
see “Active head restraint” (
page 88).
Rear seat head restraints
Warning!G
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint so that it is close
to the head as possible and the center of the
head restraint supports the back of the head
at eye level. This will reduce the potential for
injury to the head and neck in the event of
an accident or similar situation.
Warning!G
Do not drive the vehicle without the seat
head restraints installed when the rear seats
are occupied. Head restraints are intended
to help reduce injuries during an accident.
With a rear seat occupied, make sure to
move the respective head restraint up from
the lowest non-use position and have the oc-
cupant adjust the head restraint properly.
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint in such a way that
it is as close to the head as possible and the
center of the head restraint supports the
back of the head at eye level. This will re-
duce the potential for injury to the head and
neck in the event of an accident or similar
situation.

128 Controls in detail
Seats
Head restraint height
1Head restraint
2Release button
Raising:
Manually adjust the height of head
restraint1 by pulling it upward to the
desired position.
Lowering:
To lower head restraint1, press
release button2 and push down on
head restraint1.Head restraint fore and aft adjustment
Manually adjust the angle of the head
restraint.
While seated, reach behind you with
both hands and find lower edge of the
head restraint.
Adjust the head restraint to the desired
position by pushing or pulling on the
lower edge of the head restraint cush-
ion.Head restraints, removing and install-
ing
1Head restraint
2Release button
RemovingPull head restraint1 to its uppermost
position.
Press release button2 and pull out
head restraint.

129 Controls in detail
Seats
Installing
Insert head restraint1 into openings
on the seat backrest.
Push head restraint1 down until it au-
dibly engages.
Press release button2 and adjust
head restraint1 to the desired posi-
tion (
page 128).
For more information on seats, see the
“Getting started” section (
page 43).
Lumbar support
The curvature of the driver’s seat can be
adjusted to help enhance lower back sup-
port and seating comfort.
The lever for lumbar support adjustment is
located on the right hand side of the
driver’s seat backrest.
1Adjustment lever
Move adjustment lever1 in direction
of arrows until you have reached a
comfortable seating position.
Multicontour seat*
The multicontour seat has an extendable
seat cushion and inflatable air chambers
built into the backrest to provide additional
lumbar and side support.
The seat cushion depth, seat backrest
cushion-height and curvature can be con-
tinuously varied with switches on the in-
side of each front seat base after the
ignition is switched on (
page 39).
1Seat cushion depth
2Backrest side bolsters
3Backrest center
4Backrest bottom

539 Index
G
Garage door opener 302
Gasoline see Fuel
GAWR 380
Gear range
Automatic transmission 192
Limiting 192
Shifting into optimal 194
Gear selector lever 25, 54, 183
Cleaning 397
Gearshift pattern 183
Messages in the multifunction
display 420
Position 186
Shifting procedure 186
Transmission position 187
Global locking/unlocking see Key,
SmartKey
Glove box 279
Good visibility 199
Gross Axle Weight Rating see GAWR
Gross Trailer Weight see GTW
Gross Vehicle Weight Rating see GVWR
Gross Vehicle Weight see GVWGTW 380
GVW 380
GVWR 380
H
Halogen headlamp see Headlamps
Hands-free microphone 33
Hard plastic trim items, cleaning 396
Hazard warning flasher 141
Head restraints 44, 127
Active head restraint 88, 127
Front seats, Adjusting 44
Rear seats 89
Rear seats, Adjusting 128
Rear seats, Removing and
installing 128
Headlamp aim
Adjusting 473
Headlamp cleaning system* 199, 346
Headlamp shut-off delay see Delayed
shut-off, Exterior lampsHeadlamps
Automatic headlamp mode 136
Bi-Xenon* 438, 467
Cleaning lenses 393
Cleaning system* 199, 346
Halogen 466
High beam see High beam flasher
High beam see High beam headlamps
Light sensor, Messages in the
multifunction display 438
Low beam see Low beam headlamps
Manual headlamp mode 136
Messages in the multifunction
display 438, 439, 440, 441, 442,
443
Replacing bulbs 463, 464
Switch 59, 135
Heated seats see Seat heating*
Heated steering wheel* 290
Height adjustment
Vehicle level control (Vehicles with
Air suspension program*) 257

547 Index
Replacing bulbs 463
Additional turn signals, Exterior rear
view mirrors 470
Backup lamps 463, 471
Brake lamps 463, 471
Corner-illuminating front fog
lamps* 463, 464, 469
Fog lamp, Rear 463, 471
Fog lamps, Front 463, 464, 469
High beam headlamps 463, 464, 467
License plate lamps 463, 473
Low beam headlamps 463, 464, 466
Parking/standing lamps 463, 468,
471, 472
Side marker lamps, Front 463, 464,
466, 469
Side marker lamps, Rear 463, 471
Tail lamps 463, 464, 471, 472
Turn signal lamps, Front 463, 464,
468
Turn signal lamps, Rear 463, 471Reporting safety defects 19
Reset button, In instrument cluster 164
Reset tool
Active head restraints,
Depository 459
Residual heat and ventilation 215, 230
Reverse gear position, Automatic
transmission 183, 187
Rims 381, 515
Roadside Assistance 12
Roadside Assistance button see Tele Aid
RON 338, 526
Roof rails 266
Rubber parts, Cleaning 396
Run Flat Indicator (Canada only) 360S
Safety
Driving safety systems 98
Occupant safety 72
Reporting safety defects 19
Safety belts see Seat belts
Satellite radio* 160
Scissors-type vehicle jack 450, 451
Seat belt force limiter 87
Seat belts 84
Children in the vehicle 89
Cleaning 397
Fastening 51
Height adjustment 53
Messages in the multifunction
display 407
Proper use of 53, 86
Safety guidelines 76
Telltale 29, 84, 406
Warning lamp 406, 407
Seat cushion depth see Seats