400 Practical hints
What to do if …
Lamps in instrument clusterGeneral information:
If any of the following lamps in the instru-
ment cluster fails to come on during thebulb self-check when switching on the
ignition, have the respective bulb checked
and replaced if necessary.
ProblemPossible cause/consequenceSuggested solution
-The yellow ABS indicator lamp
comes on while the engine is
running.ABS has detected a malfunction and has
switched off. The BAS, ESP®, EBP, and 4-ETS
are also switched off (see messages in multi-
function display).
The brake system is still functioning normally
but without the ABS available.
If the ABS control unit is malfunctioning,
other systems such as the navigation
system* or the automatic transmission may
also be malfunctioning.
Continue driving with added caution.
Wheels may lock during hard braking,
reducing steering capability.
Read and observe messages in the
multifunction display (
page 413).
Have the system checked at an
authorized Mercedes-Benz Light
Truck Center as soon as possible.
Failure to follow these instructions
increases the risk of an accident.
The charging voltage has fallen below
10 volts. The ABS has switched off.
The battery might not be charged sufficiently.When the voltage is above this value
again, the ABS is operational again and
the ABS indicator lamp should go out.
If the ABS indicator lamp does not go out:
Have the generator (alternator) and
the battery checked.
413 Practical hints
What to do if …
Vehicle status messages in the
multifunction display
Warning and malfunction messages
appear in the multifunction display located
in the instrument cluster.
Certain warning and malfunction messag-
es are accompanied by an audible signal.
Address these messages accordingly and
follow the additional instructions given in
this Operator’s Manual.
Selecting the vehicle status message
memory menu in the control system
(
page 162) displays both cleared and
uncleared messages.
High-priority messages appear in the
multifunction display in red color.Certain messages of high priority cannot
be cleared from the multifunction display
using the reset button (
page 145) or
buttonj,k,ÿ, orè on the
multifunction steering wheel.
Other messages of high priority and mes-
sages of less immediate priority can be
cleared from the multifunction display
using the reset button (
page 145) or
buttonj,k,ÿ, orè on the
multifunction steering wheel. They are
then stored in the vehicle status message
memory (
page 162). Remember that
clearing a message will only make the mes-
sage disappear. Clearing a message will
not correct the condition that caused the
message to appear.
Warning!G
All categories of messages contain
important information which should be
taken note of and, where a malfunction is
indicated, addressed as soon as possible at
an authorized Mercedes-Benz Light Truck
Center.
Failure to repair condition noted may cause
damage not covered by the Mercedes-Benz
Limited Warranty, or result in property dam-
age or personal injury.
414 Practical hints
What to do if …
On the pages that follow, you will find a
compilation of the most important warning
and malfunction messages that may
appear in the multifunction display.
For your convenience the messages are
divided into two sections:
Text messages (page 415)
Symbol messages (page 427)
Warning!G
No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
As a result, you will not be able to see infor-
mation about your driving conditions, such
as speed or outside temperature, warn-
ing/indicator lamps, malfunction/warning
messages or the failure of any systems.
Driving characteristics may be impaired.
If you must continue to drive, please do so
with added caution. Visit an authorized
Mercedes-Benz Light Truck Center as soon
as possible.
iSwitching on the ignition causes all
instrument cluster lamps (except high beam
headlamp indicator lamp, and turn signal
indicator lamps unless activated) as well as the
multifunction display to come on. Make sure the
lamps and multifunction display are in working
order before starting your journey.
422 Practical hints
What to do if …
Display messagePossible
cause/conse-
quencePossible solution
Monitor the 59indicator lamp on the center console (page 83) and
the multifunction display in the instrument cluster (
page 26) for the following:
With the seat unoccupied and the ignition turned on,
the 59indicator lamp on the center console should illuminate and
remain illuminated, indicating that the OCS (
page 79) has deactivated the air
bag.
the message Front Passenger Airbag Enabled See Operator’s Manual or the
message
Front Passenger Airbag Disabled See Operator’s Manual should not
appear in the multifunction display at any time the seat is unoccupied. Wait at
least 60 seconds for the system to complete the necessary check cycles and to
make sure neither message appears in the multifunction display.
If above conditions are met, you can occupy the front passenger seat again.
Depending on the front passenger classification sensed by the OCS (
page 79),
the59indicator lamp will remain illuminated or go out.
If above conditions are not met, the system is not working properly. Have the system
checked as soon as possible by an authorized Mercedes-Benz Light Truck Center.
Warning!G
If the 59indicator lamp
remains out even after performing the above
corrective steps, do not have any children
12 years old and under and other smallindividuals use the front passenger seat
until the system has been repaired.
424 Practical hints
What to do if …
Display messagePossible
cause/conse-
quencePossible solution
Monitor the 59indicator lamp on the center console (page 83) and
the multifunction display in the instrument cluster (
page 26) for the following:
With the seat unoccupied and the ignition turned on,
the 59indicator lamp on the center console should illuminate and
remain illuminated, indicating that the OCS (
page 79) has deactivated the air
bag.
the message Front Passenger Airbag Enabled See Operator’s Manual or the
message
Front Passenger Airbag Disabled See Operator’s Manual should not
appear in the multifunction display at any time the seat is unoccupied. Wait at
least 60 seconds for the system to complete the necessary check cycles and to
make sure neither message appears in the multifunction display.
If above conditions are met, you can occupy the front passenger seat again.
Depending on the front passenger classification sensed by the OCS (
page 79),
the59indicator lamp will remain illuminated or go out.
If above conditions are not met, the system is not working properly. Have the system
checked as soon as possible by an authorized Mercedes-Benz Light Truck Center.
Warning!G
If the 59indicator lamp
remains illuminated with an adult occupant
on the front passenger seat even after per-
forming the above corrective steps, do nothave any passenger use the front passenger
seat until the system has been repaired.
532 Index
Automatic climate control (3-zone)* 218
Air conditioning, Cooling 229
Air distribution, Front 224
Air distribution, Rear 233
Air recirculation mode 227
Air vents, Front 224
Air volume 225
Control panel, Front 220
Control panel, Rear 231
Deactivating system 222
Defogging 225
Defrosting 225
Maximum cooling, MAXCOOL 226
Rear passenger compartment 231
Rear window defroster 203
Residual engine heat (REST) 230
Using driver-side settings for
all temperature zones 229
Automatic headlamp mode 136
Automatic lighting control, Interior
lighting 142
Automatic locking when driving 125
Automatic shift program
(ML 63 AMG only) 195Automatic transmission 54
Accelerator position 190
Automatic shift program
(ML 63 AMG only) 195
Emergency operation
(Limp-Home Mode) 197
Gear ranges 192
Gear selector lever 54, 183
Gear shifting malfunctions 197
Hill start assist system 191
Kickdown 190
Kickdown, manual shift program
(ML 63 AMG only) 196
Manual shift progam
(ML 63 AMG only) 195
Program mode selector switch
(ML 63 AMG only) 194
Shift program (ML 63 AMG only) 194
Shifting procedure 186
Starting the engine 54
Steering wheel gearshift control 193
Towing a trailer 191
Transmission fluid level 345
Transmission positions 187
Automatic Transmission Fluid see ATFB
Backrest
Seat 44
Seat, Lumbar support 129
Seat, Multicontour* 129
Backup lamps
Messages in the multifunction
display 438
Replacing bulbs 471
Bar 380
BAS 100
Lamps in instrument cluster 400
Messages in the multifunction
display 415
Basic carrier bars* 266
Batteries, SmartKey
Check lamp 110, 113
Messages in the multifunction
display 427
Replacing 461
Battery, Vehicle 489
Charging 496
Disconnecting and connecting 491
Jump starting 497
Removing and installing 491
534 Index
Climate control 204
Air conditioning, Cooling 214, 215
Air distribution, Front 209
Air distribution, Rear 217
Air recirculation mode 212
Air vents, Front 210
Air volume 210
Control panel*, Rear 216
Control panel, Front 206
Deactivating system 208
Defogging 212
Defrosting 210
Rear window defroster 203
Residual engine heat (REST) 215
Clock 27, 169
Cloth upholstery,
Cleaning and care of 397
Cockpit 24
Cockpit Management and Data System
see COMAND system
Cold tire inflation pressure 380
Collapsible tire 518
Collapsible tire (ML 63 AMG only) 453
Collapsible wheel chock 452COMAND system see separate operating
instructions
Combination switch 59, 60, 62, 139
Compass 307
Adjustment 173
Calibration 174
Calling up the compass 307
Control and operation of radio
transmitters 334
Control system 147
Multifunction display 147
Multifunction steering wheel 148
Resetting to factory default 164
Control system menus 147
AIRMATIC*/Compass 162
AMG menu 156
AUDIO 160
NAV* 161
Settings 163
Standard display 154
TEL* 180
Trip computer 178
Vehicle configuration 177
Vehicle status message memory 162Control system submenus 151, 153, 166
Comfort* 176
Instrument cluster 167, 168
Lighting 170
Time/Date 169
Vehicle 173
Coolant 345, 528
Anticorrosion/antifreeze
mixing ratio and quantity 529
Capacities 522
Checking coolant level 339, 345
Messages in the multifunction
display 431, 433
Temperature 336
Temperature display 154
Corner-illuminating front fog lamps* 140
Messages in the multifunction
display 439
Replacing bulbs 469
Crossing obstacles 325
Cruise control 244
Activating 246
Messages in the multifunction
display 416
536 Index
Driving 51, 311
Abroad 334
Hydroplaning 316
In winter 318, 384
Instructions 51, 311
Problems 63
Safety systems 98
Systems 244
Through standing water 319
Through water 324
Driving off 58
Driving safety systems
4-ETS 104
ABS 98
BAS 100
EBP 104
ESP
®100
Driving systems 244
Adaptive Damping System
(ADS)* 255
Air suspension program* 254
Cruise control 244
Downhill Speed Regulation
(DSR) 249
Off-road driving program 253
Parktronic system* 259Rear view camera* 264
Vehicle level control* 255
Driving tips 190
Accelerator position 190
Kickdown 190
E
Easy-entry/exit feature
Activating (driver’s seat)* 176
Easy-entry/exit feature* 46
EBP 104
Indicator and warning lamps 402,
429
Electrical connections
Trailer 329
Electrical fuses see Fuses
Electrical system, Technical data 519
Electronic Brake Proportioning see EBP
Electronic Stability Program see ESP
®
Electronic Traction System see 4-ETS
Emergency calls
Tele Aid 296
Emergency operation
Fuel filler flap 457
Locking/unlocking the vehicle 455,
456Emergency operation
(Limp-Home Mode) 197
Emergency operations
Remote door unlock, Tele Aid 301
Unlocking/opening the tailgate 456
Emergency Tensioning Device see ETD
Emergency, In case of
Battery, Jump starting 497
Engine shut-down 506
First aid kit 448
Flat tire 478
Fuses 504
Hazard warning flasher 141
Instrument cluster, Indicator
lamps 400, 401, 402, 403, 404,
405, 406, 407, 408, 410
Roadside Assistance 12, 298
Towing the vehicle 499
Emission control 335
Information label 511
System warranties 10