2008 MERCEDES-BENZ G55AMG child seat

82 Safety and Security
Occupant safety
Child seat anchors – LATCH type
This vehicle is equipped with two LATCH-
(L
ower Anchors and Tethers for CHildren)
type anchors (at each of the outer rear
seats) for installation of a LATCH-type
child seat with matching mounting fittings.
Warning!G
When using a BabySmartTM compatible child
seat on the front passenger seat, the
passenger front air bag will not deploy only
if the 56 indicator lamp (
page 80)
remains illuminated.
Make sure to check the 56 indicator
lamp every time you use the special system
child seat. Should the 56 indicator
lamp go out while the restraint is installed,
please check installation. If the 56
indicator lamp remains out, do not use the
BabySmart
TM restraint to transport children
on the front passenger seat until the system
has been repaired.
Warning!G
Do not place powered-on laptops, cell
phones, electronic tags such as those used
in ski passes and like electronic devices on
the front passenger seat. Signals from such
devices may interfere with the BabySmart
TM
system. Such signal interference may cause
the 56 indicator lamp (
page 80)
not to come on during self-test or be contin-
uously lit, indicating that the system is not
functioning.
Warning!G
Children too big for ch ild restraint systems
must ride in seats usin g regular seat belts.
Position shoulder belt across chest and
shoulder, not face or neck.
A booster seat may be necessary to achieve
proper seat belt positioning for children
from 41 lbs until they reach a height where
a lap/shoulder belt fits properly without a
booster.
W463.boo Seite 82 Montag, 19. November 2007 8:41 08

83
Safety and Security
Occupant safety
The LATCH-type anchors are located
between the seat cushion and the seat
backrest.
1 Anchors
Install child seat according to the
manufacturer’s instructions. Installation of infant and child restraint
systems
Remove the cargo compartment cover
blind, if installed (
page 214).
Remove the partition net*, if so
equipped and installed (
page 210).
Anchorage rings for installation of top
tether straps are located on the floor
behind each rear seat.
1 Hook
2 Anchorage ring for rear right side seat
3 Anchorage ring for rear center seat
4 Anchorage ring for rear left side seat
Install child seat according to
manufacturer’s instructions.
T h e c h i l d s e a t m u s t b e f i r m l y a t t a c h e d t o t h e
right and left side anchors 1.
An incorrectly mounted child seat may come
loose during an accide nt which could result
in serious injury or death to the child.
Damaged or impact damaged child seats or
child seat mounting fittings must be
replaced.
Do not leave children unattended in the
vehicle, even if the children are secured in a
child restraint system.
iWith a child seat installed in the left rear
seat, the seat belt for the center seat occupied
by a passenger must operate freely.
iNon-LATCH type child seats may also be
used and can be installed using the vehicle’s
seat belt system. Install child seat according to
the manufacturer’s instructions.

W463.boo Seite 83 Montag, 19. November 2007 8:41 08

84 Safety and Security
Occupant safety
Hook fastened to respective anchorage ring
1Hook
5 Top tether strap
Guide top tether strap 5 between
head restraint and top of seat backrest.
Securely fasten hook 1, which is part
of top tether strap 5, to respective
anchorage ring 2,3 , or 4. Make sure

the top tether strap is not twisted

the head restraint is installed and
positioned such that the top tether
strap can pass freely between the head
restraint and top of the seat backrest
Once the top tether anchorage hook is
attached, the child restraint itself can be
secured. Secure child restraint and tighten
the top tether strap according to the child
restraint manufacturer’s instructions.
iFor safety, make sure hook 1 has attached
to respective anchorage ring beyond the safety
catch, as shown in the illustration above.Warning!G
Use only the described anchorage rings for
the respective child seat. Other lashing
eyelets could tear in case of an accident.
Make sure

the fastening straps are not crossed or
twisted.

the hook is properly attached and is
closed.

W463.boo Seite 84 Montag, 19. November 2007 8:41 08

85
Safety and Security
Occupant safety
Blocking of rear door window operation
With the override switch you can disable
the rear side window switches in the rear
doors.
The override switch is located on the
driver’s door control panel.
1 Override switch
For more information on power windows,
see “Power windows” (
page 192). Disabling
Slide override switch
1 to the right.
Symbol 7 becomes visible.
The rear door windows can no longer
be operated using the switches located
in the rear doors.
Enabling
Slide override switch 1 to the left.
The rear door windows can again be
operated using the switches located in
the rear doors.
Warning!G
Activate the override switch when children
are riding in the back seats of the vehicle.
The children may otherwise injure them-
selves, e.g. by becoming trapped in the
window opening.
When leaving the vehicl e, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. A child’s
unsupervised access to a vehicle could
result in an accident and/or serious
personal injury.iOperating the rear door windows using the
switches located on the door control panel of the
driver’s door is still possible.
W463.boo Seite 85 Montag, 19. November 2007 8:41 08

110 Controls in detail
Seats
Rear seatsHead restraint height
Warning!G
According to accident statistics, children
are safer when properly restrained in the
rear seating positions than in the front seat-
ing position. Thus, we strongly recommend
that children be placed in the rear seats
whenever possible. Regardless of seating
position, children 12 years old and under
must be seated and properly secured in an
appropriately sized infant restraint, toddler
restraint, or booster seat recommended for
the size and weight of the child. For addi-
tional information, see “Children in the vehi-
cle” (
page 77).
A child’s risk of serious or fatal injuries is
significantly increased if the child restraints
are not properly secured in the vehicle
and/or the child is no t properly secured in
the child restraint.
Warning!G
Always lock seat backrest in its upright
position when rear seat bench is occupied
by passengers, or cargo is being carried
behind the rear seat bench.
To help avoid personal injury from smaller
objects flying in the occupant area during a
collision or sudden maneuver, always use
partition net when transporting cargo
(
page 210).
Warning!G
Do not drive the vehicle without the seat
head restraints installed when the rear seat
bench is occupied. Head restraints are
intended to help reduce injuries during an
accident.
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint in such a way that
it is as close to the head as possible and the
center of the head restraint supports the
back of the head at eye level. This will
reduce the potential fo r injury to the head
and neck in the event of an accident or
similar situation.
W463.boo Seite 110 Montag, 19 . November 2007 8:41 08

114 Controls in detail
Memory function
Prior to operating the vehicle, the driver
should check and adjust the seat height,
seat position fore and aft, and seat back-
rest angle if necessary, to ensure adequate
control, reach and comfort. The head
restraint should also be adjusted for
proper height. See also the section on
air bags (
page 70) for proper seat
positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, operation
and comfort. Both the interior and exterior
rear view mirrors should be adjusted for
adequate rear vision.
Fasten seat belts. Infants and small
children should be se ated in a properly
secured restraint system that complies
with U.S. Federal Motor Vehicle Safety
Standards 213 and 225 and Canadian
Motor Vehicle Safety Standards 213 and
210.2. With the memory function you can store up
to three different configurations.
Each stored position on the driver’s side
includes the following settings:

Seat position

Multicontour seat*: previously saved
setting

Steering wheel position

Exterior rear view mirrors’ position
Each stored position on the passenger side
includes the following settings:

Seat position

Multicontour seat*: previously saved
setting
Warning!G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.
W463.boo Seite 114 Montag, 19
. November 2007 8:41 08

195
Controls in detail
Power tilt/sliding sunroof
 Power tilt/sliding sunroof
Opening and closing
The tilt/sliding sunroof is opened and
closed electrically. The switch for the
tilt/sliding sunroof is located on the
overhead control panel.
Sunroof switch
1 Push up to raise sunroof at rear
2 Pull down to lower sunroof at rear
3 Push forward to slide sunroof closed
4 Push back to slide sunroof open
Warning!G
When closing the tilt/s liding sunroof, make
sure there is no danger of anyone being
harmed by the closing procedure.
The opening procedure of the tilt/sliding
sunroof can be immediately halted by
releasing the switch or, if the switch was
moved past the resistance point and
released, by moving the switch in any
direction.
The closing procedure of the tilt/sliding sun-
roof can be immediatel y halted by releasing
the switch.
The closing procedure of the tilt/sliding sun-
roof can be immediately reversed by moving
the switch in direction 1 or4.
In a vehicle rollover, occupants not wearing
their seat belts or not wearing them properly
may be thrown out of the opening. Such an
opening also presents a potential for injury
for occupants wearing their seat belts prop-
erly as entire body part s or portions of them
may protrude from the passenger compart-
ment.
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Unsuper-
vised use of vehicle equipment can cause an
accident and/or seri ous personal injury.
!To avoid damaging the seals, do not trans-
port any objects with sharp edges which can
stick out of the tilt/sliding sunroof.
Do not open the tilt/sliding sunroof if there is
snow or ice on the roof, as this could result in
malfunctions.
The tilt/sliding sunroof can be opened or closed
manually should an elect rical malfunction occur
(
page 372).
W463.boo Seite 195 Montag, 19 . November 2007 8:41 08

335
Practical hints
What to do if …
Lamp in center console
ProblemPossible cause/consequenceSuggested solution
56The front passenger front air
bag off indicator lamp comes
on and remains illuminated.A BabySmartTM child seat is installed on
the front passenger seat. Therefore the
passenger front air bag is switched off.
The system is malfunctioning when there
is no BabySmartTM child seat installed on
the front passenger seat.
Have the system checked at an
authorized Mercedes-Benz Light
Truck Center as soon as possible.
The front passenger front air
bag off indicator lamp does not
come on or does not remain
illuminated with a
BabySmart
TM child seat
properly installed on the front
passenger seat.
The system is malfunctioning.Make sure there is nothing between
seat cushion and child seat and check
installation of the child seat.
If the front passenger front air bag off
indicator lamp remains out, have the
system checked at an authorized
Mercedes-Benz Light Truck Center as
soon as possible.
Do not use the BabySmart
TM restraint
to transport children on the front
passenger seat until the system has
been repaired.
W463.boo Seite 335 Montag, 19 . November 2007 8:41 08