2008 MERCEDES-BENZ G55AMG oil level

273
Operation
Engine compartment
Adding engine oil
G500
1
Filler cap
G55AMG
1Filler cap
Unscrew filler cap 1 from filler neck.
Add engine oil as required. Never over-
fill with oil.
Be careful not to spill any oil when adding.
Avoid environmental damage caused by oil
entering the ground or water.
Screw filler cap 1 back on filler neck.
For more information on engine oil, see the
“Technical data” section (
page 421) and
(
page 423).
Transmission fluid level
The transmission fluid level does not need
to be checked. If you notice transmission
fluid loss or gear shifting malfunctions,
have an authorized Mercedes-Benz Light
Truck Center check the automatic trans-
mission.
!Only use approved engine oils and oil filters
required for vehicles with Maintenance System
(U.S. vehicles) or FSS (Canada vehicles). For a
listing of approved engine oils and oil filters,
refer to the Factory Approved Service Products
pamphlet (USA only) in your vehicle literature
portfolio, or contact an authorized
Mercedes-Benz Light Truck Center.
Using engine oils and oil filters of specification
other than those expressly required for the
Maintenance System (U.S. vehicles) or FSS
(Canada vehicles), or changing of oil and oil filter
at change intervals longer than those called for
by the Maintenance System (U.S. vehicles) or
FSS (Canada vehicles) will result in engine or
emission control system damage not covered by
the Mercedes-Benz Limited Warranty.
!Excess oil must be siphoned or drained off.
It could cause damage to the engine and/or
catalytic converter not covered by the
Mercedes-Benz Limited Warranty.
W463.boo Seite 273 Montag, 19 . November 2007 8:41 08

279
Operation
Tires and wheels
Tread depth
Do not allow your tires to wear down too
far. Adhesion properties on wet roads are
sharply reduced at tread depths of less
than
1/8in (3 mm).
Treadwear indicators (TWI) are required by
law. These indicators are located in six
places on the tread circumference and
become visible at a tread depth of approx-
imately
1/16in (1.6 mm), at which point the
tire is considered worn and should be
replaced.
Recommended minimum tire tread depth:

Summer tires 1/8in (3 mm)

Winter tires 1/6in (4 mm) 1
TWI (T
read Wear Indicator)
The treadwear indicator appears as a solid
band across the tread.
Storing tires
Cleaning tires
Warning!G
Although the applicable federal motor safety
laws consider a tire to be worn when the
treadwear indicators (T WI) become visible at
approximately
1/16in (1.6 mm), we recom-
mend that you do not allow your tires to
wear down to that level. As tread depth
approaches
1/8in (3 mm), the adhesion
properties on a wet road are sharply
reduced.
Depending upon the weather and/or road
surface (conditions), the tire traction varies
widely.
!Keep unmounted tires in a cool, dry place
with as little exposure to light as possible.
Protect tires from contact with oil, grease and
gasoline.
!Never use a round nozzle to power wash
tires. The intense jet of water can result in
damage to the tire.
Always replace a damaged tire.
W463.boo Seite 279 Montag, 19 . November 2007 8:41 08

312 Operation
Maintenance
Clearing the maintenance service
indicator message
The maintenance service indicator
message is automatically cleared

after approximately 10 seconds when
you switch on the ignition or when
reaching the maintenance service
threshold while driving

after approximately 30 seconds, once
the suggested maintenance service
term has passedYou can also clear maintenance service
indicator message yourself.
1 Reset button
Press reset button 1 on the instru-
ment cluster.
The maintenance service indicator
message is cleared and the standard
display appears in the multifunction
display (
page 140).
iVehicles equipped with Maintenance
System (U.S. vehicles) only:
The Maintenance System in your vehicle tracks
distance driven and the time elapsed since the
last maintenance service and calculates other
maintenance service work required.
iVehicles equipped with FSS (Flexible Service
S
ystem) (Canada vehicles) only:

FSS evaluates engine temperature, oil level,
vehicle speed, engine speed, distance driven
and the time elapsed since the last
maintenance service and calculates other
maintenance service work required.

The interval between maintenance services
depends on your driving habits. A gentle
driving style, moderate engine speeds and
the avoidance of short-distance trips will
lengthen the interval between services.
W463.boo Seite 312 Montag, 19 . November 2007 8:41 08

313
Operation
Maintenance
Maintenance service term exceeded
If you have exceeded the suggested
maintenance service term, you will see the
following message in the multifunction
display:
Service A exceeded by XX Days
Service A exceeded by XX miles (km)
In addition, a signal sounds when the
message appears.
Any authorized Merced
es-Benz Light Truck
Center will reset the maintenance service
indicator following a completed mainte-
nance service.
Calling up the maintenance service
indicator display
You can call up the maintenance service
indicator display at any time to check
when the next maintenance service is due.
Switch on the ignition (page 39).
Press button è orÿ on the mul-
tifunction steering wheel repeatedly
until the standard display appears in
the multifunction display (
page 140).
Press button k orj on the
multifunction steering wheel until the
maintenance service indicator display
with the maintenance service
symbol 9 or´ and the service
deadline appears in the multifunction
display. Resetting the maintenance service
indicator
In the event that the maintenance service
on your vehicle is not carried out at an
authorized Mercedes-Benz Light Truck
Center, you can have the maintenance
service indicator reset. The automotive
maintenance facility carrying out the main-
tenance service will find the information
for resetting the maintenance service indi-
cator in the maintenance-relevant informa-
tion for your vehicle. Such information is
available from any authorized
Mercedes-Benz Light Truck Center or
directly from Mercedes-Benz.
iIf the battery is disconnected, the days of
disconnection will not be included in the count
shown by the maintenance service indicator. To
arrive at the true maintenance service deadline,
you will need to subtract these days from the
days shown in the maintenance service indicator
message or maintenance service indicator
display.
Do not confuse the maintenance service indica-
tor with the engine oil level indicator :.
!If the maintenance service indicator was
inadvertently reset, have an authorized
Mercedes-Benz Light Truck Center correct it.
Only reset if the proper maintenance service has
been performed. Resetting the system without
performing the proper maintenance service as
called for by the maintenance service indicator
will result in engine damage and/or other vehicle
damage not covered by the Mercedes-Benz
Limited Warranty.
W463.boo Seite 313 Montag, 19 . November 2007 8:41 08

349
Practical hints
What to do if …
When the message At next gas station
add 1.0 qt engine oil

(Canada:
1.0 liter) appears while the
engine is running and at operating
temperature, the engine oil level has
dropped to approximately the minimum
level.
When this occurs, the warning will first
come on intermittently and then stay on if
the oil level drops further. Visually check for oil leaks. If no oil leaks
are noted, continue to drive to the nearest
service station where the engine oil should
be topped to the required level with an
approved engine oil. For information on
approved engine oils, refer to the Factory
Approved Service Products pamphlet
(USA only) or contact an authorized
Mercedes-Benz Light Truck Center.
Display symbolDisplay messagePossible cause/consequencePossible solution
:USA only:
At next
gas station
add
1.0 qt
engine oil
Canada only:
At next
gas station
add
1.0 liter
engine oil
The engine oil level is too low.Add engine oil (page 273) and check
the engine oil level (
page 270).
W463.boo Seite 349 Montag, 19 . November 2007 8:41 08

350 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
:Engine oil
level
Stop, turn
engine offThere is no oil in the engine. There is
a danger of engine damage.Stop the vehicle in a safe location or as soon as
it is safe to do so.
Turn off the engine.
Add engine oil (page 273) and check the
engine oil level (
page 270).
Engine oil
level
Visit
workshopThe engine oil has dropped to a
critical level.Check the engine oil level (page 270) and add
engine oil as required (
page 273).
If you must add engine oil frequently, have the
engine checked for possible leaks.
You have added too much engine oil.
There is a risk of damaging the engine
and/or the catalytic converter.Have excess oil siphoned or drained off.
Observe all legal requirements with respect to
its disposal.
It may be that there is water in the
engine oil.Have the engine oil checked at an authorized
Mercedes-Benz Light Truck Center.
The measuring system is malfunction-
ing.Have the measuring system checked at an
authorized Mercedes-Benz Light Truck Center.
!The engine oil level warnings should not be
ignored. Extended driving with the symbol
displayed could result in serious engine damage
that is not covered by the Mercedes-Benz
Limited Warranty.
W463.boo Seite 350 Montag, 19 . November 2007 8:41 08

426 Technical data
Fuels, coolants, lubricants, etc.
The coolant solution must be used year
round to provide the necessary corrosion
protection and increase boil-over protec-
tion. Refer to Maintenance Booklet for
replacement interval.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze
solution or other Mercedes-Bent approved
products of equal specification are used to
renew the coolant concen tration or bring it
back up to the proper level.
For information on other Mercedes-Benz
approved products of equal specification,
refer to the Factory Approved Service
Products pamphlet (USA only) or contact
an authorized Mercedes-Benz Light Truck
Center. To provide important corrosion protection,
the solution must be at least
50% anticorrosion/antifreeze (equivalent
to freeze protection to approximately
-35°F [-37°C]). If you use a solution that is
more than 55% anticorrosion/antifreeze
(freeze protection to approximately
-49°F [-45°C]), the engine temperature
will increase due to the lower heat transfer
capability of the so
lution. Therefore,
do not use more than this amount of
anticorrosion/antifreeze.
If the coolant level is low, water and
MB 325.0 Anticorrosion/Antifreeze
should be used to bring it up to the proper
level (have cooling system checked for
signs of leakage). Please make sure the
mixture is in accordance with label
instructions.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality,
contact an authoriz ed Mercedes-Benz
Light Truck Center. Anticorrosion/antifreeze
Your vehicle contains a number of
aluminum parts. The use of aluminum
components in motor vehicle engines
necessitates that anticorrosion/antifreeze
coolant used in such engines be
specifically formulated to protect the
aluminum parts. Failure to use such
anticorrosion/antifreeze coolant will
result in a significantly shortened service
life.
Therefore, the followin
g product is strongly
recommended for use in your vehicle:
Mercedes-Benz
325.0 Anticorrosion/Antifreeze agent.
Before the start of the winter season (or
once a year in hot southern regions), you
should have the anticorrosion/antifreeze
concentration checked. The coolant is also
regularly checked each time you bring your
vehicle to an authorized Mercedes-Benz
Light Truck Center for service.
W463.boo Seite 426 Montag, 19 . November 2007 8:41 08

432 Index
Cargo tie-down rings 209
Carpets, Cleaning 321
Catalytic converter 262
CD changer 366
CD playerOperating 143
Center console 30 Front passenger front air bag off indica-tor lamp 335
Lower part 31
Upper part 30
Central locking From inside 107
Switch 107
Switching on/off (control system) 155
Unlocking from inside 107
Central unlocking Switch 107
Certification label 410
Charging Vehicle battery 396 Checking
Coolant level 266, 274
Oil level 266, 269
Checking tire pressure electronically with the Advanced Tire Pressure Monitoring
System (Advanced TPMS) 289
Checklist Off-road driving 254
Child safety 77 Infant and child restraint systems 68, 78
LATCH child seat anchors 82
Child safety switch see Blocking of rear door window operation
Cigarette lighter 222
Cleaning Gear selector lever 321
Headlamps 177
Headliner 321
Leather upholstery 322
Light alloy wheels 320
Rear Parking Assist sensors 318, 319
Seat belts 321
Steering wheel 321 Upholstery 322
Windows 319
Windshield 59
Wiper blades 319
Wood trims 322
Cleaning tires 279
Climate control 182 Adjusting air distribution 186
Adjusting air volume 186
Air conditioning 189
Air recirculation mode 188
Defogging windshield 188
Defrosting 187
Rear window defroster 181
Residual heat utilization (REST) 190
Setting the temperature 185
Windshield defroster 180
Clock 27
Closing Glove box 215
Hood 269
Tailgate 106
Tilt/sliding sunroof 196, 372
Windows 192
Closing tilt/sliding sunroof In an emergency 372
W463.boo Seite 432 Montag, 19 . November 2007 8:41 08