2008 MERCEDES-BENZ G500 seat adjustment

33
At a glance
Door control panel
 Door control panel
ItemPage
1Switches for opening/closing
front and rear door windows192
Rear window override switch85
2Seat adjustment41,
108
3Inside door handle104
4Memory function (for storing
seat, exterior mirrors and
steering wheel settings)114
W463.boo Seite 33 Montag, 19. November 2007 8:41 08

39
Getting started
Unlocking
Press unlock button
Πon the
SmartKey.

All turn signal lamps flash once.

The locking knobs in the doors
move up.

The anti-theft alarm system is
disarmed.

The locator lighting comes on if the
feature is enabled in the control
system (
page 152).
Enter the vehicle and insert the
SmartKey in the starter switch.
For more information, see “Locking and
unlocking” (
page 100).
Starter switch positions
SmartKey
Starter switch
0 For removing SmartKey
The steering is locked when the
SmartKey is removed from the starter
switch.
1 Power supply for some electrical
consumers, such as seat adjustment
2 Ignition (power supply for all electrical
consumers) and driving position
All lamps (except high beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary. If
a lamp in the instrument cluster
remains on after starting the engine or
comes on while driving, refer to “Lamps
in instrument cluster” (
page 324).
3 Starting position
Warning!G
When leaving the vehicl e, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. A child’s
unsupervised access to a vehicle could
result in an accident and/or serious
personal injury.
W463.boo Seite 39 Montag, 19. November 2007 8:41 08

41
Getting started
Adjusting
 Adjusting
Seats
Warning!G
All seat, head restraint, steering wheel, and
rear view mirror adjustments, as well as fas-
tening of seat belts, must be done before
the vehicle is put into motion.
Warning!G
Do not adjust the driver’s seat while driving.
Adjusting the seat while driving could cause
the driver to lose control of the vehicle.
Never ride in a moving vehicle with the seat
back in an excessively reclined position as
this can be dangerous. You could slide
under the seat belt in a collision. If you slide
under it, the seat belt would apply force at
the abdomen or neck. That could cause
serious or fatal injuries.
The seat backrest and seat belts provide the
best restraint when the wearer is in a nearly
upright position and seat belts are properly
positioned on the body. Your seat must be
adjusted so that you can correctly fasten
your seat belt (
page 48).
Observe the following points:

Adjust the backrest until your arms are
slightly angled when holding the
steering wheel.

Adjust the seat to a comfortable seating
position that still a llows you to reach the
accelerator/brake pedal safely. The po-
sition should be as far back as possible
with the driver still able to operate the
controls properly.

Adjust the head restraint so that it is as
close to the head as possible and the
center of the head restraint supports
the back of the head at eye level.

Never place hands under the seat or
near any moving parts while a seat is
being adjusted.
Failure to do so could result in an accident
and/or serious personal injury.
Warning!G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle.
Even with the SmartKey removed from the
starter switch, the power seats can be
operated when the respective door is open.
Therefore, do not leave children unattended
in the vehicle, or with access to an unlocked
vehicle. A child’s unsupervised access to a
vehicle could result in an accident and/or
serious personal injury.
W463.boo Seite 41 Montag, 19. November 2007 8:41 08

42 Getting started
Adjusting
Seat adjustment
The seat adjustment switches are located
on the respective front door.1 Head restraint height
2 Seat backrest tilt
3 Seat fore and aft adjustment
4 Seat cushion tilt
5 Seat height
Switch on the ignition (page 39).
or
Open the respective front door.
Warning!G
According to accident statistics, children
are safer when properly restrained in the
rear seating positions than in the front seat-
ing position. Thus, we strongly recommend
that children be placed in the rear seats
whenever possible. Regardless of seating
position, children 12 years old and under
must be seated and properly secured in an
appropriately sized infant restraint, toddler
restraint, or booster seat recommended for
the size and weight of the child. For addi-
tional information, see “Children in the vehi-
cle” (
page 77).
A child’s risk of serious or fatal injuries is
significantly increased if the child restraints
are not properly secured in the vehicle
and/or the child is no t properly secured in
the child restraint.
!When moving the seat, make sure

there are no items in the footwell or behind
the seat

the cup holder next to the armrest is
removed (
page 219)

the cup holder in the front passenger
footwell is folded closed (
page 220)
Otherwise you could damage the seat and/or
cup holders.
iThe memory function (page 114) lets you
store the setting for the seat position together
with the settings for the steering wheel and the
exterior rear view mirrors.
W463.boo Seite 42 Montag, 19. November 2007 8:41 08

43
Getting started
Adjusting
Seat fore and aft adjustment
Press the switch forward or backward
in direction of arrow
3.
Seat cushion tilt
Press the switch up or down in
direction of arrow 4 until your upper
legs are lightly supported.
Seat backrest tilt
Press the switch forward or backward
in direction of arrow 2.
Seat height
Press the switch up or down in
direction of arrow 5.
Make sure you have sufficient head-
room. Head restraint height
Press the switch up or down in
direction of arrow
1. Head restraint fore and aft adjustment
Manually adjust the angle of the head
restraint.
Adjust the head restraint to the desired
position by pushing or pulling on the
upper edge of the head restraint cush-
ion.
For more information, see “Seats”
(
page 108).
Warning!G
Do not drive the vehicle without the seat
head restraints. Head restraints are
intended to help reduce injuries during an
accident.
For your protection, drive only with properly
positioned and engaged head restraints.
Adjust the head restraint in such a way that
it is as close to the head as possible and the
center of the head restraint supports the
back of the head at eye level. This will
reduce the potential fo r injury to the head
and neck in the event of an accident or
similar situation.
W463.boo Seite 43 Montag, 19. November 2007 8:41 08

44 Getting started
Adjusting
Steering wheelSteering wheel adjustment
Make sure that

you can reach the steering wheel with
your arms slightly bent at the elbows,

you can move your legs freely

all displays (incl. malfunction and indi-
cator lamps) on the instrument cluster
are clearly visibleThe steering wheel adjustment stalk is
located on the lower left of the steering
column.
1 Adjusting steering wheel, in or out
2 Adjusting steering wheel, up or down
Switch on the ignition (page 39).
or
Open the driver’s door.
Warning!G
Do not adjust the steering wheel while
driving. Adjusting the steering wheel while
driving could cause the dr iver to lose control
of the vehicle.
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle.
Even with the SmartKey removed from the
starter switch, the steering wheel adjust-
ment feature can be operated when the
driver’s door is open. Therefore, do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. A child’s
unsupervised access to a vehicle could
result in an accident and/or serious
personal injury.
iThe memory function (page 114) lets you
store the setting for the steering wheel together
with the settings for the seat position and the
exterior rear view mirrors.
W463.boo Seite 44 Montag, 19. November 2007 8:41 08

47
Getting started
Adjusting
The buttons are located above the exterior
lamp switch.
1 Adjustment button
2 Driver’s side exterior rear view mirror
button
3 Passenger-side exterior rear view
mirror buttonSwitch on the ignition (page 39).
Press button 2 for the driver’s side
exterior rear view mirror or button 3
for the passenger-side exterior rear
view mirror.
Push adjustment button 1 up, down,
left, or right according to the desired
setting. For more information, see “Storing exterior
rear view mirror parking position (Canada
only)” (
page 116).!If an exterior rear view mirror housing is
forcibly pushed forward (hit from the rear) or
rearward (hit from the front), reposition it by
applying firm pressure until it snaps into place.
The exterior rear view mirror housing is now
properly positioned and you can adjust the
mirror in the usual manner.
iAt low ambient temperatures, the exterior
rear view mirrors will be heated automatically.
iThe memory function (page 114) lets you
store the setting for the exterior rear view mir-
rors together with the settings for the steering
wheel and the seat position.
W463.boo Seite 47 Montag, 19. November 2007 8:41 08

52 Getting started
Driving
Opening the rear center seat belt
Press release button6 on buckle 5
for the free-sliding latch plate
(
page 50).
Press release button 3 on buckle 2
for the fixed latch plate (
page 50).
Storing the rear center seat belt
Allow the retractor to completely
rewind the rear center seat belt by
guiding latch plate 1 (
page 51).
Guide both latch plates 4 and 7
once after the other into
attachment 1 (
page 50). Seat belt outlet height adjustment
You can adjust the height of the seat belt
guide for the following seats:

Driver’s seat

Front passenger seat

Rear outer seats
Adjust seat belt so that the shoulder
portion is located as close as possible to
the middle of the shoulder (it should not
touch the neck).
1 Release button Raising
Slide the seat belt guide upward in
desired position.
The seat belt guide engages in five
different positions.
Lowering
Pull and hold release button 1.
Slide the seat belt guide downward in
desired position.
Let go of release button 1.
Make sure that the seat belt guide en-
gages into place.
Please comply with the instructions for
“Proper use of seat belts” (
page 53).Warning!G
To help prevent the possibility of injury,
always store the rear center seat belt latch
plates in the attachment when the rear
center seat belt is not in use.
W463.boo Seite 52 Montag, 19. November 2007 8:41 08