2008 MERCEDES-BENZ G500 oil temperature

Contents
Operation......................................... 243
The first 1 000 miles (1 500 km) ......... 244
Driving instructions ............................ 245 Drive sensibly – save fuel ............. 245
Drinking and driving ..................... 245
Pedals .......................................... 245
Power assistance ......................... 246
Brakes .......................................... 246
Driving off..................................... 247
Parking ......................................... 248
Tires ............................................. 248
Hydroplaning ................................ 249
Tire traction .................................. 249
Tire speed rating .......................... 250
Winter driving instructions ........... 251
Standing water ............................. 252
Passenger compartment .............. 252
Off-road driving ............................ 253
Driving abroad .............................. 261
Control and operation of radio
transmitters.................................. 261
Catalytic converter ....................... 262
Emission control........................... 263
Coolant temperature .................... 263 At the gas station .............................. 264
Refueling ...................................... 264
Check regularly and before a
long trip........................................ 265
Engine compartment ......................... 267 Hood ............................................ 267
Engine oil ..................................... 269
Transmission fluid level ................ 273
Coolant level ................................ 274
Windshield/rear window washer
system and headlamp
cleaning system ........................... 275
Tires and wheels ................................ 277 Important guidelines .................... 277
Tire care and maintenance ........... 278
Direction of rotation ..................... 280
Loading the vehicle ...................... 280
Recommended tire inflation
pressure ....................................... 286
Checking tire inflation pressure ... 288
Tire labeling.................................. 294
Load identification ....................... 298
DOT, Tire Identification Number
(TIN) ............................................. 299
Maximum tire load ....................... 300
Maximum tire inflation pressure .. 301 Uniform Tire Quality Grading
Standards (U.S. vehicles) ............. 302
Tire ply material ........................... 304
Tire and loading terminology........ 304
Rotating tires ............................... 307
Winter driving .................................... 309 Winter tires .................................. 309
Block heater (Canada only) .......... 310
Snow chains................................. 310
Maintenance...................................... 311 Maintenance service indicator
message ...................................... 311
Calling up the maintenance
service indicator display .............. 313
Resetting the maintenance
service indicator .......................... 313
Vehicle care....................................... 314 Cleaning and care of the vehicle .. 314
W463.boo Seite 6 Montag, 19. November 2007 8:41 08

137
Controls in detail
Control system
Menus, submenus and functions
Menu
1Menu2Menu3Menu 4
Standard displayAudioNAVVehicle status message
memory1
1The vehicle status message memory menu is only displayed if there is a message stored.
(page 140)(page 141)(page 144)(page 144)
Commands/submenu
Trip- and main odometerSelecting radio stationRoute guidance instructions,
current direction traveledCalling up malfunction
messages, warning messages,
and system status messages
stored in memory
Checking tire inflation
pressureSelecting satellite radio
station* (USA only)
Calling up digital speedometer
or outside temperatureOperating CD player
Calling up maintenance
service indicator
Checking engine oil level
iThe headings used in the menus table are
designed to facilitate navigation within the
system and are not necessarily identical to those
shown in the control system displays. The first function displayed in each menu will
automatically show you which part of the system
you are in.
W463.boo Seite 137 Montag, 19
. November 2007 8:41 08

140 Controls in detail
Control system
Standard display menu
In the standard display, the main odometer
and the trip odometer appear in the multi-
function display.
Standard display
1 Trip odometer
2 Main odometer If you see another display instead of the
standard display:
Press button
è orÿ repeatedly
until the standard display appears in
the multifunction display.
Press button k orj to select
the functions in the standard display
menu.
The following functions are available: Calling up digital speedometer or
outside temperature
Press button
k orj repeatedly
until the digital speedometer or the
outside temperature appears in the
multifunction display.
Digital speedometer
FunctionPage
Checking tire inflation pressure288
Calling up digita l speedometer or
outside temperature140
Calling up maintenance service
indicator313
Checking engine oil level270
W463.boo Seite 140 Montag, 19 . November 2007 8:41 08

271
Operation
Engine compartment
If necessary, add engine oil
(
page 273).
For more information on engine oil, see the
“Technical data” section (
page 421) and
(
page 423).
Other display messages
If the SmartKey is not turned to position 2
in the starter switch, the following
message will appear:
Switch
ignition on to
check engine
oil level
Switch on the ignition (page 39).
If you see the message:
Observe
waiting time
If the engine is at operating
temperature, wait 5 minutes before
repeating check procedure.
If the engine is not at operating
temperature yet, wait 30 minutes
before repeating check procedure.
If you see the message:
Engine oil
level
Not with
engine on
Turn off the engine.
If the engine is at operating
temperature, wait 5 minutes before
checking oil.
If the engine is not at operating
temperature yet, you must wait
30 minutes before checking oil.
If there is excess engine oil with the engine
at operating temperature, the following
message will appear:
Engine oil
level
Reduce oil
level
Have excess oil siphoned or drained
off. Contact an authorized
Mercedes-Benz Light Truck Center.
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
page 349).
!Excess oil must be siphoned or drained off.
It could cause damage to the engine and/or
catalytic converter not covered by the
Mercedes-Benz Limited Warranty.
iG 500 only:
Perform the engine oil level check with the oil
dipstick if it cannot be completed with the
control system (
page 272).
In this case we recommend that you have the
system checked at a Mercedes-Benz Light Truck
Center.
W463.boo Seite 271 Montag, 19 . November 2007 8:41 08

272 Operation
Engine compartment
Checking engine oil level with the oil
dipstick (G 500 only)
When checking the oil level

the vehicle must be parked on level
ground

with the engine at operating
temperature, the vehicle must have
been stationary for at least 5 minutes
with the engine turned off

with the engine not at operating
temperature yet, the vehicle also must
have been stationary for at least
5 minutes with the engine turned off
Open the hood (page 267).1
Oil dipstick
2 Upper mark
3 Lower mark
Pull out oil dipstick 1.
Wipe oil dipstick 1 clean.
Fully insert oil dipstick 1 into the
dipstick guide tube.
Pull out oil dipstick 1 again after
approximately 3 seconds to obtain
accurate reading.
The oil level is correct when it is
between lower mark 3 (min.) and
upper mark 2 (max.) of the oil
dipstick.
If necessary, add engine oil
(
page 273).
For more information on engine oil, see the
“Technical data” section (
page 421) and
(
page 423).
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
page 349).
iThe filling quantity between the upper and
lower marks on the oil dipstick is approximately
2.1 US qt (2.0 l).
W463.boo Seite 272 Montag, 19 . November 2007 8:41 08

312 Operation
Maintenance
Clearing the maintenance service
indicator message
The maintenance service indicator
message is automatically cleared

after approximately 10 seconds when
you switch on the ignition or when
reaching the maintenance service
threshold while driving

after approximately 30 seconds, once
the suggested maintenance service
term has passedYou can also clear maintenance service
indicator message yourself.
1 Reset button
Press reset button 1 on the instru-
ment cluster.
The maintenance service indicator
message is cleared and the standard
display appears in the multifunction
display (
page 140).
iVehicles equipped with Maintenance
System (U.S. vehicles) only:
The Maintenance System in your vehicle tracks
distance driven and the time elapsed since the
last maintenance service and calculates other
maintenance service work required.
iVehicles equipped with FSS (Flexible Service
S
ystem) (Canada vehicles) only:

FSS evaluates engine temperature, oil level,
vehicle speed, engine speed, distance driven
and the time elapsed since the last
maintenance service and calculates other
maintenance service work required.

The interval between maintenance services
depends on your driving habits. A gentle
driving style, moderate engine speeds and
the avoidance of short-distance trips will
lengthen the interval between services.
W463.boo Seite 312 Montag, 19 . November 2007 8:41 08

321
Operation
Vehicle care
Hard plastic trim items
Use Mercedes-Benz approved Interior
Care, a soft, lint-free cloth and apply
with light pressure.
Steering wheel and gear selector lever
Wipe with a damp cloth and dry
thoroughly or clean with
Mercedes-Benz approved Leather
Care.
Carpets
Use Mercedes-Benz approved Carpet
and Fabric Care for cleaning the
carpets.
Headliner
Use a soft bristle brush or a
dry-shampoo cleaner in case of
excessive dirt. Seat belts
Only use clear, lukewarm water and
soap.
!Do not use oil, wax or scouring agents on
these parts.
Never apply strong force and only use a soft,
non-scratching cloth when cleaning the surface.
Do not attempt to wipe the surface with a dry
cloth or sponge.
Otherwise you may scratch or damage the
surface.
!Never apply strong force and only use a soft,
non-scratching cloth when cleaning the surface.
Do not attempt to wipe the surface with a dry
cloth or sponge.
Otherwise you may scratch or damage the
surface.
!The seat belts must not be treated with
chemical cleaning agents. Do not dry the seat
belts at temperatures above 176°F (80°C) or in
direct sunlight.
Warning!G
Do not bleach or dye seat belts as this may
severely weaken them. In a crash they may
not be able to provide adequate protection.
W463.boo Seite 321 Montag, 19 . November 2007 8:41 08

349
Practical hints
What to do if …
When the message At next gas station
add 1.0 qt engine oil

(Canada:
1.0 liter) appears while the
engine is running and at operating
temperature, the engine oil level has
dropped to approximately the minimum
level.
When this occurs, the warning will first
come on intermittently and then stay on if
the oil level drops further. Visually check for oil leaks. If no oil leaks
are noted, continue to drive to the nearest
service station where the engine oil should
be topped to the required level with an
approved engine oil. For information on
approved engine oils, refer to the Factory
Approved Service Products pamphlet
(USA only) or contact an authorized
Mercedes-Benz Light Truck Center.
Display symbolDisplay messagePossible cause/consequencePossible solution
:USA only:
At next
gas station
add
1.0 qt
engine oil
Canada only:
At next
gas station
add
1.0 liter
engine oil
The engine oil level is too low.Add engine oil (page 273) and check
the engine oil level (
page 270).
W463.boo Seite 349 Montag, 19 . November 2007 8:41 08