259
Operation
Driving instructions
When driving over tree stumps, big rocks
and other obstacles, observe the following
rules:
Check the vehicle clearance before
crossing obstacles.
Comply with the warnings
(
page 253) and rules for off-road
driving (
page 253).
Select gear range 1 on the automatic
transmission (
page 167).
Cross obstacles very slowly by aiming
one of the front wheels at the center of
the obstacle, and repeat same with the
rear wheel. Driving on sand
When driving on sand, observe the
following rules:
Avoid high engine speeds.
Shift automatic transmission into a
gear range that is appropriate for the
terrain.
In sandy soil, drive at a steady speed as
conditions permit. This helps overcome
the vehicle rolling resistance and
reduce the likelihood of the vehicle
sinking into the ground.
Drive in tracks of other vehicles if they
are not too deep and you have suffi-
cient clearance.
Ruts
A number of off-road tracks or other
byways have deep ruts which can cause
the underbody to come in contact with the
ground.
!Special attention is needed when you cross
obstacles on a steep incline.
The vehicle could slide sideways as a result of its
possible slanted position which in turn may
result in the vehicle tipping or rolling over.
Warning!G
Do not reduce the tire inflation pressure
before driving through sand. However, if you
do so, remember to correct the tire inflation
pressure (
page 288) before continuing
your trip. Driving with reduced tire inflation
pressure increases the risk of losing control
of the vehicle and rolling over.
!Check that the ruts are not too deep and
your vehicle’s clearance is sufficient. Otherwise:
your vehicle may be damaged
the underbody of the vehicle may come in
contact with the ground and you may get
stuck
W463.boo Seite 259 Montag, 19 . November 2007 8:41 08
261
Operation
Driving instructions
Check tires for possible damage.
Inspect frame, oil pan, brake hoses,
etc., as well as vehicle underbody for
possible damage.
Check for brush or br
anches caught in
the underbody.
After continued operation in mud,
sand, water or other dirty conditions,
clean the brake discs, wheels, brake
pads, and check and clean axle joints.
Conduct a brake test.
Driving abroad
Abroad, there is an extensive
Mercedes-Benz service network at your
disposal. If you plan to drive into areas
which are not listed in the index of a
Mercedes-Benz Light Truck Center
directory, you should request pertinent
information from an authorized
Mercedes-Benz Light Truck Center. Control and operation of radio
transmitters
COMAND, radio and telephone*
!Brush or branches could increase the possi-
bility of a fire, as well as cut fuel and/or brake
lines, puncture rubber be llows of the axles or
drive shafts.
Warning!G
Do not forget that your primary responsi-
bility is to drive the vehicle safely. Only
operate the COMAND system, radio or
telephone
1 if road, weather and traffic
conditions permit.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
1Observe all legal requirements.
W463.boo Seite 261 Montag, 19 . November 2007 8:41 08
266 Operation
At the gas station
G55AMG
1Coolant
2 Brake fluid Brake fluid
Coolant
For normal replenishing, use water
(potable water quality).
For more information, see “Coolant level”
(
page 274) and see “Fuels, coolants, lu-
bricants, etc.” (
page 420). Engine oil level
For more information on engine oil, see
“Engine oil” (
page 269).
Windshield/rear window washer sys-
tem and headlamp cleaning system
For more information on refilling the
washer reservoir, see “Windshield/rear
window washer syst em and headlamp
cleaning system” (
page 275).
Vehicle lighting
Check function and cleanliness.
For information on replacing light bulbs,
see “Replacing bulbs” (
page 375).
For more information, see “Exterior lamp
switch” (
page 117).
Tire inflation pressure
For more information, see “Checking tire
inflation pressure” (
page 288).
!If you find that the brake fluid in the brake
fluid reservoir has fallen to the minimum mark or
below, have the brake system checked for brake
pad thickness and leaks immediately. Notify an
authorized Mercedes-Benz Light Truck Center
immediately. Do not add brake fluid as this will
not solve the problem.
For more information, see “Practical hints”
(
page 326) and see “Brake fluid”
(
page 423).
W463.boo Seite 266 Montag, 19 . November 2007 8:41 08
267
Operation
Engine compartment
Engine compartment
Hood
Opening
Warning!G
Do not pull the release lever while the vehi-
cle is in motion. Otherwise the hood could
be forced open by passing air flow.
This could cause the hood to come loose
and injure you and others.
Warning!G
If you see flames or smoke coming from the
engine compartment, or if the coolant tem-
perature display indicates that the engine is
overheated, do not open the hood. Move
away from vehicle and do not open the hood
until the engine has cooled. If necessary,
call the fire department.
Warning!G
You could be injured when the hood is open
– even when the engi ne is switched off.
Parts of the engine can become very hot. To
prevent burns, let the engine cool off com-
pletely before touching any components on
the vehicle. Comply with all relevant safety
precautions.
Warning!G
To help prevent personal injury, stay clear of
moving parts when the hood is open and the
engine is running.
The radiator fan may continue to run for
approximately 30 seconds or even restart
after the engine has b een turned off. Stay
clear of fan blades.
Warning!G
The engine is equipped with a transistorized
ignition system. Becaus e of the high voltage,
it is dangerous to touch any components
(ignition coils, spark plug sockets,
diagnostic socket) of the ignition system
with the engine running
while starting the engine
if ignition is “on” and the engine is
turned manually
W463.boo Seite 267 Montag, 19 . November 2007 8:41 08
269
Operation
Engine compartment
ClosingLower hood and let it drop into lock
from a height of approximately 0.7 ft
(20 cm).
The hood will lock audibly.
Check to make sure the hood is fully
closed.
If you can raise the hood at a point
above the turn signals to the left and
right of the hood, then it is not properly
closed. Open it again and let it drop
with somewhat greater force.
Engine oil
The amount of oil your engine needs will
depend on a number of factors, including
driving style. Higher
oil consumption can
occur when
the vehicle is new
the vehicle is driven frequently at
higher engine speeds
Engine oil consumption checks should only
be made after the vehicle break-in period.
Warning!G
When closing the hood, use extreme caution
not to catch hands or fi ngers. Be careful that
you do not close the hood on anyone.
Make sure that the hood is securely
engaged before driving off. Do not continue
driving if the hood can no longer engage
after an accident, for example. The hood
could otherwise come loose while the
vehicle is in motion and endanger you and
others.
!Do not push the hood closed manually, as
this could damage it. !Do not use any special lubricant additives,
as these may damage the drive assemblies.
Using special additives not approved by
Mercedes-Benz may cause damage not covered
by the Mercedes-Benz Limited Warranty.
More information on this subject is available at
any Mercedes-Benz Light Truck Center.
W463.boo Seite 269 Montag, 19 . November 2007 8:41 08
270 Operation
Engine compartment
Checking engine oil level with the
control system
When checking the oil level
the vehicle must be parked on level
ground
with the engine at operating tempera-
ture, the vehicle must have been sta-
tionary for at least 5 minutes with the
engine turned off
with the engine not at operating tem-
perature yet, the vehicle must have
been stationary for at least 30 minutes
with the engine turned off
To check the engine oil level via the
multifunction display, do the following:
Switch on the ignition (page 39).
The standard display (
page 140)
should appear in the multifunction
display.
Press button k orj on the
multifunction steering wheel until the
following message appears in the
multifunction display:
One of the following messages will
subsequently appear in the multi-
function display:
Engine oil
level
OK
Add
1.0 qt
to reach
maximum
oil level
(Canada: 1.0 liter)
Add
1.5 qts
to reach
maximum
oil level
(Canada: 1.5 liters)
Add
2.0 qts
to reach
maximum
oil level
(Canada: 2.0 liters)
iIf you want to interrupt the checking
procedure, press button k orj on the
multifunction steering wheel.
W463.boo Seite 270 Montag, 19 . November 2007 8:41 08
271
Operation
Engine compartment
If necessary, add engine oil
(
page 273).
For more information on engine oil, see the
“Technical data” section (
page 421) and
(
page 423).
Other display messages
If the SmartKey is not turned to position 2
in the starter switch, the following
message will appear:
Switch
ignition on to
check engine
oil level
Switch on the ignition (page 39).
If you see the message:
Observe
waiting time
If the engine is at operating
temperature, wait 5 minutes before
repeating check procedure.
If the engine is not at operating
temperature yet, wait 30 minutes
before repeating check procedure.
If you see the message:
Engine oil
level
Not with
engine on
Turn off the engine.
If the engine is at operating
temperature, wait 5 minutes before
checking oil.
If the engine is not at operating
temperature yet, you must wait
30 minutes before checking oil.
If there is excess engine oil with the engine
at operating temperature, the following
message will appear:
Engine oil
level
Reduce oil
level
Have excess oil siphoned or drained
off. Contact an authorized
Mercedes-Benz Light Truck Center.
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
page 349).
!Excess oil must be siphoned or drained off.
It could cause damage to the engine and/or
catalytic converter not covered by the
Mercedes-Benz Limited Warranty.
iG 500 only:
Perform the engine oil level check with the oil
dipstick if it cannot be completed with the
control system (
page 272).
In this case we recommend that you have the
system checked at a Mercedes-Benz Light Truck
Center.
W463.boo Seite 271 Montag, 19 . November 2007 8:41 08
272 Operation
Engine compartment
Checking engine oil level with the oil
dipstick (G 500 only)
When checking the oil level
the vehicle must be parked on level
ground
with the engine at operating
temperature, the vehicle must have
been stationary for at least 5 minutes
with the engine turned off
with the engine not at operating
temperature yet, the vehicle also must
have been stationary for at least
5 minutes with the engine turned off
Open the hood (page 267).1
Oil dipstick
2 Upper mark
3 Lower mark
Pull out oil dipstick 1.
Wipe oil dipstick 1 clean.
Fully insert oil dipstick 1 into the
dipstick guide tube.
Pull out oil dipstick 1 again after
approximately 3 seconds to obtain
accurate reading.
The oil level is correct when it is
between lower mark 3 (min.) and
upper mark 2 (max.) of the oil
dipstick.
If necessary, add engine oil
(
page 273).
For more information on engine oil, see the
“Technical data” section (
page 421) and
(
page 423).
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
page 349).
iThe filling quantity between the upper and
lower marks on the oil dipstick is approximately
2.1 US qt (2.0 l).
W463.boo Seite 272 Montag, 19 . November 2007 8:41 08