Page 327 of 521

326 Operation
Engine compartment
CLK 63 AMG
1Oil dipstick
2Upper (max) mark
3Lower (min) markTo check the engine oil level with the oil
dipstick, do the following:
Open the hood (page 323).
Pull out oil dipstick1.
Wipe oil dipstick1 clean.
Fully insert oil dipstick1 into the
dipstick guide tube.
Pull out oil dipstick1 again after
approximately 3 seconds to obtain ac-
curate reading.
The oil level is correct when it is be-
tween the lower (min) mark3 and
upper (max) mark2 of oil dipstick1.
If necessary, add engine oil.
For adding engine oil, see “Adding en-
gine oil” (
page 327).
For more information on engine oil, see
“Fuels, coolants, lubricants, etc.”
(
page 489).
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
page 409).
iCLK 350:
The filling quantity between the upper and lower
marks on the oil dipstick is approximately
2.1 US qt. (2.0 l).
CLK 550 / CLK 63 AMG:
The filling quantity between the upper and lower
marks on the oil dipstick is approximately
1.6 US qt. (1.5 l).
Page 328 of 521

327 Operation
Engine compartment
Adding engine oil
CLK 350 / CLK 550
1Filler cap
CLK 63 AMG
1Filler cap
Unscrew filler cap1 from filler neck.
Add engine oil as required. Be careful
not to overfill with oil.
Be careful not to spill any oil when adding.
Avoid environmental damage caused by oil
entering the ground or water.
Screw filler cap1 back on filler neck.
More information on engine oil can be
found in the “Technical data” section
(
page 489) and (page 491).
Transmission fluid level
The transmission fluid level does not need
to be checked. If you notice transmission
fluid loss or gear shifting malfunctions,
have an authorized Mercedes-Benz Center
check the automatic transmission.
!Only use approved engine oils and oil filters
required for vehicles with Maintenance System.
For a listing of approved engine oils and oil fil-
ters, refer to the Factory Approved Service Prod-
ucts pamphlet (USA only) in your vehicle
literature portfolio, or contact an authorized
Mercedes-Benz Center.
Using engine oils and oil filters of specification
other than those expressly required for the
Maintenance System, or changing of oil and oil
filter at change intervals longer than those called
for by the Maintenance System will result in
engine or emission control system damage not
covered by the Mercedes-Benz Limited
Warranty.
!Excess oil must be siphoned or drained off.
It could cause damage to the engine and emis-
sion control system not covered by the
Mercedes-Benz Limited Warranty.
Page 495 of 521

494 Technical data
Fuels, coolants, lubricants, etc.
Coolants
The engine coolant is a mixture of water
and anticorrosion / antifreeze, which
provides:
Corrosion protection
Freeze protection
Boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -35°F (-37°C) and
corrosion protection.
If the antifreeze mixture is effective
to -35°F (-37°C), the boiling point of the
coolant in the pressurized cooling system
is reached at
approximately 266°F (130°C).The coolant solution must be used year
round to provide the necessary corrosion
protection and increase boil-over protec-
tion. Refer to Maintenance Booklet for re-
placement interval.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze solu-
tion or other Mercedes-Benz approved
products of equal specification are used to
renew the coolant concentration or bring it
back up to the proper level.
For information on other Mercedes-Benz
approved products of equal specification,
refer to the Factory Approved Service
Products pamphlet (USA only) or contact
an authorized Mercedes-Benz Center.To provide important corrosion protection,
the solution must be at least 50% anticor-
rosion/antifreeze (equivalent to freeze
protection to approximately -35°F
[-37°C]). If you use a solution that is more
than 55% anticorrosion/antifreeze (freeze
protection to approximately -49°F
[-45°C]), the engine temperature will in-
crease due to the lower heat transfer capa-
bility of the solution. Therefore, do not use
more than this amount of anticorro-
sion/antifreeze.
If the coolant level is low, water and
MB 325.0 Anticorrosion /Antifreeze
should be used to bring it up to the proper
level (have cooling system checked for
signs of leakage). Please make sure the
mixture is in accordance with label instruc-
tions.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality,
consult an authorized Mercedes-Benz
Center.
!Add premixed coolant solution only. Adding
water and MB 325.0 Anticorrosion/Antifreeze
separately from each other, could cause engine
damage not covered by the Mercedes-Benz
Limited Warranty
Page 503 of 521

502 Index
Roll bars, Lowering 431
Roll bars, Releasing 430
Soft top, Closing 432–439
Trunk lid, Releasing from inside 117
Trunk lid, Unlocking 428
Unlocking/locking
the vehicle 427, 428
Emergency tensioning device see ETD
Emergency, In case of
Battery, Jump starting 467
First aid kit 421
Flat tire, Changing 452
Fuses 472
Hazard warning flasher 135
Roadside Assistance 12, 298
Towing the vehicle 469
Emission control 318
Emission control information label 479
Emission system warranties 10Engine
Belt layout 480
Block heater (Canada only) 363
Break-in recommendations 308
Cleaning 369
Compartment 323
Malfunction indicator lamp 29, 381
Maximum engine speed 481
Message in display 405
Number 479
Starting 51
Starting difficulties 53
Starting with KEYLESS-GO* 52
Starting with SmartKey 52
Technical data 481
Turning off 60
Turning off with KEYLESS-GO* 60
Turning off with SmartKey 60
Engine coolant see CoolantEngine oil 325, 491
Adding 327, 491
Additives 491
Changing 327, 491
Checking level 322, 325
Consumption 325
Filler cap 327
Filler neck 327
Engine oil level 322
ESP
®92
Messages in display 394–395
Warning lamp 384
ETD 80
Safety guidelines 68
Exterior rear view mirrors 47, 186
Exterior view 22, 24