196 Controls in detail
Climate control
Deactivating
Press buttonP or0
(
page 191) again.
The indicator lamp on the button goes
out. Defrosting is turned off.
The previous settings are once again in
effect.
Windshield fogged on the outside
Switch the windshield wipers on
(
page 56).
If the automatic mode of the climate con-
trol is switched off:
Turn air distribution control4
toaorY(
page 191).
Air recirculation mode
Switch to air recirculation mode to prevent
unpleasant odors from entering the vehicle
from the outside (e.g. before driving
through a tunnel). This setting cuts off the
intake of outside air and recirculates the
air in the passenger compartment.
Activating
Press button, (page 191).
The indicator lamp on the button
comes on.Deactivating
Press button, (page 191).
The indicator lamp on the button goes
out.
iIf you have switched on the defrost function
using thePor0 button, you cannot
make any other settings.
iThe cooling remains switched on.
iKeep this setting selected only until the
windshield is clear again.
Warning!G
Fogged windows impair visibility, endanger-
ing you and others. If the windows begin to
fog on the inside, switching off the air
recirculation mode immediately should clear
interior window fogging. If interior window
fogging persists, make sure the air
conditioning (
page 198) is activated, or
press buttonP or0.
iThe air recirculation mode is activated auto-
matically at high outside temperatures.
The indicator lamp on button, is not lit when
the air recirculation mode is automatically
switched on.
A quantity of outside air is added after approxi-
mately 30 minutes.
iThe air recirculation mode is deactivated au-
tomatically:
after 5 minutes if the outside temperature is
below approximately 41°F (5°C)
after 5 minutes if the air conditioning is
turned off
after 30 minutes if the outside temperature
is above approximately 41°F (5°C)
206 Controls in detail
Automatic climate control
Adjusting air volume
Use buttonU (
page 201) for auto-
matic mode or air volume controls
orQ (
page 201) to adjust air volume
manually.
Seven blower speeds are available.
Press button to decrease
orQ (
page 201) to increase air
volume to the desired level.
The indicator lamp on the buttonU
goes out.
The automatic air distribution remains
switched on.
Front defroster
You can use this setting to defrost the
windshield, for example if it is iced up.
You can also defog the windshield and the
side windows.
Activating
Press buttonP or0
(
page 201).
The indicator lamp on the button
comes on.
The air conditioning switches
automatically to the following functions:
cooling on to dehumidify
maximum blowing and heating
power
air flows onto the windshield and
the front side windows
the air recirculation mode is
switched offDeactivating
Press buttonP or0
(
page 201) again.
The indicator lamp on the button goes
out.
The previous settings are once again in
effect.
Windshield fogged on the outside
Switch the windshield wipers on
(
page 56).
If the automatic mode of the automatic cli-
mate control is switched off:
Turn air distribution control1 or8
toa orY (
page 201).
iKeep this setting selected only until the
windshield or the side windows are clear again.
iIf you have switched on the defrost function
using thePor0 button, you cannot
make any other settings.
iThe cooling remains switched on.
iKeep this setting selected only until the
windshield is clear again.
324 Operation
Engine compartment
The hood lock release lever is located to
the left of the steering wheel under the
dashboard.
1Hood lock release lever
Pull lever 1 downwards.
The hood is unlocked.2Lever for opening the hood
Push lever2 under the hood upwards.
Pull up on the hood and then release it.
The hood will be automatically held
open at shoulder height by gas-filled
struts.Closing
Let the hood drop from a height of
approximately 1 ft (30 cm).
The hood will lock audibly.
Check to make sure the hood is fully
closed.
If you can raise the hood at a point
above the headlamps, then it is not
properly closed. Open it again and let it
drop with somewhat greater force.
!To avoid damage to the windshield wipers or
hood, never open the hood if the wiper arms are
folded forward away from the windshield.
Warning!G
When closing the hood, use extreme caution
not to catch hands or fingers.
Be careful that you do not close the hood on
anyone.
Make sure the hood is securely engaged be-
fore driving off. Do not continue driving if the
hood can no longer engage after an acci-
dent, for example. The hood could otherwise
come loose while the vehicle is in motion
and injure you and/or others.
370 Operation
Vehicle care
Soft top (CLK cabriolet)
Frequent cleaning reduces the
dirt-repellent effect of the soft top.
Intensive cleaning with Mercedes-Benz
car-care products for convertible soft tops
can help to restore the dirt-repellent
effect. Contact an authorized
Mercedes-Benz Center for detailed
information.
Light colored soft tops should be cleaned
frequently to prevent spots and dirt from
setting in, which could stain and discolor
the soft top material permanently.
Incorrect cleaning and care, as well as
ageing, can cause the soft-top seams to
leak. Have the soft-top seams sealed at a
Mercedes-Benz Center.!Make sure the windshield wiper switch is
set to0 (
page 56). Otherwise, e.g. the rain
sensor could activate and cause the wipers to
move unintentionally. This may lead to vehicle
damage.
Due to the width of the vehicle, fold in exterior
rear view mirrors prior to running the vehicle
through an automatic car wash to prevent
damage to the mirrors.
iAfter running the vehicle through an
automatic car wash, wipe any wax off of the
windshield (
page 373). This will prevent
smears and reduce wiping noise which can be
caused by residual wax on the windshield.
When leaving the car wash, make sure the mir-
rors are folded out. Otherwise they may vibrate.
iIf the soft top is kept in the storage
compartment for a lengthy period, raise it and air
out with the windows open about every
4months.
Place a suitable cover over the soft top if you are
leaving the vehicle parked in the open for an
extended period of time.
!Remove bird droppings immediately. The
organic acid damages the material and causes
the soft top to leak.
Never use a power washer to clean the soft top,
as you may damage the soft top material.
Do not use sharp-edged instruments for the
removal of ice and snow.
Never use hot-wax when you run the vehicle
through an automatic car wash, as you may
damage the soft top material.
373 Operation
Vehicle care
Cleaning the windows and the wiper
blades
Make sure the hood is fully closed.
Make sure the vehicle’s on-board
electronics have status0 (
page 38).
Fold the wiper arms forward until they
snap into place.
Clean the wiper blade inserts with a
clean cloth and detergent solution.
Use a soft, clean cloth and a mild
window cleaning solution on all outside
and inside glass surfaces.
An automotive glass cleaner is
recommended.
!Do not apply strong pressure to the sensor
covers. Applying strong pressure may damage
the sensor covers.
Follow the instructions provided by the power
washer manufacturer on maintaining a distance
between the vehicle and the nozzle of the power
washer.
!To prevent scratches, never apply strong
force and only use a soft, non-scratching cloth
when cleaning the sensors. Do not attempt to
wipe dirty sensors with a dry cloth or sponge.
!Never open the hood when the wiper arms
are folded forward.
Warning!G
For safety reasons, switch off wipers and
remove SmartKey from starter switch
(vehicles with KEYLESS-GO*: Make sure the
vehicle's on-board electronics have
status0) before cleaning the windshield
and/or the wiper blades. Otherwise, the
wiper motor could suddenly turn on and
cause injury.
!Do not pull on the wiper blade inserts. They
could tear.
!Fold the windshield wiper arms back onto
the windshield before turning the SmartKey in
the starter switch or pressing the KEYLESS-GO
start/stop button (vehicles with KEYLESS-GO*).
Hold on to the wiper when folding the wiper arm
back. If released, the force of the impact from
the tensioning spring could crack the windshield.
!To clean the window interior, do not use a
dry cloth, abrasives, solvents or cleaners
containing solvents. Do not touch the inside of
the front, rear or side windows with hard objects
such as an ice scraper or ring. Doing so may
damage the windows.
450 Practical hints
Replacing wiper blades
Removing and installing wiper blades
Remove SmartKey from starter switch
(vehicles with KEYLESS-GO*: make
sure the vehicle's on board electronics
have status 0).
Removing wiper blades
1Unlocking
2Tab
Pull the tab2 in the direction of
arrow1.
The wiper blade is unlocked.
Lift up the wiper arm as far as you need
to remove the wiper blade.
Carefully fold the wiper arm back to
rest on the windshield.
Warning!G
For safety reasons, switch off wipers and
remove SmartKey from starter switch
(vehicles with KEYLESS-GO*: make sure the
vehicle’s on-board electronics have
status0) before replacing a wiper blade.
Otherwise, the wiper motor could suddenly
turn on and cause injury.
Warning!G
Wiper blades are components that are sub-
ject to wear and tear. Replace the wiper
blades twice a year, preferably in the spring
and fall. Otherwise the windows will not be
properly wiped. As a result, you may not be
able to observe surrounding traffic condi-
tions and could cause an accident.
!Never open the hood when the wiper arms
are folded forward.
For your convenience, we recommend that you
have this work carried out at an authorized
Mercedes-Benz Center.
!Do not pull on the wiper blade inserts. They
could tear.
!Hold on to the wiper arm. If released, the
force of the impact from the tensioning spring
could crack the windshield.
517 Index
W
Warning indicators
Parktronic system*
(Canada only) 273
Warning sounds
Driver’s or passenger’s seat belt 79
Parking brake 54
Parktronic system*
(Canada only) 273, 274
Seat belt telltale 386
Warranty coverage 10, 477
Washer fluid see Windshield washer fluid
Washer reservoir level 490
Washing the vehicle 367
Wear pattern, Tires 361
Weights, Vehicle 488
Wheel
Bolts 426
Change 458
Collapsible wheel chock 422
Removing 460
Spare 458
Tightening torque 462
TIREFIT (CLK 63 AMG only) 422
Wrench 422
Wheels, Sizes 483Wheels, Tires and 331
Wind screen 265
Window curtain air bags 70
Windows see Power windows
Windshield
Cleaning 57, 373
Defogging 196, 206
Windshield washer fluid 330, 496
Message in display 420
Mixing ratio 496
Refilling 330
Reservoir level 490
Wiping 57
Windshield washer system 490, 496
Windshield wipers 56
Cleaning wiper blades 373
Replacing wiper blades 450
Winter driving 362
Block heater (Canada only) 363
Snow chains 363
Tires 362
Winter driving instructions 316
Winter tires 362
Wood trims, cleaning 376