378 Practical hints
What to do if …?
Lamps in instrument clusterGeneral information:
If any of the following lamps in the instru-
ment cluster fails to come on during thebulb self-check when switching on the igni-
tion, have the respective bulb checked and
replaced if necessary.
ProblemPossible cause/consequenceSuggested solution
-The yellow ABS indicator lamp
comes on while the engine is
running.The ABS has detected a malfunction and has
switched off. The BAS and the ESP® are also
switched off (see messages in the multifunc-
tion display).
The brake system is still functioning normally
but without the systems specified above.
If the ABS control unit is malfunctioning,
other systems such as the navigation
system* or the automatic transmission may
also be malfunctioning.
Continue driving with added caution.
Wheels will lock during hard braking,
reducing steering capability.
Read and observe messages in the
multifunction display (
page 394).
Have the system checked at an autho-
rized Mercedes-Benz Center as soon
as possible.
Failure to follow these instructions in-
creases the risk of an accident.
The charging voltage has fallen below
10 volts. The ABS has switched off. The BAS
and the ESP
® are also switched off (see mes-
sages in the multifunction display)
The battery might not be charged sufficiently.
Switch off electrical consumers that
are currently not needed, e.g. seat
heating*.
If necessary, have the generator and
battery checked.
When the voltage is above this value
again, the ABS is operational again.
392 Practical hints
What to do if …?
Vehicle status messages in the
multifunction display
Warning and malfunction messages
appear in the multifunction display located
in the instrument cluster.
Certain warning and malfunction messag-
es are accompanied by an audible signal.
Address these messages accordingly and
follow the additional instructions given in
this Operator’s Manual.
Selecting the vehicle status message
memory menu in the control system
(
page 154) displays both cleared and
uncleared messages.
High-priority messages appear in the
multifunction display in red color.Certain messages of high priority cannot
be cleared from the multifunction display
using the reset button (
page 138) or but-
ton k,j, è, orÿ on the
steering wheel.
Other messages of high priority and
messages of less immediate priority can
be cleared from the multifunction display
using the reset button (
page 138) or
buttonk,j, è, orÿ on the
steering wheel. They are then stored in the
vehicle status message memory
(
page 154). Remember that clearing a
message will only make the message dis-
appear. Clearing a message will not cor-
rect the condition that caused the
message to appear.
Warning!G
All categories of messages contain
important information which should be
taken note of and, where a malfunction is
indicated, addressed as soon as possible at
an authorized Mercedes-Benz Center.
Failure to repair condition noted may cause
damage not covered by the Mercedes-Benz
Limited Warranty, or result in property
damage or personal injury.
393 Practical hints
What to do if …?
On the pages that follow, you will find a
compilation of the most important warning
and malfunction messages that may
appear in the display.
High priority messages appear in red color.
For your convenience the messages are
divided into two sections:
Text messages (page 394)
Symbol messages (page 403)
Warning!G
No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
As a result, you will not be able to see infor-
mation about your driving conditions, such
as speed or outside temperature, warn-
ing/indicator lamps, malfunction/warning
messages or the failure of any systems.
Driving characteristics may be impaired.
If you must continue to drive, please do so
with added caution. Visit an authorized
Mercedes-Benz Center as soon as possible.
iSwitching on the ignition causes all
instrument cluster lamps (except low beam
headlamp indicator lamp, high beam headlamp
indicator lamp, and turn signal indicator lamps
unless activated) as well as the multifunction dis-
play to come on. Make sure the lamps and the
multifunction display are in working order before
starting your journey.
397 Practical hints
What to do if …?
Display messagePossible cause/ consequencePossible solution
Monitor the 56indicator lamp on the center console (page 31) and
the multifunction display in the instrument cluster (
page 28) for the following:
With the seat unoccupied and the ignition turned on,
the 56indicator lamp on the center console should illuminate and
remain illuminated, indicating that the OCS (
page 72) has deactivated the
air bag.
the message Front Passenger Airbag Enabled See Operator’s Manual or
the message
Front Passenger Airbag Disabled See Operator’s Manual
should not appear in the multifunction display at any time the seat is unoc-
cupied. Wait at least 60 seconds for the system to complete the necessary
check cycles and to make sure neither message appears in the multifunc-
tion display.
If above conditions are met, you can occupy the front passenger seat again. De-
pending on the front passenger classification sensed by the OCS (
page 72),
the 56indicator lamp will remain illuminated or go out.
If above conditions are not met, the system is not working properly. Have the
system checked as soon as possible at an authorized Mercedes-Benz Center.
Warning!G
If the 56indicator lamp remains
out even after performing the above correc-
tive steps, do not have any children 12 years
old and under and other small individuals use the front passenger seat until the sys-
tem has been repaired.
399 Practical hints
What to do if …?
Display messagePossible cause/ consequencePossible solution
Monitor the 56indicator lamp on the center console (page 31) and
the multifunction display in the instrument cluster (
page 28) for the following:
With the seat unoccupied and the ignition turned on,
the 56indicator lamp on the center console should illuminate and
remain illuminated, indicating that the OCS (
page 72) has deactivated the
air bag.
the message Front Passenger Airbag Enabled See Operator’s Manual or
the message
Front Passenger Airbag Disabled See Operator’s Manual
should not appear in the multifunction display at any time the seat is unoc-
cupied. Wait at least 60 seconds for the system to complete the necessary
check cycles and to make sure neither message appears in the multifunc-
tion display.
If above conditions are met, you can occupy the front passenger seat again. De-
pending on the front passenger classification sensed by the OCS (
page 72),
the 56indicator lamp will remain illuminated or go out.
If above conditions are not met, the system is not working properly. Have the
system checked as soon as possible at an authorized Mercedes-Benz Center.
Warning!G
If the 56indicator lamp remains
illuminated with an adult occupant on the
front passenger seat even after performing
the above corrective steps, do not have anypassenger use the front passenger seat until
the system has been repaired.
407 Practical hints
What to do if …?
During severe operating conditions and
stop-and-go city traffic, the coolant tem-
perature may rise close to 248°F (120°C).
Display symbolDisplay messagePossible cause/consequencePossible solution
•Observe the coolant temperature indicator in
the instrument cluster (
page 28).
If the temperature rises again:
Contact an authorized Mercedes-Benz
Center immediately.
•The cooling fan for the coolant is mal-
functioning.Observe the coolant temperature indicator in the
instrument cluster (
page 28).
Have the fan replaced as soon as possible.
Warning!G
Driving when your engine is overheated can
cause some fluids which may have leaked
into the engine compartment to catch fire.
You could be seriously burned.
Steam from an overheated engine can cause
serious burns which can occur just by open-
ing the hood. Stay away from the engine if
you see or hear steam coming from it.
Turn off the engine, get out of the vehicle
and do not stand near the vehicle until the
engine has cooled down.!The engine should not be operated with the
coolant temperature above 248°F (120°C). Do-
ing so may cause serious engine damage which
is not covered by the Mercedes-Benz Limited
Warranty.
453 Practical hints
Flat tire
Foreign objects (e.g. screws or nails)
should not be removed from the tire.
Take TIREFIT, the sticker, and the
electric air pump out of the trunk
(
page 422).
Two-part sticker
1Sticker for instrument cluster
2Sticker for wheel
Attach sticker part 1 where it will be
easily seen by the driver on the instru-
ment cluster.
Attach sticker part 2 to the damaged
tire (close to the tire valve).
Warning!G
Take care not to allow the contents of
T I R E F I T t o c o m e i n c o n t a c t w i t h h a i r , e y e s o r
clothing. TIREFIT is harmful if inhaled,
swallowed or absorbed through the skin -
causes skin, eye and respiratory irritation.
Any contact with eyes or skin should be
flushed immediately with plenty of water.
If clothing comes in contact with TIREFIT,
change clothing as soon as possible.
In case of allergic reaction or rash, consult a
physician immediately.
Warning!G
Keep TIREFIT out of reach of children.
If swallowed, rinse mouth immediately with
plenty of water and drink plenty of water.
Do not induce vomiting!
Consult a physician immediately.
Keep away from open flame or heat source.
iIf sealant has leaked out, let it dry. You can
then peel it off.
Warning!G
Observe safety instructions on air pump
label.
iYour vehicle may be equipped with either of
two versions of the electric air pump:
Version 1
The air hose with pressure gauge and the
electrical plug are located behind a flap.
Version 2
The pressure gauge is located in the pump
housing.
The following description applies to both
versions. Differences in usage are expressly
declared.
500 Index
Control system menus 144, 145
AMG 148
AUDIO 151
NAV* 153
Settings 155
Settings, Submenus 156
Standard display 147
Submenus 143
TEL* 169
Trip computer 167
Vehicle status message memory 154
Control system submenus 143, 145, 157
Convenience 166
Instrument cluster 158
Lighting 162
Time/Date 160
Vehicle 165Coolant 328, 494
Adding 328
Anticorrosion/antifreeze
mixing ratio and quantity 494
Capacities 489
Checking coolant level 328
Messages in display 405–407
Temperature 319
Temperature indicator 139
Warning lamp 382
Coolants 494
Corner-illuminating front fog lamps* 133
Replacing bulbs 444
Cruise control 267
Canceling 269
Cruise control lever 267
Current speed 268
Fine adjustment 270
Higher speed 269
Last stored speed ("Resume"
function) 270
Slower speed 270
Cup holder 288
Curb weight 358D
Date 160
Date, Setting 161, 162
Daytime running lamp mode 131
Setting 162
Deep water see Standing water
Defogging
Windshield 196, 206
Defrosting, Front 195, 206
Defrosting, Rear 189
Delayed shut-off
Exterior lamps 164
Interior lighting 165
Department of Transportation see DOT
Difficulties
With starting 53
Digital speedometer 147
Dimensions, Vehicle 488
Direction of rotation (tires) 334
Displays
Digital speedometer 147
Lap analysis 151
Maintenance service indicator 364
Messages in display 392
Multifunction display 141
Outside temperature 140