2008 MERCEDES-BENZ CLK550 set clock

321 Operation
At the gas station
Take off the fuel cap and set it in the di-
rection of arrow 2 in the recess on the
fuel filler flap.
To prevent fuel vapors from escaping
into open air, fully insert the filler noz-
zle unit.
Only fill your tank until the filler nozzle
unit cuts out – do not top off or
overfill.
Replace the fuel cap by turning it
clockwise until it audibly engages.
Close the fuel filler flap.
Warning!G
Overfilling of the fuel tank may create
pressure in the system which could cause a
gas discharge. This could cause the gas to
spray back out when removing the fuel
pump nozzle, which could cause personal
injury.
iMake sure to close the fuel filler flap before
locking your vehicle as the flap locking pin
prevents closing after you have locked the
vehicle.
iOnly use premium unleaded gasoline with a
minimum Posted Octane Rating of 91 (average
of 96 RON / 86 MON).
Information on gasoline quality can normally be
found on the fuel pump. Please contact gas sta-
tion personnel in case labels on the pump cannot
be found.
For more information on gasoline, see “Premium
unleaded gasoline” (
page 492), or the Factory
Approved Service Products pamphlet (USA only),
or contact an authorized Mercedes-Benz Center.
iLeaving the engine running and the fuel cap
open can cause theú malfunction indicator
lamp (USA only) or the± malfunction indica-
tor lamp (Canada only) to illuminate.
More information can be found in the “Practical
hints” section (
page 381).

423 Practical hints
Where will I find...?
Example CLK coupe
3Arrow
4Minispare wheel
5Vehicle tool kit storage well casing
6Vehicle tool kit
Remove vehicle tool kit6.Storing the vehicle tool kit
Place vehicle tool kit6 in vehicle tool
kit storage well casing5.
Place storage well casing2 over the
vehicle tool kit storage well casing5
and turn retaining screw1 clockwise
as far it will go to secure the Minispare
wheel.
Disengage the handle in upper edge of
trunk and lower trunk floor cover
(
page 421).Vehicle jack
iArrow3 on vehicle tool kit storage well
casing5 must point in the direction of travel.
Otherwise you cannot place the storage well
casing2 on top and secure the Minispare
wheel with retaining screw1.
!To prevent damage, always disengage trunk
floor handle from upper edge of trunk and lower
trunk floor before closing the trunk.
Warning!G
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into both sides of the vehicle. To help
avoid personal injury, use the jack only to lift
the vehicle during a wheel change. Never
get beneath the vehicle while it is supported
by the jack. Keep hands and feet away from
the area under the lifted vehicle. Always
firmly set parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use,
especially on hills. Always try to use the jack
on level surface. Make sure the jack arm is
fully seated in the jack take-up bracket.
Always lower the vehicle onto sufficient
capacity jackstands before working under
the vehicle.

424 Practical hints
Where will I find...?
The vehicle jack is located in the storage
compartment underneath the trunk floor.
Storage position
Remove vehicle jack from its
compartment.
Turn crank handle in direction of arrow
as far as it will go.
Operational position
Turn crank handle clockwise.
Before storing the vehicle jack in its
compartment:

It should be fully collapsed.

The handle must be folded in (storage
position).Setting up the collapsible wheel chock
The collapsible wheel chock serves to
additionally secure the vehicle, e.g. while
changing the wheel.
1Tilt the plate upward
2Fold the lower plate outward
3Insert the plate

466 Practical hints
Battery
Charging and reinstalling the battery
Charge battery in accordance with the
instructions of the battery charger
manufacturer.
Reinstall the charged battery. Follow
the previously described steps in
reverse order.
Reconnecting the battery
Turn off all electrical consumers.
Remove SmartKey from starter switch.
Vehicles with KEYLESS-GO*:
Open the driver’s door.
Connect the battery positive lead and
fasten its cover3 (
page 465).
Connect the battery negative lead 2
(
page 465).
Reinstall the filter box (page 464).Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12-volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
Warning!G
Never charge a battery while still installed in
the vehicle unless the accessory battery
charge unit approved by Mercedes-Benz is
being used. Gases may escape during charg-
ing and cause explosions that may result in
paint damage, corrosion or personal injury.
An accessory battery charge unit specially
adapted for Mercedes-Benz vehicles and
tested and approved by Mercedes-Benz is
available, permitting the charging of the bat-
tery in its installed position. Contact an au-
thorized Mercedes-Benz Center for
information and availability. Charge battery
in accordance with the separate instruc-
tions for the accessory battery charger.
!The battery, its filler caps and the ventilation
hose must always be securely installed when the
vehicle is in operation.
!Always connect the battery in the order
described below. Otherwise the vehicle’s
electronics can be damaged.
!Never invert the terminal connections!
iThe following procedures must be carried
out following any interruption of battery power
(e.g. due to reconnecting):

Set the clock (page 160). Vehicles with
COMAND*: see COMAND operator’s manu-
al.

Synchronize the side windows
(
page 252).

Synchronize the tilt/sliding sunroof* (CLK
coupe) (
page 258).

499 Index
C
California retail buyers and
lessees, Important notice for 11
Call priority (Tele Aid) 300
Can holder see Cup holder
Capacities and
recommended fuels/lubricants 489
Cargo area see Trunk
Cargo tie-down rings 284
Carpets, cleaning 375
Catalytic converter 318
CD changer* 229
MP3 230
CD player 229
Control system 152
Center console 31
Lower part 32
Upper part 31
Central locking
Automatic 118, 166
Locking/unlocking from inside 119
Central locking switch 119
Certification label 478
Certification label, examples 478
Charcoal filter 209Checking tire pressure electronically
Tire Pressure Monitoring System
(TPMS), (USA only) 344
Children in the vehicle 83
Air bags 83
Blocking
rear side window operation 88
Front passenger front
air bag off indicator lamp 76
Infant and
child restraint systems 77, 83, 86
LATCH-type child seat anchors 87
Occupant Classification System
(OCS) 72
Cigarette lighter 290
Climate control
see Climate control system
Climate control system
Air conditioning refrigerant 491
Air conditioning, Cooling 198, 210
Air distribution 194, 205
Air recirculation mode 196, 207
Air vents 199, 212
Air volume 194, 195, 206
Charcoal filter 209Control panel,
Automatic climate control 201
Deactivating/Reactivating 193, 203
Defogging 206
Defrosting 206
Defrosting, rear window 189
Front defroster 195
MAXCOOL 207
Residual engine heat
and ventilation* (REST*) 211
Temperature 194, 204
Clock 29, 140, 160
Setting time 160
Cockpit 26
Cold tire inflation pressure 358
Collapsible wheel chock 422, 424
COMAND* see separate
COMAND operating instructions
Combination switch 55, 133
Control system 141
Functions 143, 145
Multifunction display 141
Multifunction steering wheel 142
Resetting to factory default 155