2008 MERCEDES-BENZ CLK350 ignition

393 Practical hints
What to do if …?
On the pages that follow, you will find a
compilation of the most important warning
and malfunction messages that may
appear in the display.
High priority messages appear in red color.
For your convenience the messages are
divided into two sections:

Text messages (page 394)

Symbol messages (page 403)
Warning!G
No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
As a result, you will not be able to see infor-
mation about your driving conditions, such
as speed or outside temperature, warn-
ing/indicator lamps, malfunction/warning
messages or the failure of any systems.
Driving characteristics may be impaired.
If you must continue to drive, please do so
with added caution. Visit an authorized
Mercedes-Benz Center as soon as possible.
iSwitching on the ignition causes all
instrument cluster lamps (except low beam
headlamp indicator lamp, high beam headlamp
indicator lamp, and turn signal indicator lamps
unless activated) as well as the multifunction dis-
play to come on. Make sure the lamps and the
multifunction display are in working order before
starting your journey.

396 Practical hints
What to do if …?
Display messagePossible cause/consequencePossible solution
Front Passenger
Airbag Enabled
See Operator’s ManualFront passenger front air bag is
activated while driving even though
a child, small individual, or object
below the system’s weight
threshold is on the front passenger
seat, or the front passenger seat is
empty. Objects on the seat or
forces acting on the seat may
make the system sense supple-
mental weight.Stop the vehicle in a safe location as soon as possible and check the
front passenger seat for the following:
Switch off the ignition (page 38).
Remove child and child restraint from front passenger seat and
properly secure the child in rear seat employing the child restraint
if necessary.
Make sure no objects applying supplemental weight onto the seat
are present. The system may recognize such supplemental weight
and sense that an occupant on the front passenger seat is of a
greater weight than actually present.
Keep the seat unoccupied, close the front passenger door and
switch on the ignition (
page 38).
(Continued on next page)

397 Practical hints
What to do if …?
Display messagePossible cause/ consequencePossible solution
Monitor the 56indicator lamp on the center console (page 31) and
the multifunction display in the instrument cluster (
page 28) for the following:
With the seat unoccupied and the ignition turned on,

the 56indicator lamp on the center console should illuminate and
remain illuminated, indicating that the OCS (
page 72) has deactivated the
air bag.

the message Front Passenger Airbag Enabled See Operator’s Manual or
the message
Front Passenger Airbag Disabled See Operator’s Manual
should not appear in the multifunction display at any time the seat is unoc-
cupied. Wait at least 60 seconds for the system to complete the necessary
check cycles and to make sure neither message appears in the multifunc-
tion display.
If above conditions are met, you can occupy the front passenger seat again. De-
pending on the front passenger classification sensed by the OCS (
page 72),
the 56indicator lamp will remain illuminated or go out.
If above conditions are not met, the system is not working properly. Have the
system checked as soon as possible at an authorized Mercedes-Benz Center.
Warning!G
If the 56indicator lamp remains
out even after performing the above correc-
tive steps, do not have any children 12 years
old and under and other small individuals use the front passenger seat until the sys-
tem has been repaired.

398 Practical hints
What to do if …?
Display messagePossible cause/consequencePossible solution
Front Passenger
Airbag Disabled
See Operator’s ManualFront passenger front air bag is
deactivated while driving even
though an adult or someone larger
than a small individual is
occupying the front passenger
seat. Forces acting on the seat
may make the system sense a
decrease in weight.Stop the vehicle in a safe location as soon as possible and check the
front passenger seat for the following:
Switch off the ignition (page 38).
Have the front passenger vacate the seat and exit the vehicle.
Keep the seat unoccupied, close the front passenger door and
switch on the ignition (
page 38).
(Continued on next page)

399 Practical hints
What to do if …?
Display messagePossible cause/ consequencePossible solution
Monitor the 56indicator lamp on the center console (page 31) and
the multifunction display in the instrument cluster (
page 28) for the following:
With the seat unoccupied and the ignition turned on,

the 56indicator lamp on the center console should illuminate and
remain illuminated, indicating that the OCS (
page 72) has deactivated the
air bag.

the message Front Passenger Airbag Enabled See Operator’s Manual or
the message
Front Passenger Airbag Disabled See Operator’s Manual
should not appear in the multifunction display at any time the seat is unoc-
cupied. Wait at least 60 seconds for the system to complete the necessary
check cycles and to make sure neither message appears in the multifunc-
tion display.
If above conditions are met, you can occupy the front passenger seat again. De-
pending on the front passenger classification sensed by the OCS (
page 72),
the 56indicator lamp will remain illuminated or go out.
If above conditions are not met, the system is not working properly. Have the
system checked as soon as possible at an authorized Mercedes-Benz Center.
Warning!G
If the 56indicator lamp remains
illuminated with an adult occupant on the
front passenger seat even after performing
the above corrective steps, do not have anypassenger use the front passenger seat until
the system has been repaired.

405 Practical hints
What to do if …?
Display symbolDisplay messagePossible cause/consequencePossible solution
úVisit workshopThere may be a malfunction in the

fuel injection system

ignition system

exhaust system

fuel system
Have the measuring system checked
at an authorized Mercedes-Benz Cen-
ter.
B Top Up
Coolant
See Operator’s Man.The coolant level is too low.Add coolant (page 328).
If you have to add coolant frequently,
have the cooling system checked at
an authorized Mercedes-Benz Center.
Warning!G
Do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which
may burn if it comes into contact with hot
engine parts. You could be seriously burned.
!Do not ignore the low engine coolant level
warning. Extended driving with the message and
symbol displayed may cause serious engine
damage not covered by the Mercedes-Benz
Limited Warranty.
Do not drive without sufficient amount of coolant
in the cooling system. The engine will overheat,
causing major engine damage.

470 Practical hints
Towing the vehicle
Installing towing eye bolt
Towing eye bolt CLK 350
1Cover on right side of front bumper2Cover on right side of rear bumper
To remove cover:
Press mark on cover 1 or 2.
Lift cover off to reveal the threaded
hole for towing eye bolt.
The towing eye bolt is supplied with the
tool kit (located in the compartment under-
neath the trunk floor).
Screw towing eye bolt in to its stop and
tighten with wheel wrench.
To reinstall cover:
Fit cover 1 or 2 and snap into place.
!Towing of the vehicle should only be done
using the properly installed towing eye bolt.
Never attach tow cable, tow rope or tow rod to
the vehicle chassis, frame or suspension parts.
iWhen towing the vehicle with all wheels on
the ground, please note the following:
With the automatic central locking activated and
the SmartKey in starter switch position2, or
KEYLESS-GO* start/stop button in position2,
the vehicle doors lock if the left front wheel as
well as the right rear wheel are turning at vehicle
speeds of approximately 9 mph (15 km / h) or
more.
To prevent the vehicle door locks from locking,
deactivate the automatic central locking
(
page 166).
iTo signal turns while being towed with the
hazard warning flasher in use, switch on the
ignition and activate the combination switch for
the left or right turn signal in the usual manner –
only the selected turn signal will operate.
Upon canceling the turn signal, the hazard
warning flasher will operate again.
iIf the battery is disconnected or discharged

the SmartKey will not turn in the starter
switch. For more information, see “Battery”
(
page 464) and “Jump starting”
(
page 467).

the gear selector lever will remain locked in
positionP. For information on manually un-
locking the transmission gear selector lever,
see (
page 429).

505 Index
High beam headlamps 133
Indicator lamp 29
Messages in display 412
Replacing bulbs (Bi-Xenon*) 444
Replacing bulbs (Halogen) 444, 446
Replacing bulbs for
high beam flasher (Bi-Xenon*) 447
Switching on 55
High mounted brake lamp 444
Hood 323
Horn 27
HVAC see Climate control system
Hydroplaning 314I
Identification labels 478
Identification number,
Vehicle (VIN) 478, 479
Ignition
with KEYLESS-GO* 40
with SmartKey 38
Immobilizer 97
Indicator lamps see
Lamps, indicator and warning
Infant and child restraint systems see
Children in the vehicle
Inflation pressure see
Tires, Inflation pressure
Inside door handle 34, 109
Instrument cluster 28, 138
Illumination brightness 138
Lamps in 378–387
Messages in display see
Multifunction display messages
Multifunction display 141
Instrument lighting see Instrument
cluster, Illumination brightness
Instrument panel see Instrument cluster
Instruments and controls see CockpitInterior lighting 136
Delayed shut-off 165
Interior rear view mirror 47, 186
Antiglare position 185
Auto-dimming 186
Interior storage spaces see
Storage compartments
J
Jack 422
Jacking up the vehicle 459
Jump starting 467