178 Voice Control
Overview
Canceling the dialog
Press the L button.
or
Say the command “Cancel” (except
when creating and storing voice tags,
navigation entries or during individual-
ization).
or
Press any button on COMAND.
Adjusting the volume
Start the dialog.
Give a command, e.g. “Help”.
Press the æ or ç button.
The volume increases or decreases
during voice output.
or
Set the volume for the voice output on
the volume control for COMAND.
Display messages
The audible help function can be supple-
mented by visual help on the display
(
page 167). If the help function is
switched on, the most important com-
mands that are currently possible appear
in the display when you start the dialog.
In the address book and navigation sys-
tem, a selection list is shown in the display
if voice control requires additional informa-
tion from you.
1Display
Entering numbers
Digits from “zero” to “nine” are permit-
ted.
Say the phone number in groups of
three to five digits.
Spell
The letters of the alphabet and the
numbers 0 - 9 are permitted.
Say the letters in groups of five to sev-
en letters.
Say each individual letter clearly.
i Using individualization, you can fine-tune
voice control to your own voice and thus improve
voice recognition. The process of individualiza-
tion is described in chapter “System Settings”
(
page 167).
i If you use individualization, it may impair
recognition of other users. Switch off individual-
ization if it makes recognition of other users
worse.
187 Voice Control
Navigation
Example of dialog:
sEnter Street
tPlease say the name of the street
sMabel’s Street
uThe system shows a numbered list
of street names on the display
tPlease select a line number.
sNumber three
tNumber three accepted
The street name is stored for route guid-
ance.
“Correction”
If you have entered or spelled a city or
street, you can use the “Correction” com-
mand to enter the city or street again or
spell it from the beginning.
“House number”
You can use the “House number” com-
mand to specify the house number for the
selected street in individual digits.Example of dialog:
sHouse number
tPlease say the house number in sin-
gle digits
sThree four
tThree four
sOkay
The house number is stored for route guid-
ance.
“Point of interest” (POI)
You can use the “Point of interest” com-
mand to select specific destinations (filling
stations, airports, stations, etc.).
Example of dialog:
sPoint of interest
uThe system shows the following list
in the display:
1 Current position
2 Other town
tPlease select a line number.
sLine number 1 ...
tLine number 1 accepted.uThe system shows a numbered list
of POI categories
tPlease select a line number or say
the category name
sLine number 5 ...
tNumber 5 accepted
uThe system shows a numbered list
with destinations from the selected
category
tPlease select a line number.
sLine number 1 ...
tLine number 1 accepted.
The specific destination which has the
number one is stored for route guidance.
i Depending on the selected area, other lists
may be shown.
You can only select points of interest in the
state or province the navigation system is
set for.
