LOCKS
Always check the Owner’s Manual for more operating information and safety features
Integrated Keyhead
Transmitter (IKT)*
1. LockPress button; pr essing again
within 3 seconds causes doors
to relock, horn to beep.
2. Unlock Press to unlock driver’s door;
press again within 3 seconds
to unlock other doors.
3. Panic alarm Press and hold 1 1/2 seconds
to activate, horn sounds; press again to stop, or turn ignition
to ON or START position, functions
only with ignition in LOCK position.
4. Liftgate Press twice within 3 seconds
to open liftgate glass.
Tip: One step unlocking of all
doors, liftgate and liftgate
glass is available; to enable
one step door unlocking, press
and hold and for 4 seconds,
parking lights flash twice; to
reset to two step door unlocking,
repeat procedure.
Illuminated entry system
Press unlock button on (IKT)
Integrated Keyhead Transmitter,
interior lights come on; lights
turn off after 25 seconds or
with ignition in ON position.
Tip: Perimeter lamps illuminated
entry feature turns on head, park
and tail lamps when unlock
button is pressed using (IKT)
Integrated Keyhead T ransmitter,
lamps automatically turn off
after 25 seconds or if IKT
lock button is pressed.
LiftgateVehicle must be unlocked
before opening liftgate
or liftgate window.
To open liftgate window:
Press right side button ( 3) under
rear license plate lamp shield.
To open liftgate: Press and hold
middle button ( 4), lift under rear
license plate lamp shield.
Locks
Locks
*Denotes optional equipment
Power door locks
To unlock/lock all doors: Press / on driver’s door switch ( 1).
To lock doors without key: With
door open, press on driver’s door
switch, exit vehicle, close doors.
Smart unlocking system
Prevents locking yourself out of
vehicle with key in any ignition
position; driver’s door will auto-
matically unlock if locked using
power lock control on driver’s
door panel when door is open.
Key
Operates ignition and all locks.
Tip: OTIS, One Touch Integrated
Start, turn key and release
to start.
SecuriLock™ passive
anti-theft key
Coded chip in key activates
ignition.
Tip: Use key number sticker
on key to purchase a new key;
store in safe place separate
from vehicle.
Child- safety locks
Located at the edge of rear doors.
To activate: Insert key into slot
( 2 ) and rotate to .
To cancel: Rotate key in opposite
direction.
WARNINGS: Since children
may access either rear door,
child-safety locks for both rear
doors should be activated.
Never leave a child in car
with key in the vehicle.
1L
2
4
3
2
1
34
SEATS
Always check the Owner’s Manual for more operating information and safety features
Shoulder belt
height
adjustment
To raise/lower belt:
Squeeze and hold
release buttons (1)
and slide up/down.
WARNING: Make sure
adjuster locks in one
of its positions.
Beltminder
Intermittently sounds chime
and illuminates seat belt warning
lamp when driver’s seat belt
is unbuckled and occupied.
Manual controls
1. Fore/aft adjustment
Raise lever and hold, slide seat,
release lever.
2. Seatback angle
Pull lever up to adjust seatback
angle, release lever at
desired angle.
WARNINGS: Do not adjust
seats while driving.
Seat belts must always be
worn when vehicle is in motion.
Air bags are supplemental
and do not replace seat
belt usage.
Always wear your seat belt
and properly secure children
12 and under in the rear seat.
Even with a deactivation
system, never place rear-facing
infant-safety seat in front
of any air bag, an infant is
in serious danger of being
injured or killed.
If you must install a forward-
facing child-safety seat in
the front seating position,
move vehicle seat as far
back as possible.Child-safety seat
To install in rear outboard seats:
Use dual locking mode retractor
seat belts; see Owner’s Manual
for proper installation and child
seat tether and LATCH system
instructions.
WARNING: Use age
appropriate child restraints,
see Owner’s Manual and
state or province laws.
Seats
Seats
*Denotes optional equipment
Seat belt emergency
locking mode
Belts lock only on hard acceleration,
braking, cornering or impacts of
about 5 mph or more.
Automatic locking mode
(all seat belts except
driver’s seat belt)
Must be used when installing
child-safety seat.
To activate: Pull webbing fully
out of retractor, allow belt to
retract until click is heard;
belt will only tighten.
To disengage: Unbuckle belt and
allow webbing to retract fully.
Passenger air bag sensing
system,see Getting Started
4
8
2
1
765
3
3 . Manual lumbar adjustment*
Rotate clockwise/counterclock-
wise to increase/decrease
firmness.
4. Head restraint
To raise/lower: Pull up/hold
release button (8) and push down.
Power driver’s seat*
5. Raise/lower front of seat
Pull/push front of switch up/down.
6. Fore/aft adjustment
Slide entire switch horizontally.
Raise/lower seat cushion
Pull/push entire switch vertically.
7. Raise/lower rear of seat
Pull/push back of switch up/down.
WARNING: Never ride in
a moving vehicle with any
seat in a reclined position
because you will not get
the full protection from
seat belts.
1 1
