Replacing tail/stop/turn/backup lamp bulbs
The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same
portion of the tail lamp assembly, one just below the other. Follow the
same steps to replace either bulb: 1. Make sure the headlamp switch is in the OFF position and then
open the liftgate to expose the
lamp assembly screws.
2. Remove the two screws from the lamp assembly.
3. Carefully remove the lamp assembly away from the vehicle
by pulling the assembly straight
out to expose the bulb socket.
DO NOT TIP THE LAMP ASSEMBLY SIDEWAYS.
4. Rotate the bulb socket counterclockwise and remove from lamp assembly.
5. Pull bulb straight out of socket and push in the new bulb.
6. Install the bulb socket into the lamp assembly and rotate clockwise.
7. Carefully install the tail lamp assembly on the vehicle and secure with two screws.
Replacing license plate lamp bulbs 1. Make sure the headlamp switch is in the OFF position.
2. Depress the lever and carefully pry the license plate lamp
assembly (located above the
license plate) from the liftgate.
3. Rotate the bulb socket counterclockwise and remove
from lamp assembly.
2008 Tribute (j14)
Owners Guide (post-2002-fmt)
USA (fus)
Lights
39
4. Pull bulb straight out of socket and push in the new bulb.
5. Install the bulb socket into the lamp assembly and rotate
clockwise.
6. To install, carefully press the lamp assembly into liftgate.
Replacing high-mount brake lamp bulbs
To remove the lamp assembly: 1. Remove the two screws and move the lamp assembly away
from the liftgate.
2. Remove the bulb holder from the lamp assembly by
depressing the snaps.
3. Pull the bulb straight out of the socket and push in the new
bulb.
To complete installation, follow the
removal procedure in reverse order.
2008 Tribute (j14)
Owners Guide (post-2002-fmt)
USA (fus)
Lights
40
Replacing foglamp bulbs (if equipped) 1. Make sure the foglamp switch is in the OFF position.
2. From underneath the vehicle, rotate the harness/bulb
assembly counterclockwise, to
remove from the fog lamp.
3. Carefully disconnect the bulb from the harness assembly via
the two snap clips.
Install the new bulb in reverse order.
2008 Tribute (j14)
Owners Guide (post-2002-fmt)
USA (fus)
Lights
41
•Entering a snow-free road from a snow-covered side street, or vice
versa.
• Entering a paved road from a gravel road, or vice versa.
• Driving on slick surfaces.
• Cornering while towing a heavily loaded trailer (refer to Trailer
towing in theTires, Wheels and Loading chapter.)
Roll Stability Control (RSC)
The RSC system works in conjunction with the ESC system to help
maintain roll stability of the vehicle during aggressive maneuvers by
applying brake force to one or more wheels.
During Roll Stability Control (RSC) events the “sliding car” icon in the
instrument cluster will flash momentarily.
Driving conditions that may activate ESC include:
• Emergency lane-change
• Taking a turn too fast
• Quick maneuvering to avoid an accident, pedestrian or obstacle
Electronic Stability Control (ESC) button and icon functionality
The ESC system automatically turns on each time the engine is started,
even if it was turned off when the engine was last shut down. The
“sliding car” icon which is located with the warning lights in the
instrument cluster will illuminate during bulb check at initial start-up and
then go off. This tells you that the system is normal and active. All
functions of the ESC system (RSC, DSC, and TCS) will be activated at
start up. When the system is left active, the “sliding car” icon will flash
only when any of the components of the system are affecting the
vehicle’s performance, otherwise the light will remain off. Consequently,
the “sliding car” icon will not be illuminated during most of your normal
driving.
The ESC button, located on the
center stack of the instrument
panel, allows the driver to control
certain features of the ESC system
below 25 mph (40 km/h). If the
vehicle is below 25 mph (40 km/h),
momentarily pressing the ESC button will disable RSC, DSC and Engine
Traction Control and steadily illuminate the “sliding car” icon. Pressing
and holding the ESC button for more than five seconds will further
disable the brake portion of the Traction Control feature and the “sliding
car” icon will flash momentarily and then illuminate steady.
2008 Tribute (j14)
Owners Guide (post-2002-fmt)
USA (fus)
Driving
170
If the vehicle is above 25 mph (40 km/h), momentarily pressing the ESC
button will steadily illuminate the “sliding car” icon, however, the ESC
system will remain enabled until the vehicle speed drops below 25 mph.
If the vehicle speed decreases below 25 mph (40 km/h), the system will
become deactivated, but if the vehicle speed subsequently increases to
above 25 mph (40 km/h), the system will again become active. In
general, the system will be active at all times the vehicle speed is above
25 mph (40 km/h).
In R (Reverse), ABS and the Traction Control feature will continue to
function, however ESC and RSC are disabled.
All these conditions are normal during ESC system operation. Refer to
the following table.
Electronic Stability Control Features
Button
functions “Sliding
car” icon RSC DSC Engine
Traction Control Brake
Traction Control
Default at
start-up Illuminated
during bulb check Enabled Enabled Enabled Enabled
Button
pressed
momentarily Illuminated
solid Disabled
below
25 mph
(40 km/h)
Disabled below
25 mph
(40 km/h)
Disabled below
25 mph
(40 km/h) Enabled
Button
pressed and
held more
than five
seconds Flashes
then
illuminated solid Disabled
below
25 mph
(40 km/h)
Disabled below
25 mph
(40 km/h)
Disabled below
25 mph
(40 km/h) Disabled
below
25 mph
(40 km/h)
WARNING: Do not alter or modify your vehicle’s suspension or
steering; the resulting changes to the vehicle’s handling can
adversely affect the Electronic Stability Control (ESC) system.
2008 Tribute (j14)
Owners Guide (post-2002-fmt)
USA (fus)
Driving
171
4. Driving through deep water—the electrical system may be wet.
These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel, properly tightening the fuel cap or letting the
electrical system dry out. After three driving cycles without these or any
other temporary malfunctions present, the
indicator should stay off
the next time the engine is started. A driving cycle consists of a cold
engine startup followed by mixed city/highway driving. No additional
vehicle service is required.
If the
indicator remains on, have your vehicle serviced at the first
available opportunity. Although some malfunctions detected by the
OBD-II may not have symptoms that are apparent, continued driving
with the
indicator on can result in increased emissions, lower fuel
economy, reduced engine and transmission smoothness, and lead to more
costly repairs.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if the
indicator is on or not working properly (bulb is burned
out), or if the OBD-II system has determined that some of the emission
control systems have not been properly checked. In this case, the vehicle
is considered not ready for I/M testing.
If the
indicator is on or the bulb does not work, the vehicle may
need to be serviced. Refer to the On board diagnostics (OBD-II)
description in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the ON position
for 15 seconds without cranking the engine. If the
indicator blinks
eight times, it means that the vehicle is not ready for I/M testing; if
the
indicator stays on solid, it means that the vehicle is ready for
I/M testing.
The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
2008 Tribute (j14)
Owners Guide (post-2002-fmt)
USA (fus)
Maintenance and Specifications
266
A
ABS (see Brakes) .....................166
Accessory delay ..........................48
Air cleaner filter ...............269, 271
Air conditioning manual heating and
air conditioning system ............29
Airbag supplemental
restraint system ..........97, 106, 109 and child safety seats ..............99
description ................97, 106, 109
disposal ....................................113
driver airbag ..............99, 107, 111
indicator light .........106, 109, 112
operation ...................99, 107, 111
passenger airbag .......99, 107, 111
side airbag ...............................106
All Wheel Drive (AWD),
driving off road .........................181
Ambulance packages ....................7
Antifreeze
(see Engine coolant) ................250
Anti-lock brake system
(see Brakes) ......................166–167
Anti-theft system ........................68
Audio system (see Radio) .........19
Automatic transaxle fluid, adding ............................267
fluid, checking ........................267
Automatic transmission ............173 driving an automatic
overdrive .................................175
fluid, refill capacities ..............271
fluid, specification ..................271
Auxiliary Input Jack ...................25
Auxiliary power point .................46 Axle
lubricant specifications ..........271
refill capacities ........................271
B
Battery .......................................248 acid, treating emergencies .....248
jumping a disabled battery ....207
maintenance-free ....................248
servicing ..................................248
Belt-Minder ...............................92
Booster seats .............................114
Brakes ........................................166 anti-lock ...........................166–167
anti-lock brake system
(ABS) warning light ...............167
fluid, checking and adding ....267
fluid, refill capacities ..............271
fluid, specifications .................271
lubricant specifications ..........271
parking ....................................167
shift interlock ..........................173
Break-in period .............................6
Bulbs ............................................36
C
Capacities for refilling fluids ....271
Cargo area shade ........................55
Cargo management system ........56
Cell phone warning ...................276
Child safety restraints ..............114 child seat belts .......................114
Child safety seats ......................117 attaching with tether
straps .......................................121
2008 Tribute (j14)
Owners Guide (post-2002-fmt)
USA (fus)
Index
277
Foglamps .....................................32
Four-Wheel Drive vehicles driving off road .......................181
preparing to drive your
vehicle .....................................173
Fuel ............................................256 calculating fuel economy .......261
cap ...........................................259
capacity ...................................271
choosing the right fuel ...........259
comparisons with EPA fuel
economy estimates .................264
detergent in fuel .....................260
filling your vehicle
with fuel ..................256, 259, 261
filter, specifications ................256
fuel pump shut-off switch .....189
improving fuel economy ........261
octane rating ...................260, 273
quality ......................................260
running out of fuel .................261
safety information relating
to automotive fuels ................256
Fuses ..................................189–190
G
Gas cap (see Fuel cap) ............259
Gas mileage
(see Fuel economy) .................261
Gauges .........................................17
H
Hazard flashers .........................188
Head restraints .....................72, 76
Headlamps ...................................32 aiming ........................................34
bulb specifications ....................37
daytime running lights .............33 flash to pass ..............................33
high beam .................................32
replacing bulbs .........................38
turning on and off ....................32
Heating manual heating and air
conditioning system .................29
Hood ..........................................239
I
Ignition ...............................161, 273
Illuminated visor mirror .............44
Infant seats
(see Safety seats) .....................117
Inspection/maintenance
(I/M) testing ..............................266
Instrument panel cleaning ...................................229
cluster ........................................12
lighting up panel and
interior .......................................33
location of components ............12
J
Jump-starting your vehicle ......207
K
Keys .......................................60, 69 positions of the ignition .........161
L
Lamps bulb replacement
specifications chart ..................37
cargo lamps ...............................33
daytime running light ...............33
2008 Tribute (j14)
Owners Guide (post-2002-fmt)
USA (fus)
Index
279