GETTING STARTED
Always check the Owner’s Manual for more operating information and safety features
Wiper/washer leverSingle wipe: Push lever up.
Washer: Pull back, also operates wipers.
Intermittent wiper: One click down, to
change interval speed rotate ring (1).
Auto*: One click down, rain sensor
senses rain amount on windshield,
then controls wiper automatically.
Rain sensor sensitivity is adjusted
from high sensitivity (+) to less
sensitivity (-) by rotating ring ( 2).
Passenger air bag
deactivation indicator light
Front air bag deactivation indicator
light ( 5) provides current status
of front passenger air bag and
pretensioner system.
If total seated weight on front
passenger seat is less than
approximately 66 lb., front
passenger air bag deactivation
indicator light illuminates,
front passenger and side air
Getting
Started
Getting
Started
bags/pretensioner will not
deploy/activate in an accident.
If the total seated weight
is greater than approximately
93 lb., light does not illuminate,
and the front passenger and side
air bags/pretensioner will deploy/
activate in an appropriate accident.
See Owner’s Manual for additional
information on this feature and
the air bag system.
WARNINGS: Even with a
deactivation system, never
place rear-facing infant-safety
seat in front of any air bag,
an infant is in serious danger
of being injured or killed.
If you must install a forward-
facing child-safety seat in
the front seating position,
move vehicle seat as far
back as possible.
High beams on/off: Push
forward/pull back to detent.
To flash high beams: Pull back
slightly and release.
AUTO* = With ignition switch
in ON position; headlights and
exterior lights automatically
turn ON/OFF depending on
surrounding darkness/lightness;
rotate knob ( 4) to third notch
= Fog lights* on: Rotate ( 5);
functions only with low beams on
Turn signals right/left: move
lever up/down.
Tip: With AUTO* ON/OFF or
auto OFF system, headlights
switch off automatically within
30 seconds if lights are left on
or with AUTO selected, switch
in lock position or key
removed.
Cruise
control
Operates
above 19 mph.
Push up/press
down ON/OFF
switch ( 1) to
enable/disable.
To set speed: Press switch ( 2)
down and release.
To increase set speed: Push switch
( 2 ) up and release at desired speed.
To decrease set speed: Press switch ( 2)
down and release at desired speed.
To cancel: Press down ON/Off
switch ( 1), tap brake or press
CANCEL switch ( 3).
To resume cruising speed:
Press switch ( 4); resume function
will not operate if cruise control
was cancelled using ON/OFF
switch. Normal wiper speed: Two clicks down.
High-speed wiper: Three clicks down.
Rear window wiper/washer To activate rear interval wiper:
Rotate knob (
3) up to INT.
To activate rear normal speed
wiper: Rotate knob ( 3) up to ON.
To activate rear washer: Rotate
knob ( 3) to and release.
Turn signal/lighting leverOFF = Lights off
= Tail, parking and dashboard
lights on: Rotate knob ( 4) to first notch
= Tail, parking, dashboard
and headlights on: Rotate knob
( 4 ) to second notch
S ET +
S ET -
ON
OF F
4312
54
AUTO
1 3
REA R
2
R
EA
RAU TO
3
LOAD
km/h mph H
C0
20 40
60
80
10 0
12 0
14 0 220
20
40
60
80
100
120
140
160
18 0
200 12 2.3
5
PASS AIR BAG OFF OUTSIDE PASS72.0 oF
*Denotes optional equipment
INSTRUMENT CLUSTER
Always check the Owner’s Manual for more operating information and safety features
WARNING LIGHTS
• Cruise control onAmber light: Cruise control system
activated; Green light: Cruising
speed set; see Getting Started
• Tire Pressure Monitoring System (TPMS)*,
see Driving Tips
• High beams on • Engine oil-pressure Stop car when safe and turn
off engine; check oil level
• Brake system Parking brake on/low brake fluid
• Always fasten seat belts • Security indicator light*
• KEY*,see Getting Started
• O Low fuel
• BSM OFF*BSM system is deactivated,
see Getting Started
BSM
OFF
GAUGES
1. Instrument cluster dimmer select knob
With headlights ON: Rotate knob
to increase/decrease brightness.
Headlights/parking lights ON,
ignition key ON: Illumination
changes brightness when knob
is pressed.
2. Tachometer
3. Gear position indicator Displays current gear
position or manual mode.
4. Gear indicator Displays current gear
when in D or M.
5. Speedometer
6. Odometer/Trip meter selector
Press to view odometer, trip
meter A and B; press and hold
to reset trip meter A/B settings.
• Check engineDealer inspection required if light
remains on, see Owner’s Manual
• Charging system Charging system malfunction;
dealer inspection required
• Air bag/front seat belt pretensioner system
If light flashes or stays on, the air
bags/front seat belt pretensioners
may not operate in an accident;
dealer inspection r equired
• AT Automatic transaxle*
Automatic transaxle malfunction;
dealer inspection required
• Anti-lock Brake System (ABS)
ABS malfunction, normal brakes
only; dealer inspection required
• Check fuel cap Fuel cap not securely tightened
• Door ajar
7. Engine coolant temperature gauge
Stop car if above normal
range, turn off engine, let
vehicle cool; check coolant
level when safe.
InstrumentCluster
Instrument Cluster
km/h mph
E F H
C
x1000r/min2 3
4
5
6
7
8
TRIP
1 0
0
20 40
60
80
10 0
12 0
140 220
20
40
60
80
100
120
140
160
18 0
200
P
R
N
D
M
8
2112
382.3
8 7 9
4 1 6 2 5
KEY
CRUISE
AT
4WD
3
BSM
OFF
8. Odometer/Trip meter
9. Fuel gauge 20.1-gallon/76-liter tank
CRUISE• TCS OFFTraction Control System is
deactivated
• Lights ON indicator light*
• Traction Control System (TCS)/Dynamic
Stability Control (DSC)/
Roll Stability Control (RSC)
Light flashes when system is
activated while driving; dealer
inspection required if light
remains on
•
4WDAWD warning light*
Flashing lamp indicates high
temperature differential oil,
illuminated lamp indicates an
abnormality with AWD system;
dealer inspection required
• Powertrain malfunction/ reduced power
Dealer inspection required if light
remains on, see Owner’s Manual
*Denotes optional equipment
