2008 MAZDA MODEL CX-7 warning

[x] Cancel search: warning

Page 107 of 502

MAZDA MODEL CX-7 2008  Owners Manual (in English) Black plate (107,1)
NOTE
If the vehicle battery is dead or there is a
malfunction in the electrical system and the
liftgate cannot be unlocked, perform the
following procedure as an emergency measure

Page 109 of 502

MAZDA MODEL CX-7 2008  Owners Manual (in English) Black plate (109,1)
Power Windows
The ignition switch must be in the ON
position for the power windows to
operate.
WARNING
Make sure the opening is clear before
closing a window:Closing power windows

Page 111 of 502

MAZDA MODEL CX-7 2008  Owners Manual (in English) Black plate (111,1)
NOTE
Pressing the power window switch once when
the window is fully closed will only open it
about 3 cm (1 in) to allow convenient
ventilation of the cabin.
Canceling the two-step

Page 113 of 502

MAZDA MODEL CX-7 2008  Owners Manual (in English) Black plate (113,1)
Engine-off power window operation
The power windows can be operated for
about 40 seconds after the ignition switch
is turned from the ON position to the
ACC or LOCK position with a

Page 114 of 502

MAZDA MODEL CX-7 2008  Owners Manual (in English) Black plate (114,1)
Opening
Because nobody likes getting into a very
hot car, Mazda has introduced a way to
open the two front windows and the
moonroof as you approach the vehicle to
get the air movin

Page 116 of 502

MAZDA MODEL CX-7 2008  Owners Manual (in English) Black plate (116,1)
Fuel-Filler Lid and Cap
WARNING
When removing the fuel cap, loosen the
cap slightly and wait for any hissing to
stop. Then remove it:Fuel spray is dangerous. Fuel can
burn skin and

Page 117 of 502

MAZDA MODEL CX-7 2008  Owners Manual (in English) Black plate (117,1)
CAUTION
Make sure the fuel-filler cap is
tightened securely. The check engine
light may illuminate when the cap
isnt tightened securely. If the light
remains on (even after you ha

Page 118 of 502

MAZDA MODEL CX-7 2008  Owners Manual (in English) Black plate (118,1)
3. Grasp the support rod in the paddedarea and secure it in the stay hole
indicated by the arrow to hold the hood
open.
Pad
Clip
Support rod
q
Closing the Hood
1. Check under the h