2008 MAZDA MODEL B4000 CAB PLUS 4 TRUCK ignition

[x] Cancel search: ignition

Page 100 of 312

MAZDA MODEL B4000 CAB PLUS 4 TRUCK 2008  Owners Manual The control is located on the outboard side of the seat cushion.
Move the front of the control up or
down to raise or lower the front
portion of the seat cushion.
Move the rear of the control up or
do

Page 109 of 312

MAZDA MODEL B4000 CAB PLUS 4 TRUCK 2008  Owners Manual seat belt pretensioners, front seat belt buckle sensors, driver seat
position sensor, and front passenger sensing system. In addition, the
RCM also monitors the restraints warning light in the instrum

Page 115 of 312

MAZDA MODEL B4000 CAB PLUS 4 TRUCK 2008  Owners Manual WARNING: Failure to inspect and if necessary replace the seat
belt assembly under the above conditions could result in severe
personal injuries in the event of a collision.
For proper care of soiled s

Page 116 of 312

MAZDA MODEL B4000 CAB PLUS 4 TRUCK 2008  Owners Manual Both the driver’s and passenger’s seat belt usages are monitored and
either may activate the Belt-Minderfeature. The warnings are the same
for the driver and the front passenger. If the Belt-Mind

Page 118 of 312

MAZDA MODEL B4000 CAB PLUS 4 TRUCK 2008  Owners Manual WARNING: Do not sit on top of a buckled seat belt or insert a
latchplate into the buckle to avoid the Belt-Minderchime. To
do so may adversely affect the performance of the vehicle’s air
bag system

Page 119 of 312

MAZDA MODEL B4000 CAB PLUS 4 TRUCK 2008  Owners Manual 1. Turn the ignition switch to the RUN (or ON) position. (DO NOTSTART THE ENGINE)
2. Wait until the seat belt warning light turns off. (Approximately 1 minute)
• Step 3 must be completed within 50 s

Page 125 of 312

MAZDA MODEL B4000 CAB PLUS 4 TRUCK 2008  Owners Manual Note: The indicator lamp will illuminate for a short period of time when
the ignition is turned to the ON position to confirm it is functional.
When the front passenger seat is not occupied (empty sea

Page 129 of 312

MAZDA MODEL B4000 CAB PLUS 4 TRUCK 2008  Owners Manual A difficulty with the system is indicated by one or more of the following:
•The readiness light will either
flash or stay lit.
• The readiness light will not
illuminate immediately after
ignition