2008 MAZDA MODEL 5 tires

[x] Cancel search: tires

Page 149 of 376

MAZDA MODEL 5 2008  Owners Manual Black plate (149,1)
Adjust the tire pressure to the correct tire
pressure. Refer to the specification charts
(page 10-6).
CAUTION
When replacing/repairing the tires or
wheels or both, have the work do

Page 245 of 376

MAZDA MODEL 5 2008  Owners Manual Black plate (245,1)
qSpare Tire
The temporary spare tire is lighter and
smaller than a conventional tire, and is
designed only for emergency use and
should be used only for VERY short
periods. Tempora

Page 247 of 376

MAZDA MODEL 5 2008  Owners Manual Black plate (247,1)
Changing a Flat Tire
NOTE
If the following occurs while driving, it could
indicate a flat tire.
lSteering becomes difficult.lThe vehicle begins to vibrate excessively.lThe vehicle

Page 249 of 376

MAZDA MODEL 5 2008  Owners Manual Black plate (249,1)
4. Turn the lug wrench clockwise andraise the vehicle high enough so that
the spare tire can be installed. Before
removing the lug nuts, make sure your
Mazda is firmly in position

Page 250 of 376

MAZDA MODEL 5 2008  Owners Manual Black plate (250,1)
To install the nut
1. Place the key on top of the nut, and besure to hold the key square to it. If you
hold the key at an angle, you may
damage both key and nut. Dont use a
power

Page 252 of 376

MAZDA MODEL 5 2008  Owners Manual Black plate (252,1)
11. Pull the belt end to secure the flat tire.
12. Remove the tire blocks and store thetools and jack.
13. Check the tire inflation pressure. Refer to the specification charts on
p

Page 265 of 376

MAZDA MODEL 5 2008  Owners Manual Black plate (265,1)
8Maintenance and Care
How to keep your Mazda in top condition.
Introduction .................................................................................. 8-2Introduction .....

Page 295 of 376

MAZDA MODEL 5 2008  Owners Manual Black plate (295,1)
Tires
For reasons of proper performance, safety,
and better fuel economy, always maintain
recommended tire inflation pressures and
stay within the recommended load limits
and weigh