Page 116 of 487
114
1-8. Safety information
RX400h_UWhile pushing the child restraint
system down into the rear seat,
allow the shoulder belt to retract
until the child restraint system is
securely in place.
After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended.
■
Forward facing Convertible seat
Place the child restraint system on
the seat facing the front of the vehi-
cle.
Run the seat belt through the child
restraint system and insert the
plate into the buckle. Make sure
that the belt is not twisted.
Fully extend the shoulder belt and
then allow it to retract slightly into
the ALR lock mode.
Lock mode allows the seat belt to
retract only.
STEP4
STEP1
STEP2
STEP3
Page 117 of 487
115
1-8. Safety information
1
Before driving
RX400h_UWhile pushing the child restraint
system into the rear seat, allow the
shoulder belt to retract until the
child restraint system is securely in
place.
After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended.
■
Booster seat
Place the child restraint system on
the seat facing the front of the vehi-
cle.
Sit the child in the child restraint
system. Fit the seat belt to the child
restraint system according to the
manufacturer's instructions and
insert the plate into the buckle.
Make sure that the belt is not
twisted.
Check that the shoulder belt is cor-
rectly positioned over the child's
shoulder, and that the lap belt is as
low as possible. (→
P. 5 8)
STEP4
STEP1
STEP2
Page 118 of 487
116
1-8. Safety information
RX400h_U
Removing a child restraint installed with a seat beltPush the buckle release button
and fully retract the seat belt.
Installation with child restraint lower anchorages
Fold the seatback forward and
then back to the 1st lock position
(most upright position) until it locks
into place. Adjust the seatback to
the 3rd lock position.1st lock position
3rd lock position
Widen the gap between the seat cushion and seatback slightly.
STEP1
STEP2
Page 119 of 487
117
1-8. Safety information
1
Before driving
RX400h_UType A
Latch the hooks of lower straps
onto the anchorages.
Type B
Latch the buckles onto the anchor-
ages.
If the child restraint has a top strap, the top strap should be latched onto
the anchorages. ( →P. 1 1 8 )
STEP3
Canada only
STEP3
Canada only
Page 120 of 487
118
1-8. Safety information
RX400h_UFor owners in Canada:
The symbol on a child restraint system indicates the presence of a lower
connector system.
Child restraint systems with a top strap
Secure the child restraint using a
seat belt or a lower anchorage,
and remove the head restraint.
Open the anchor bracket cover,
latch the hook onto the anchor
bracket and tighten the top strap.
Replace the head restraint and lift
it up to the uppermost lock posi-
tion.
STEP1
STEP2
STEP3
Page 121 of 487

119
1-8. Safety information
1
Before driving
RX400h_U
■Laws and regulations pertaining to anchorages
Anchorages conform to FMVSS225 or CMVSS210.2.
Child restraint systems conforming to FMVSS213 or CMVSS213 specifications
can be used.
This vehicle is designed to confirm to the SAE J1819.
CAUTION
■When installing a booster seat
Do not fully extend the shoulder belt to prevent the belt from going to ALR lock
mode: ( →P. 6 1 )
ALR mode causes the belt to tighten only which could cause injury or discomfort to
the child.
■When installing a child restraint system
Follow the directions given in the child restraint system installation manual and fix
the child restraint system securely in place.
If the child restraint system is not correctly fixed in place, the child or other passen-
gers may be injured or even killed in the event of sudden braking or an accident.
●If the driver’s seat interferes with the child
restraint system and prevents it from being
attached correctly, attach the child restraint
system to the right-hand rear seat.
●Only put a forward facing or booster child
seat on the front seat when unavoidable.
When installing a forward facing or
booster seat on the front passenger seat,
move the seat as far back as possible even
if AIR BAG OFF indicator light is illumi-
nated. Failing to do so may result in death
or serious injury if the airbags deploy
(inflate).
Page 122 of 487

120
1-8. Safety information
RX400h_U
CAUTION
■When installing a child restraint system
●When installing a child restraint system in the rear center position, adjust both
seat cushions to the same position and align both seatbacks at the same angle.
Otherwise, the child restraint system cannot be securely restrained and this may
cause death or serious injuries in a collision.
●When using the lower anchorages for a child restraint system, ensure that the
seat is moved to the rear-most position, with the seatback close to the child
restraint system.
●When a booster seat is installed, always ensure that the shoulder belt is posi-
tioned across the center of the child's shoulder. The belt should be kept away
from the child's neck, but not so that it could fall off the child's shoulder.
Failing to do so may result in death or serious injury in the event of an accident or
sudden braking.
●Ensure that the belt and tab are securely locked and the seat belt is not twisted.
●Push and pull the child seat in different directions to be sure it is secure.
●Follow all installation instructions provided by the child restraint system manufac-
turer.
■Do not use a seat belt extender
If a seat belt extender is used when installing a child restraint system, the seat belt
will not securely hold the child restraint system, which could cause death or serious
injury to the child or other passengers in the event of a collision.
■To correctly attach a child restraint system to the anchorages
When using the lower anchorages, be sure that there are no foreign objects around
the anchorages and that the seat belt is not caught behind the child restraint. Make
sure the child restraint system is securely attached, or it may cause death or serious
injury to the child or other passengers in the event of a sudden stop or accident.
Page 472 of 487
470
RX400h_U
Abbreviation list
Abbreviation/Acronym list
ABBREVIATIONSMEANING
A/CAir Conditioning
ABSAnti-Lock Brake System
ACCAccessory
AFSAdaptive Front-lighting System
ALRAutomatic Locking Retractor
AW DAll-Wheel Drive
CRSChild Restraint System
DISPDisplay
ECUElectronic Control Unit
EDREvent Data Recorder
ELREmergency Locking Retractor
EPSElectric Power Steering
GAWRGross Axle Weight Ratings
GVWRGross Vehicle Weight Ratings
I/MEmission inspection and Maintenance
INFOInformation
INTIntermittent
LEDLight Emitting Diode
LTLight Truck
MMTMethylcyclopentadienyl Manganese Tricarbonyl
M + SMud and Snow
MTBEMethyl Tertiary Butyl Ether
OBDOn Board Diagnostics
PWRPow e r
SRSSupplemental Restraint System