2008 Lancia Musa glove box

8
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
L0D0374m
1.Side air vents - 2.Left stalk - 3.Upper left-hand glove box - 4.Right stalk - 5.Central air vents - 6.Instrument panel -
7.Upper right-hand glove box - 8.Glove box compartment - 9.Passenger’s airbag - 10.Controls for heating/ventilation/
climate control - 11.Control buttons - 12.Sound system (where provided) - 13.Ignition converter - 14.Driver’s airbag -
15.Cruise control (where provided).
DASHBOARD
The presence and position of the controls, instruments and indicators may vary according to the different versions.
The upper and lower central panel offers several solutions according to the Customer’s requirements (see the illustrations
below).
fig. 1
007-037 MUSA 3ed GB 12-11-2007 11:33 Pagina 8

9
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Upper central panel:
❒with fixed glove box compartment,
A-fig. 2, and extractable com-
partment (DIN), B-fig. 2, for au-
dio system installation;
❒with required auto system, fig. 3;
❒with Connet Nav+, fig. 4;
Lower central panel:
❒with manual climate control system,
B-fig. 5;
❒with automatic two-zone climate
control system, C-fig. 6.
fig. 2L0D0231m
fig. 3L0D0232m
fig. 4L0D0359m
fig. 5L0D0234m
fig. 6L0D0235m
007-037 MUSA 3ed GB 12-11-2007 11:33 Pagina 9

99
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
PRETENSIONERS
To increase the protection efficiency
of the seat belts, the car is fitted with
front pretension. In the event of a vi-
olent crash, these devices rewind the
seat belts a few centimetres. In this
way they ensure that the seat belt per-
fectly adheres to the wearer before the
restraining action begins.
When the pretensioner is engaged, the
reel is blocked. The belt is no longer
wound even if it is accompanied.The pretensioner can only
be used once. Go to a Lan-
cia Dealership to have it replaced
after is has been deployed. For de-
vice validity refer to the plate po-
sitioned inside the upper glove box
on the passenger’s side. Refer to the
Lancia Dealership when the time
comes to replace the device.
WARNING
Operations which lead to
shocks, vibrations or lo-
calised heating (over 100°C
for a maximum of 6 hours)
in the area around the pretensioners
may damage or trigger them. These
devices are not affected by vibra-
tions caused by irregularities of the
road surface or low obstacles such
as kerbs, etc. Contact Lancia Deal-
ership for any assistance.
IMPORTANT Maximum protection is
obtained from the pretensioner if the
belt is worn tight on the chest and
hips.
A slight emission of smoke may occur.
This smoke is not harmful and does
not indicate a fire.
The pretensioner does not require any
maintenance or greasing.
Any work tampering with its original
conditions invalidates pretensioner ef-
ficiency.
If unusual natural events (floods, sea
storms, etc.) have caused the device
to be contaminated by water and
mud, it must be replaced.
095-112 MUSA 3ed GB 12-11-2007 11:36 Pagina 99

167
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
SERVICE SCHEDULE
Thousands of kilometres
Check tyre conditions/wear and adjust
pressure if required
Check light system operation (headlights, direction indicators,
hazard lights, boot lights, passenger compartment lights,
glovebox light, instrument panel warning lights, etc.)
Wiper and windscreen washer system check
(adjustment of spray nozzles/wear on wiper blades)
Check front disk brake pad conditions and wear
Check rear drum brake linings
and wear
Visually inspect the conditions of: bodywork, underbody
protection, pipes and hoses
(exhaust - fuel feed - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of locks, bonnet and boot and lever
cleanness and lubrication
Check and if necessary adjust the accessory drive belts
excluding engines equipped with automatic tensioners)
visually inspect the accessory drive belt conditions
Check, adjust play of tappets
(versions 1.48V(where provided) - 1.9 Multijet)
Check and adjust handbrake lever stroke
20 40 60 80 100 120 140 160 180
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●
●●●●● ●●●●
●●●●● ●●●●
●
●● ● ●
●● ● ●
●● ● ●
165-186 MUSA 3ed GB 12-11-2007 11:39 Pagina 167