2008 Lancia Musa check engine

171
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
CHECKING
FLUID LEVELS
IMPORTANT Be careful not to con-
fuse the various types of fluids while
topping up: they are all reciprocally
incompatible and may severely dam-
age your car.
L0D0411m
L0D0412m
fig. 1 - 1.48Vversions (where provided)
fig. 2 - 1.416Vversions
Never smoke while work-
ing in the engine compart-
ment: flammable gases may be
present. Risk of fire.
WARNING
1 Engine coolant - 2 Engine oil -
3 Brake fluid - 4 Battery - 5 Wind-
screen washer/rear window washer
fluid
165-186 MUSA 3ed GB 12-11-2007 11:39 Pagina 171

173
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
fig. 5 - 1.4 8V version(where provided)L0D0258mfig. 6 -1.416VversionL0D0208mfig. 7 - 1.3 Multijet versionL0D0209m
fig. 8 - 1.9 Multijet versionL0D0326m
ENGINE OIL fig. 5-6-7-8
Engine oil check
Check the oil level a few minutes
(about 5) after the engine has
stopped, with the car parked on level
ground.
The oil level must be included be-
tween the MINandMAXmarks on
the dipstick. The range between the
MINandMAXlevels corresponds to
approximately 1 litre of oil.Topping up the engine oil
If the oil level is near or under the
MINline, add oil through the filler to
reach the MAXline. Oil level shall
never exceed the MAXline.
IMPORTANT If, following the rou-
tine checks, the engine oil level is
found to be above the MAXline, con-
tact the Lancia Dealership in order to
have the correct level restored.
IMPORTANT After adding or chang-
ing the oil, before checking the level,
run the engine for a few seconds and
wait for a few minutes after it has
stopped.
165-186 MUSA 3ed GB 12-11-2007 11:39 Pagina 173

174
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
Engine oil consumption
The maximum engine oil consump-
tion is usually 400 grams every 1000
km.
When the car is new, the engine needs
to be run in, therefore the engine oil
consumption can only be considered
stabilised after the first 5,000 - 6,000
km.
IMPORTANT The oil consumption
depends on driving style and the con-
ditions under which the car is used.
IMPORTANT Always top up using
engine oil of the same types as that al-
ready in the engine.ENGINE COOLANT fig. 10
The coolant level must be checked
when the engine is cold and must be
between the MINandMAXlines on
the vessel.
If the level is too low, slowly pour a
mixture of 50% distilled water and of
FL Selenia’s PARAFLU UP into the
filler of the vessel.
A 50-50 mixture of PARAFLU UP
and distilled water gives freeze pro-
tection to –35°C.
IMPORTANT When the engine is very
hot, do not remove the cap of the ves-
sel: risk of burns.
Proceed very carefully in-
side the engine compart-
ment when the engine is hot: risk of
burns. Remember that the fan may
start up if the engine is hot: risk of
injury. Pay attention to scarves,
ties and other loose fitting gar-
ments: they could get dragged by
the moving parts.
WARNING
Waste engine oil and oil fil-
ters contain substances
which are dangerous for the
environment. For oil and
filter changing, we recommend con-
tacting a Lancia Dealership.
fig. 9 - 1.48V(where provided)
and 1.4 16V version
L0D0210mfig. 10 - 1.3 Multijet and
1.9 Multijet versionsL0D0211m
165-186 MUSA 3ed GB 12-11-2007 11:39 Pagina 174

175
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
When the vehicle is used under par-
ticularly harsh climate conditions, we
recommend using a 60-40 mixture of
PARAFLU UP and demineralised
water.
WINDSCREEN/
REAR WINDOW WASHER
FLUID fig. 11
To add fluid lift the cap Aand pour
in a mixture of water and TUTELA
PROFESSIONAL SC 35fluid, in the
following proportions:
❒30% of TUTELA PROFES-
SIONAL SC 35and 70% of water
in summer;
❒50% of TUTELA PROFES-
SIONAL SC 35and 50% of water
in winter.
At temperatures inferior to –20°C use
TUTELA PROFESSIONAL SC 35
undiluted.
Check level through the reservoir.
PARAFLU UP antifreeze is
used in the engine cooling
system. Use fluid of the same type
contained in the cooling system for
top-ups. PARAFLU UP may not be
mixed with other types of fluids. If
this accidentally occurs, do not start
the engine and contact a Lancia
Dealership.
WARNING
The engine cooling system
is pressurized. If required,
replace the cap with an original
spare part so as not to compromise
system efficiency.
WARNING
fig. 11L0D0212m
Do not travel with the
windscreen washing reser-
voir empty: the action of the wind-
screen washer is essential for im-
proving visibility.
WARNING
Some commercial addi-
tives for windscreen wash-
ing are flammable. The engine
compartment contains hot parts
which could start a fire if they
come into contact.
WARNING
165-186 MUSA 3ed GB 12-11-2007 11:39 Pagina 175

185
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
Engine compartment
At the end of the winter the engine
compartment should be carefully
washed, without directing the jet
against electronic control units. Have
this operation performed at a spe-
cialised workshop.
IMPORTANT Perform this operation
on a cold engine and with the key at
STOP. After the washing operation,
make sure that the various protections
(e.g. rubber caps and guards) have
not been removed or damaged.
Never use flammable
products, such as petrol
ether or rectified petrol to clean in-
side the car. The electrostatic
charges which are generated by
rubbing during the cleaning oper-
ation may cause a fire.
WARNINGINTERIORS
Periodically check that water is not
trapped under the mats (due to water
dripping off shoes, umbrellas, etc.)
which could cause oxidisation of the
sheet metal.
CLEANING SEATS AND
FABRIC PARTS
Remove dust with a soft brush or a
vacuum cleaner. It is advisable to use
a moist brush on velvet upholstery.
Rub the seats with a sponge moist-
ened with a solution of water and
neutral detergent.
INTERIOR PLASTIC PARTS
It is advisable to clean interior parts
with a moist cloth and a solution of
water and mild soap. Use specific
products for cleaning plastic, without
solvents and specifically designed to
prevent damage to the appearance
and colour of the treated parts to re-
move grease and tough stains.
IMPORTANT Never use spirit or
petroL to clean the glass of the in-
strument panel or other plastic parts.
165-186 MUSA 3ed GB 12-11-2007 11:39 Pagina 185

206
STARTING
AND
DRIVING
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
ABS (System) ........................ 85
Accessories purchased by
the owner ............................... 88
Air vents ............................... 48
Ashtray (Smoking kit) .......... 75
Battery
– inspecting the charge ........ 177
– jump starting ................... 137
– replacement procedure ..... 178
Bodywork
– maintenance ..................... 182
– version code ..................... 190
Boot extension ....................... 80
Boot ....................................... 80
Brake fluid level .................... 176
Brakes
– fluid level ......................... 176
– handbrake ........................ 116
– technical data .................. 193
Bulb
(when needing to change a) ... 147Capacities ............................. 199
Car inactivity ........................ 124
Car refuelling ........................ 201
Carrying children in safety .... 101
Ceiling lights ......................... 69
Changing a wheel .................. 142
Checking fluid levels ............. 171
Cigar lighter (Smokers kit) .... 75
Clutch ................................... 192
CO2 emissions ...................... 205
Cruise Control ....................... 67
Current outlets ....................... 75
Dashboard ........................... 8
Dashboard and controls ........ 7
Dimensions ........................... 198
Dipped beam headlights
– bulb replacement
procedure .............................. 151
– control ............................ 62
Direction Indicators– bulb replacement
procedure ............................. 152
– control ............................ 63
Direction indicators ............... 63
Dualdrive (electric power
steering system) .................... 89
Engine
– features ............................ 191
– fuel feed system ................ 192
– identification code ............ 188
– starting ............................ 20
Engine bonnet ....................... 82
Engine compartment ............. 171
Engine coolant level .............. 174
Engine coolant thermometer .. 22
Engine oil
– level gauge ....................... 173
– technical specifications ..... 202
Engine oil level ..................... 173
Environment (protection). ..... 94
EOBD system ........................ 86
INDEX
206-216 MUSA 3ed GB 12-11-2007 11:40 Pagina 206

Fiat Group Automobiles S.p.A.
Servizi al Cliente - Assistenza Tecnica - Ingegneria Assistenziale
Largo Senatore G. Agnelli, 5 - 10040 Volvera - Torino (Italia)
Print no. 603.81.236 - 11/2007 - 3
rdedition
ENGINE OIL CHANGE COLD TYRE INFLATION PRESSURE (bar)
STANDARD TYRES
Size Medium load Full load
Front Rear Front Rear
FUEL CAPACITIES (litres)
1.48V - 1.416V1.3 Multijet 1.9 Multijet
Tank capacity 47 47 47
Reserve 5 - 7 5 - 7 5 - 7
Refuel petrol engines with unleaded petrol with an octane rating (RON) no lower than 95 only.
Refuel diesel engines with diesel fuel for motor vehicles (EN590 specifications) only.
1.418V1.416V1.3 Multijet 1.9 Multijet
litres kg litres kg litres kg litres kg
Engine sump 2.4 2.1 2.5 2.2 2.85 2.5 4.2 3.75
Engine sump and filter 2.62.25 2.7 2.35 3.0 2.6 4.4 3.9
185/65 R14 86T 2,2 2,1 2,3 2,3
195/60 R15 88T 2,2 2,1 2,3 2,3
205/50 R16 87V 2,2 2,1 2,3 2,3
135/80 B14 84M 2,8SPARE WHEEL
125/80 R15 95M 4,2
Add +0.3 bar to the prescribed inflation pressure when the tyres are warm. Recheck pressure value with cold tyres.
With snow tyres, add +0.2 bar to the inflation pressure value prescribed for standard tyres.
206-216 MUSA 3ed GB 12-11-2007 11:40 Pagina 216