2008 Lancia Delta stop start

114GETTING TO KNOW YOUR CAR
ACTIVATING/DEACTIVATING THE CITY
FUNCTIONfig. 73
Press button A to turn the function on/off.
When the function is active, the CITY warning light on
the instrument panel turns on.
With CITY function on, wheel effort is lighter, facilitat-
ing parking manoeuvres: the function is particularly help-
ful when driving in city centres.
FAILURE INDICATIONS
Any failure of the power steering is indicated by instru-
ment panel warning light gcoming on together with a
message on the reconfigurable multifunctional display. In
the event of electric power steering system failure, the
car can be driven with mechanical steering.
IMPORTANT In some circumstances, factors independent
of the electric power steering could cause the illumination
of the gwarning light on the instrument panel.
In this case, stop the car immediately, switch off the en-
gine for about 20 seconds and then restart the engine. If
the gwarning light remains on, together with the mes-
sage on the reconfigurable multifunctional display, con-
tact a Lancia Dealership as soon as possible
fig. 73L0E0057m
Under no circumstances should after-market
operations be carried out involving steering
system or steering column modifications (e.g.:
installation of anti-theft device). This could nega-
tively affect performance and safety, cause the lapse
of the warranty and also result in vehicle non-com-
pliance with type-approval requirements.

STARTING UP AND DRIVING149
3
STARTING PROCEDURE FOR PETROL
VERSIONS
Proceed as follows:
engage the handbrake;
put the gear lever into neutral;
press the clutch pedal down to the floor without touch-
ing the accelerator;
turn the ignition key to AVV and release it the moment
the engine starts.
If the engine does not start at the first attempt, return
the ignition key to STOP before repeating the procedure.
If, when the ignition key is at MAR the
Ywarning light
remains lit together with warning light U, turn the key
to STOP and then back to MAR; if the warning light re-
mains lit, try with the other keys provided with the car.
Contact a Lancia Dealership if you still cannot start the
engine.
PROCEDURE FOR DIESEL VERSIONS
Proceed as follows:
engage the handbrake;
put the gear lever into neutral;
turn the ignition key to MAR: instrument panel warn-
ing lights
mandYwill light up;
wait for warning lights
Yandm, to turn off. The
hotter the engine is, the quicker this will happen;press the clutch pedal down to the floor without touch-
ing the accelerator;
turn the ignition key to AVV as soon as the
mwarn-
ing light goes out. Waiting too long will waste the work
done by the glow plugs.
Release the key as soon as the engine starts.
IMPORTANT When the engine is cold, the accelerator
pedal must be completely released when the key is turned
to AVV.
If the engine does not start at the first attempt, return the
ignition key to STOP before repeating the procedure. If,
when the ignition key is at MAR the
Ywarning light re-
mains lit, turn the key to STOP and then back to MAR; if
the warning light remains lit, try with the other keys pro-
vided with the car. Contact a Lancia Dealership if you still
cannot start the engine.
Warning light mwill blink for 60 seconds
after starting or during prolonged cranking
to indicate a fault in the glow plug preheat-
ing system. Use the car normally if the engine starts
and contact the Lancia Dealership as soon as pos-
sible.

150STARTING UP AND DRIVING
Never jump start the engine by pushing, tow-
ing or driving downhill. This could cause a
flow of fuel into the catalytic converter and
damage it beyond repair.
HOW TO WARM UP THE ENGINE AFTER
IT HAS JUST STARTED
Proceed as follows:
drive off slowly, letting the engine turn at medium
speed. Do not accelerate abruptly;
do not demand maximum performance for the first few
kilometres. Wait until the engine coolant gauge starts
moving.
STOPPING THE ENGINE
Turn the ignition key to STOP while the engine is idling.
IMPORTANT After a taxing drive, you should allow the
engine to “catch its breath” before turning it off by letting
it idle to allow the temperature in the engine compartment
to fall.
A quick burst on the accelerator before turn-
ing off the engine serves absolutely no prac-
tical purpose, it wastes fuel and is damaging
especially to turbocharged engines.
HANDBRAKE
The handbrake lever is located between the two front seats.
Pull the lever upwards to operate the handbrake.
The car should be braked after a few snaps
of the lever, if it is not, contact a Lancia Deal-
ership to have it adjusted.
When the handbrake lever is engaged and the ignition key
is on MAR, the instrument panel warning light xwill
light.
Proceed as follows to release the handbrake:
slightly lift the handbrake and press release button
A-fig. 1;
hold button A pressed and lower the lever. The x
warning light on the instrument panel will go out.
Press the brake pedal when carrying out this operation
to prevent the car from moving accidentally.

STARTING UP AND DRIVING151
3
PARKING THE CAR
Proceed as follows:
stop the engine and engage the handbrake;
Engage a gear (on a slope, engage first gear if the car
is faced uphill or reverse if it is faced downhill) and
leave the wheels steered.
If the car is parked on a steep slope, it is further advisable
to block the wheels with a wedge or stone.
Do not leave the ignition key on MAR to prevent drain-
ing the battery. Always remove the key when you leave the
car.
Never leave children unattended in the car. Always remove
the ignition key when leaving the car and take it out with
you.
fig. 1L0E0072m
USING THE MANUAL GEARBOX
To engage the gears, press the clutch pedal fully and shift
the gear lever into one of the required positions (the gear
diagram varies according to the different versions and is
shown on the knob or on the plate below the lever fig. 2).
To engage sixth gear, operate the lever by pressing it to-
wards the right in order to avoid engaging fourth gear by
mistake. Use the same action to pass from sixth to fifth
gear.
IMPORTANT Reverse may only be engaged when the car
is at a standstill. With the engine running, wait at least 2
seconds before engaging reverse gear with the clutch
pressed down to the floor in order to avoid damaging or
scraping the gears.
fig. 2L0E0073m

STARTING UP AND DRIVING153
3
Accessories fitted on longitudinal bars
Remove any accessories such as: longitudinal bars, ski
racks, luggage rack, from the roof if they are not being
used. These accessories decrease aerodynamic penetration
and have a negative effect on fuel consumption. It is bet-
ter to use a trailer to transport particularly bulky objects.
Electrical devices
Use electrical devices only for the amount of time needed.
The heated rear windscreen, additional headlights, wind-
screen wipers and heater fan need a considerable amount
of energy; increasing the requirement of current increas-
es fuel consumption (up to +25% in the urban cycle).
Climate control
The climate control system leads to higher fuel consump-
tion (up to +20% on average): use air vents only when the
external temperature allows.
Spoilers
The use of non-certified aerodynamic items may adversely
affect air drag and fuel consumption levels.DRIVING STYLE
Starting
Do not warm the engine up with the car standing: the en-
gine warms up very slowly in these conditions, increas-
ing fuel consumption and emissions. It is advisable to start
off immediately and slowly keeping the engine speed
down: the engine will warm up much faster this way.
Unnecessary actions
Avoid revving up when starting at traffic lights or before
stopping the engine. The latter action, like doubling the
clutch, is unnecessary and causes increased fuel con-
sumption and pollution.
Gear selection
Use a higher gear as soon as traffic and road conditions
allow. Using a low gear for faster acceleration will increase
fuel consumption.
In the same way improper use of a high gear increases
fuel consumption, emissions and engine wear.
Top speed
Fuel consumption considerably increases as speed in-
creases. Keep your speed as even as possible, avoiding un-
necessary braking and acceleration, which cause excessive
fuel consumption and increased emissions.

196IN AN EMERGENCY
TOWING THE CAR
The tow ring provided with the car is housed in the tool
box under the luggage compartment mat.
FASTENING THE TOW RING fig. 43-44
Proceed as follows:
release cap A;
take the tow hook B from its seat in the tool support;
tighten the ring on the rear or front threaded pin.
fig. 43L0E0090mfig. 44L0E0091m
Before starting towing operations, turn the ig-
nition key to MAR and then to STOP, without
extracting it. If the key is extracted, the steer-
ing wheel lock will be automatically activated, thus
preventing steering. The power brakes and the elec-
trical power steering will not work while the car is be-
ing towed. More effort on the brake pedal and steer-
ing wheel will therefore be required. Do not use wires
for towing. Do not jerk. Make sure not to damage parts
in contact with the car while towing. Respect the spe-
cific rules of the Highway Code when towing the car
specifically in relation to the towing device and the be-
haviour to maintain on the road. Do not start the en-
gine while towing the car.

216CARE AND MAINTENANCE
WHEELS AND TYRES
Check the pressure of each tyre, including the spare wheel,
approximately once every two weeks and before starting
a long journey: this check must be performed with the tyre
rested and cold.
It is normal for the pressure to increase when the car is
used; for the correct tyre inflation pressure, see “Wheels”
in chapter “6”.
Incorrect tyre pressure causes abnormal tyre wear fig. 4:
fig. 4L0E0096m
A normal pressure: evenly worn tread.
B low pressure: tread particularly worn on the edges.
C excessive pressure: tread particularly worn in the mid-
dle.
The tyres must be replaced when the tread is less than 1.6
mm thick. In all cases, follow the laws in force in the coun-
try where you are driving.
IMPORTANT NOTES
Avoid braking suddenly, burning starts and violent
knocks against the curb, potholes or other obstacles
where possible. Long distances on rough roads may
damage the tyres;
check the tyres regularly for cuts on the sides, swelling
or irregular tread wear. Go to a Lancia Dealership if
required;
do not overload your car: this may cause serious dam-
age to wheels and tyres;
if a tyre is punctured, stop immediately and change it
to avoid damage to the tyre, wheel rim, suspension and
steering system;