2008 KIA Sorento brake

Maintenance
40 7
EXTERIOR CARE
Exterior general caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all warning and
caution statements that appear on the
label.
Finish maintenance
Washing
To help protect your vehicle’s finish from
rust and deterioration, wash it thoroughly
and frequently at least once a month with
lukewarm or cold water.
If you use your vehicle for off-road driv-
ing, you should wash it after each off-
road trip. Pay special attention to the
removal of any accumulation of salt, dirt,
mud, and other foreign materials. Make
sure the drain holes in the lower edges of
the doors and rocker panels are kept
clear and clean.
Insects, tar, tree sap, bird droppings,
industrial pollution and similar deposits
can damage your vehicle’s finish if not
removed immediately.Even prompt washing with plain water
may not completely remove all these
deposits. A mild soap, safe for use on
painted surfaces, may be used.
After washing, rinse the vehicle thor-
oughly with lukewarm or cold water. Do
not allow soap to dry on the finish.
WARNING - Wet brakes
After washing the vehicle, test the
brakes while driving slowly to see if
they have been affected by water. If
braking performance is impaired,
dry the brakes by applying them
lightly while maintaining a slow for-
ward speed.
CAUTION
Do not use strong soap, chemical
detergents or hot water, and do not
wash the vehicle in direct sunlight
or when the body of the vehicle is
warm.
CAUTION
• Water washing in the engine com-
partment including high pressure
water washing may cause the fail-
ure of electrical circuits located in
the engine compartment.
• Never allow water or other liquids
to come in contact with electri-
cal/electronic components inside
the vehicle as this may damage
them.
OJB037800

Maintenance
42 7
Bright-metal maintenance
• To remove road tar and insects, use a
tar remover, not a scraper or other
sharp object.
• To protect the surfaces of bright-metal
parts from corrosion, apply a coating of
wax or chrome preservative and rub to
a high luster.
• During winter weather or in coastal
areas, cover the bright metal parts with
a heavier coating of wax or preserva-
tive. If necessary, coat the parts with
non-corrosive petroleum jelly or other
protective compound.
Underbody maintenance
Corrosive materials used for ice and
snow removal and dust control may col-
lect on the underbody. If these materials
are not removed, accelerated rusting can
occur on underbody parts such as the
fuel lines, frame, floor pan and exhaust
system, even though they have been
treated with rust protection.
Thoroughly flush the vehicle underbody
and wheel openings with lukewarm or
cold water once a month, after off-road
driving and at the end of each winter. Pay
special attention to these areas because
it is difficult to see all the mud and dirt. It
will do more harm than good to wet down
the road grime without removing it. The
lower edges of doors, rocker panels, and
frame members have drain holes that
should not be allowed to clog with dirt;
trapped water in these areas can cause
rusting.
Aluminum wheel maintenance
The aluminum wheels are coated with a
clear protective finish.
• Do not use any abrasive cleaner, pol-
ishing compound, solvent, or wire
brushes on aluminum wheels. They
may scratch or damage the finish.
• Use only a mild soap or neutral deter-
gent, and rinse thoroughly with water.
Also, be sure to clean the wheels after
driving on salted roads. This helps pre-
vent corrosion.
• Avoid washing the wheels with high-
speed car wash brushes.
• Do not use any acid detergent. It may
damage and corrode the aluminum
wheels coated with a clear protective
finish.
WARNING
After washing the vehicle, test the
brakes while driving slowly to see if
they have been affected by water. If
braking performance is impaired,
dry the brakes by applying them
lightly while maintaining a slow for-
ward speed.

Specifications
4 8
Capacities
*1Refer to the recommended SAE viscosity numbers on the page 7-38.
*2LSD : Limited Slip Differential
Lubricant Volume Classification
5.2l(5.49 US qt.)
Automatic transmission fluid 10 l(10.57 US qt.) APOLLOIL ATF RED-1K
4WD transfer case 1.42 l(1.50 US qt.) DEXRON III (fill for-life)
Power steering0.85~0.9l
PSF-III
(0.9~0.95 US qt.)
Front differential 1.3 l(1.37 US qt.) API SERVICE GL-5 (SAE 90)
Rear differentialAPI SERVICE GL-5 (SAE 90)
1.6l(1.69 US qt.)
API SERVICE GL-5 (SAE 85W-90, INFILREX33)
Coolant 9.0 l(9.4 US qt.)Ethylene glycol base for
aluminum radiator
Brake fluid 0.35 l(0.37 US qt.) FMVSS116 DOT-3 or DOT-4
Fuel 80 l(21 US gal) -
Engine oil with filter *1
Without LSD *2
With LSD *2
API Service SJ, SL or above,
ILSAC GF-3 or above

Index
2 9
Air bags - advanced supplemental restraint
system ········································································3-47
Air cleaner ····································································7-19
Antenna ·········································································3-98
Audio remote control···················································3-99
Audio system ······························································3-100
Auto fuel cutoff switch ················································3-74
Automatic climate control system ······························4-66
Automatic transmission ········································4-5,7-16
Battery···········································································7-22
Before driving·································································5-5
Brake fluid ····································································7-14
Brake system ································································4-20
Climate control air filter ·············································7-20
Cruise control system ··················································4-27
Defroster ·······································································4-57
Door locks ·······································································3-7Electrical circuit protection ··········································6-7
Electronic stability control ··········································4-30
Emergency starting························································6-4
Emission control system ················································5-3
Engine compartment ·············································2-3,7-10
Engine cooling system ·················································7-12
Engine oil ······································································7-11
Exterior care·································································7-39
Four wheel drive (4WD)··············································4-10
Fuel filler lid ·································································3-71
Fuel requirements ··························································5-2
Gauges ···········································································4-37
Hazard warning flasher ··············································4-58
Homelink® wireless control system ···························3-78
Hood ··············································································3-69
How to use this manual ·················································1-2
A
B
C
D
E
F
G
H